- 您現在的位置：買賣IC網 > PDF目錄371440 > 29LV160BE (Fujitsu Limited) 16M (2M X 8/1M X 16) BIT PDF資料下載
參數資料
| 型號： | 29LV160BE |
| 廠商： | Fujitsu Limited |
| 英文描述： | 16M (2M X 8/1M X 16) BIT |
| 中文描述： | 16米（2米x 8/1M × 16）位 |
| 文件頁數： | 15/59頁 |
| 文件大?。?/td> | 653K |
| 代理商： | 29LV160BE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁
MBM29LV160TE/BE
-70/90/12
15
Write
Device erasure and programming are accomplished via the command register. The contents of the register serve
as inputs to the internal state machine. The state machine outputs dictate the function of the device.
The command register itself does not occupy any addressable memory location. The register is a latch used to
store the commands, along with the address and data information needed to execute the command. The com-
mand register is written by bringing WE to V
IL
, while CE is at V
IL
and OE is at V
IH
. Addresses are latched on the
falling edge of WE or CE, whichever happens later; while data is latched on the rising edge of WE or CE,
whichever happens first. Standard microprocessor write timings are used.
Refer to AC Write Characteristics and the Erase/Programming Waveforms for specific timing parameters.
Sector Protection
The MBM29LV160TE/BE features hardware sector protection. This feature will disable both program and erase
operations in any number of sectors (0 through 34). The sector protection feature is enabled using programming
equipment at the user’s site. The device is shipped with all sectors unprotected.
To activate this mode, the programming equipment must force V
ID
on address pin A
9
and control pin OE, CE =
V
IL
, A
0
= A
6
= V
IL
, A
1
= V
IH
. The sector addresses pins (A
19
, A
18
, A
17
, A
16
, A
15
, A
14
, A
13
, and A
12
) should be set to
the sector to be protected. Tables 5 and 6 define the sector address for each of the thirty five (35) individual
sectors. Programming of the protection circuitry begins on the falling edge of the WE pulse and is terminated
with the rising edge of the same. Sector addresses must be held constant during the WE pulse. See Figures 17
and 24 for sector protection waveforms and algorithm.
To verify programming of the protection circuitry, the programming equipment must force V
ID
on address pin A
9
with CE and OE at V
IL
and WE at V
IH
. Scanning the sector addresses (A
19
, A
18
, A
17
, A
16
, A
15
, A
14
, A
13
, and A
12
)
while (A
6
, A
1
, A
0
) = (0, 1, 0) will produce a logical “1” at device output DQ
0
for a protected sector. Otherwise the
device will read 00H for an unprotected sector. In this mode, the lower order addresses, except for A
0
, A
1
, and
A
6
are DON’T CARES. Address locations with A
1
= V
IL
are reserved for Autoselect manufacturer and device
codes. A
-1
requires to V
IL
in byte mode.
It is also possible to determine if a sector is protected in the system by writing an Autoselect command. Performing
a read operation at the address location XX02H, where the higher order addresses pins (A
19
, A
18
, A
17
, A
16
, A
15
,
A
14
, A
13
, and A
12
) represents the sector address will produce a logical “1” at DQ
0
for a protected sector. See
Tables 4.1 and 4.2 for Autoselect codes.
Temporary Sector Unprotection
This feature allows temporary unprotection of previously protected sectors of the MBM29LV160TE/BE devices
in order to change data. The Sector Unprotection mode is activated by setting the RESET pin to high voltage
(V
ID
). During this mode, formerly protected sectors can be programmed or erased by selecting the sector ad-
dresses. Once the V
ID
is taken away from the RESET pin, all the previously protected sectors will be protected
again. (See Figures 18 and 25.)
相關PDF資料 |
PDF描述 |
|---|---|
| 29LV160B | 16M-BIT [2Mx8/1Mx16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY |
| 29LV160B | 16 Megabit (2 M x 8-Bit/1 M x 16-Bit) CMOS 3.0 Volt-only Boot Sector Flash Memory |
| 29LV160C-55R | 16M-BIT [2Mx8/1Mx16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY |
| 29LV160C-70 | 16M-BIT [2Mx8/1Mx16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY |
| 29LV160C-90 | 16M-BIT [2Mx8/1Mx16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 29LV160BT-90V | 制造商: 功能描述: 制造商:undefined 功能描述: |
| 29LV160C-55R | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:16M-BIT [2Mx8/1Mx16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY |
| 29LV160C-70 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:16M-BIT [2Mx8/1Mx16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY |
| 29LV160C-90 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:16M-BIT [2Mx8/1Mx16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY |
| 29LV160DB70EC | 制造商: 功能描述: 制造商:undefined 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。