- 您現在的位置：買賣IC網 > PDF目錄368705 > 12CE673 (Microchip Technology Inc.) HookUp/Lead Wire; Conductor Size AWG:18; No. Strands x Strand Size:65 x 36; Jacket Color:Black; Conductor Material:Copper; Jacket Material:Rubber; Leaded Process Compatible:Yes; Number of Conductors:1; Outer Diameter:0.144" RoHS Compliant: Yes PDF資料下載
參數資料
| 型號： | 12CE673 |
| 廠商： | Microchip Technology Inc. |
| 英文描述： | HookUp/Lead Wire; Conductor Size AWG:18; No. Strands x Strand Size:65 x 36; Jacket Color:Black; Conductor Material:Copper; Jacket Material:Rubber; Leaded Process Compatible:Yes; Number of Conductors:1; Outer Diameter:0.144" RoHS Compliant: Yes |
| 中文描述： | 8引腳，8位CMOS微控制器與A / D轉換器和EEPROM數據存儲器 |
| 文件頁數： | 48/116頁 |
| 文件大小： | 671K |
| 代理商： | 12CE673 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁當前第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁
PIC12CE67X
DS40181B-page 48
Preliminary
1998 Microchip Technology Inc.
9.2.5
INTERNAL 4 MHz RC OSCILLATOR
The internal RC oscillator provides a fixed 4 MHz (nom-
inal) system clock at V
DD
= 5V and 25
°
C, see "Electri-
cal Specifications" section for information on variation
over voltage and temperature.
In addition, a calibration instruction is programmed into
the last address of the program memory which contains
the calibration value for the internal RC oscillator. This
value is programmed as a
RETLW XX
instruction where
XX is the calibration value. In order to retrieve the cali-
bration value, issue a
CALL YY
instruction where YY is
the last location in program memory (03FFh for the
PIC12CE673, 07FFh for the PIC12CE674). Control will
be returned to the user’s program with the calibration
value loaded into the W register. The program should
then perform a MOVWF OSCCAL instruction to load
the value into the internal RC oscillator trim register.
OSCCAL, when written to with the calibration value, will
“trim” the internal oscillator to remove process variation
from the oscillator frequency. Only bits <7:2> of OSC-
CAL are implemented, and bits <1:0> should be written
as 0 for compatibility with future devices. The oscillator
calibration location is not code protected.
9.2.6
CLKOUT
The PIC12CE67X can be configured to provide a clock
out signal (CLKOUT) on pin 3 when the configuration
word address (2007h) is programmed with FOSC2,
FOSC1, FOSC0 equal to 101 for INTRC or 111 for
EXTRC. The oscillator frequency, divided by 4 can be
used for test purposes or to synchronize other logic.
Note:
Please note that erasing the device will
also erase the pre-programmed internal
calibration value for the internal oscillator.
The calibration value must be saved prior
to erasing the part.
9.3
The PIC12CE67X differentiates between various kinds
of reset:
Power-on Reset (POR)
MCLR reset during normal operation
MCLR reset during SLEEP
WDT Reset (normal operation)
Some registers are not affected in any reset condition;
their status is unknown on POR and unchanged in any
other reset. Most other registers are reset to a “reset
state” on Power-on Reset (POR), MCLR Reset, WDT
Reset, and MCLR Reset during SLEEP. They are not
affected by a WDT Wake-up, which is viewed as the
resumption of normal operation. The TO and PD bits
are set or cleared differently in different reset situations
as indicated in Table 9-4. These bits are used in
software to determine the nature of the reset. See
Table 9-5 for a full description of reset states of all
registers.
A simplified block diagram of the on-chip reset circuit is
shown in Figure 9-7.
The PIC12CE67X has a MCLR noise filter in the MCLR
reset path. The filter will detect and ignore small pulses.
It should be noted that a WDT Reset
does not drive
MCLR pin low.
Reset
相關PDF資料 |
PDF描述 |
|---|---|
| 12CGQ150 | SCHOTTKY RECTIFIER |
| 12CTQ030 | 12 AMP DUAL SCHOTTKY CENTER TAP RECTIFIERS |
| 12CTQ | SCHOTTKY RECTIFIER |
| 12CTQ035-1 | SCHOTTKY RECTIFIER |
| 12CTQ035S | SCHOTTKY RECTIFIER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 12CEX57E1A | 制造商:GE 功能描述:RELAY |
| 12CGQ150 | 制造商:International Rectifier 功能描述:Diode Schottky 150V 35A 3-Pin(3+Tab) TO-254AA 制造商:International Rectifier 功能描述:SCHOTTKY 150V 35A 3PIN TO-254AA - Bulk 制造商:International Rectifier 功能描述:SCHOTTKY RECTIFIER CMN CTHD 35A TO-254AA; Diode Type:Schottky; Diode Configuration:Dual Common Cathode; Repetitive Reverse Voltage Vrrm Max:150V; Forward Current If(AV):35A; Forward Voltage VF Max:1.6V; No. of Pins:3 ;RoHS Compliant: No |
| 12CGQ150SCS | 制造商:International Rectifier 功能描述:Diode Schottky 150V 35A 3-Pin(3+Tab) TO-254AA 制造商:International Rectifier 功能描述:SCHOTTKY 150V 35A 3PIN TO-254AA - Bulk |
| 12CGQ150SCV | 制造商:International Rectifier 功能描述:Diode Schottky 150V 35A 3-Pin(3+Tab) TO-254AA 制造商:Unity Microelectronics Inc 功能描述:SCHOTTKY DIODE, HI-REL, QIRL 制造商:International Rectifier 功能描述:SCHOTTKY 150V 35A 3PIN TO-254AA - Bulk |
| 12CGQ150SCX | 制造商:International Rectifier 功能描述:SCHOTTKY 150V 35A 3PIN TO-254AA - Bulk |
發布緊急采購，3分鐘左右您將得到回復。