- 您現在的位置：買賣IC網 > Datasheet目錄58 > XIB-E (Digi International/Maxstream)BOARD INTERFACE ETHERNET Datasheet資料下載
參數資料
| 型號： | XIB-E |
| 廠商： | Digi International/Maxstream |
| 文件頁數： | 53/64頁 |
| 文件大?。?/td> | 1858K |
| 描述： | BOARD INTERFACE ETHERNET |
| 標準包裝： | 1 |
| 附件類型： | 接口板 |
| 適用于相關產品： | XStream 和 Xcite 收音機 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁當前第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁
XStream"燨EM燫F燤odule?燩roduct燤anual爒5.x00燵2006.02.24]?/DIV>
MaxStream RS-232/485 Interface Board
B-01a. Power Switch
Figure燘01. Front燰iew?/DIV>
牋牘?006燤axStream,營nc.燙onfidential燼nd燩roprietary?/DIV>
53?/DIV>
B-01b. LEDs
The LED indicators visualize diagnostic status information. The
modules status is represented as follows:
erial Data Out (to host)
m) = Power/TX Indicator (Red light is on when
riefly during RF transmission)
Yellow (top LED) = S
Green (middle) = Serial Data In (from host)
Red (botto
powered, off b
B-01c. Serial Port
Standard female DB-9 (RS-232) DCE connector T
nnector
-422 connectio
his co
can be also used for RS-485 and RS
ns.
B-01d. Power Connector
7-18 VDC Power Connector (Center positive, 5.5/2.1mm) Power
B-9 Serial Port.
can also be supplied through Pin 9 of the D
B-02a. DIP Switch
Figure燘02. Back燰iew?/DIV>
ot b
ime
the module assembly is powered-on, the processor must be
disabled by populating J7 on the interface board.
B-02b. Config (Configuration) Switch
NOTE: In cases where AT Commands should n
e sent each t
The Configuration Switch provides an alternate way to enter AT
Command Mode . To enter AT Command Mode at the modules
default baud rate, hold the Configuration Switch down while
powering on the module using the Power Switch [B-01a].
Figure燘03. MaxStream燲IB
Move the Power Switch to the on (up) position to power the
Interface Board. DIP Switch [B.2a] settings are only read
during a power-up sequence.
R?RS232/485)營nterface燘oard燚IP燬witch燬ettings?/DIV>
The DIP Switch automatically configures the XStrea
e the module
ow
ms the module
e
m OEM RF
Module to operate in different modes. Each tim
assembly (interface board + the RF Module) is p ered-on,
intelligence on the XIB-R interface board progra
according to the positions of the DIP Switch. [Se figure below
for DIP Switch settings]
Refer爐o爐able爄n爐he?/DIV>
Automatic燚IP燬witch?/DIV>
Configurations爏ection燵next?/DIV>
page]爁or爉ore爄nformation?/DIV>
regarding燾onfigurations?/DIV>
triggered燽y爐he燚IP燬witch.
DIP燬witch?/DIV>
Config
B01a.?/SPAN>
Power?/DIV>
Switch?/DIV>
B01b.?/SPAN>
LEDs?/DIV>
Serial燩ort?/DIV>
wer
B01c.?/SPAN>
B0d.?/SPAN>
B02a.牋
B02b.?/DIV>
燬witch?/DIV>
Po
?/DIV>
Connector?/DIV>
相關PDF資料 |
PDF描述 |
|---|---|
| XIB-R | BOARD INTERFACE RS232/485 |
| ZMN2400HPDB | BOARD ROUTER DEV ZIGBEE 100MW |
| ZMN24HPDK-B | KIT DEV W/ZIGBEE ZMN2400HP |
| ZNI1000TC | IC TEMP SENSOR NI1000 SOT23-3 |
| 02110102-000 | SNSR TILT RATIO 60DEG 500MA FLNG |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XIB-R | 功能描述:界面模塊 RS-232/485 interface 24XStream 9XCite RoHS:否 制造商:4D Systems 產品:Serial Converters 通道/端口數量: 數據速率: 接口類型:USB, UART 工作電源電壓:3.3 V, 5 V 最大工作溫度: |
| XIB-U | 功能描述:界面模塊 USB interface board 24XStream 9XCite RoHS:否 制造商:4D Systems 產品:Serial Converters 通道/端口數量: 數據速率: 接口類型:USB, UART 工作電源電壓:3.3 V, 5 V 最大工作溫度: |
| XIC25040 | 制造商:XIC 功能描述:25040 24HR '6 |
| XILINXPWR-079 | 功能描述:電源管理IC開發工具 Pow Mgt Eval Mod for Xilinx FPGAs RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| XILINXPWR-080 | 功能描述:電源管理IC開發工具 Pow Mgt Eval Mod for Xilinx FPGAs RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
發布緊急采購，3分鐘左右您將得到回復。