參數資料
型號： XIB-E
廠商： Digi International/Maxstream
文件頁數： 11/64頁
文件大?。?/td> 1858K
描述： BOARD INTERFACE ETHERNET
標準包裝： 1
附件類型： 接口板
適用于相關產品： XStream 和 Xcite 收音機
XStream"燨EM燫F燤odule?燩roduct燤anual爒5.x00燵2006.02.24]?/DIV>
2.2. Modes of Operation
XStream OEM RF Modules operate in five modes.
Figure?04. XStream燤odes爋f燨peration?/DIV>
The爉odule燾an爋nly燽e爄n爋ne爉ode燼t燼爐ime.?/DIV>
 
 
 
 
 
 
2.2.1. Idle Mode
When not receiving or transmitting data, the module is in Idle Mode. The module uses the same
amount of power in Idle Mode as it does in Receive Mode.
The module shifts into the other modes of operation under the following conditions:
"   Serial data is received in the DI Buffer (Transmit Mode)
"   Valid RF data is received through the antenna (Receive Mode)
"   Command Mode Sequence is issued (Command Mode)
"   Sleep Mode condition is met (Sleep Mode)
After responding to any of the preceding conditions, the module automatically transitions back
into Idle Mode.
2.2.2. Transmit Mode
After the first byte of serial data is received in the DI buffer (from the UART), the module
attempts to shift to Transmit Mode and initiate RF connections with other modules. After
transmission is complete, the module returns to Idle Mode.
RF transmission begins after either of the following criteria is met:
1.   RB bytes have been received in the DI buffer and are pending for RF transmission [refer to
RB (Packetization Threshold) Command, p29].
 
The RB parameter may be set to any value between 1 and the RF packet size (PK), inclusive.
When RB = 0, the packetization threshold is ignored.
2.   At least one character has been received in the DI buffer (pending for RF transmission) and
RO time has been observed on the UART [refer to RO (Packetization Timeout) Command].
 
The timeout can be disabled by setting RO to zero. In this case, transmission will begin after
RB bytes have been received in the DI buffer.
After either RB or RO conditions are met, the module then initializes a communications channel.
[Channel Initialization is the process of sending an RF initializer that synchronizes receiving
modules with the transmitting module. During channel initialization, incoming serial data
accumulates in the DI buffer.]
Serial data in the DI buffer is grouped into RF packets [refer to PK (RF Packet Size)]; converted
to RF data; then transmitted over-the-air until the DI buffer is empty.
RF data, which includes the payload data, follows the RF initializer. The payload includes up to
the maximum packet size (PK Command) bytes. As the transmitting module nears the end of the
transmission, it inspects the DI buffer to see if more data exists to be transmitted. This could be
the case if more than PK bytes were originally pending in the DI buffer or if more bytes arrived
from the UART after the transmission began. If more data is pending, the transmitting module
assembles a subsequent packet for transmission.
Note: RF reception must
complete before the
module is able to enter
into Transmit Mode.
牋牘?006燤axStream,營nc.燙onfidential燼nd燩roprietary?/DIV>
11?/DIV>
相關PDF資料
PDF描述
XIB-R BOARD INTERFACE RS232/485
ZMN2400HPDB BOARD ROUTER DEV ZIGBEE 100MW
ZMN24HPDK-B KIT DEV W/ZIGBEE ZMN2400HP
ZNI1000TC IC TEMP SENSOR NI1000 SOT23-3
02110102-000 SNSR TILT RATIO 60DEG 500MA FLNG
相關代理商/技術參數
參數描述
XIB-R 功能描述:界面模塊 RS-232/485 interface 24XStream 9XCite RoHS:否 制造商:4D Systems 產品:Serial Converters 通道/端口數量: 數據速率: 接口類型:USB, UART 工作電源電壓:3.3 V, 5 V 最大工作溫度:
XIB-U 功能描述:界面模塊 USB interface board 24XStream 9XCite RoHS:否 制造商:4D Systems 產品:Serial Converters 通道/端口數量: 數據速率: 接口類型:USB, UART 工作電源電壓:3.3 V, 5 V 最大工作溫度:
XIC25040 制造商:XIC 功能描述:25040 24HR '6
XILINXPWR-079 功能描述:電源管理IC開發工具 Pow Mgt Eval Mod for Xilinx FPGAs RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
XILINXPWR-080 功能描述:電源管理IC開發工具 Pow Mgt Eval Mod for Xilinx FPGAs RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*