- 您現在的位置：買賣IC網 > PDF目錄15834 > SI3225PPT0-EVB (Silicon Laboratories Inc)BOARD EVAL W/SI3200 INTERFACE PDF資料下載
參數資料
| 型號： | SI3225PPT0-EVB |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 43/112頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVAL W/SI3200 INTERFACE |
| 標準包裝： | 1 |
| 系列： | ProSLIC® |
| 類型： | ADC + DAC，編碼解碼器，前端 |
| 適用于相關產品： | Si3225 |
| 所含物品： | 評估板和光盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁當前第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁
Si3220/25 Si3200/02
36
Rev. 1.3
Not
Recommended
fo
r N
ew
D
esi
gn
s
transition point. In the case of the discrete bipolar
linefeed, since the source impedance is 320
both
before and after the adaptive linefeed transition, the V/I
curve exhibits no discontinuity at the transition points
when VOCDELTA = 0.
3.4.3. Off-Hook to On-Hook Transition
Load lines of 10 k
, 1930 and 1800 are shown in
Figure 16. These load lines intercept the linefeed V/I
curve at the V/I point that would result if a load of that
resistance value were connected across TIP and RING.
As the dc loop is opened, the dc feed will exit the
constant current region (point 4) and enter the 320
source impedance region. As the current in the loop
collapses, the VTIP/RING voltage will linearly increase
until VOCHTH (point 5) is reached. At this point,
adaptive linefeed will transition to a source impedance
of 640
(320 for discrete bipolar transistor linefeed)
and decrease the VOC voltage by VOCDELTA (point 6).
3.4.4. VOCTRACK and Adaptive Linefeed
Hysteresis
The two thresholds, VOCLTH and VOCHTH, control
adaptive linefeed hysteresis as shown in Figure 16.
VOCTRACK is a RAM location and is the actual open-
circuit voltage that is being fed to the line. VOCTRACK
is dependent on the measured VBAT voltage. The
behavior of VOCTRACK is as shown in the equation
below. As long as VBAT is sufficient to supply VOC +
VOV + VCM, VOCTRACK is equal to the programmed
VOC. However, if VBAT becomes too small to support
VOC + VOV + VCM, then VOCTRACK will track the
battery voltage so that the programmed VOV and VCM
are satisfied at the expense of a reduced VOC voltage.
In
the
example
of
therefore,
VOCTRACK = VOC = 48 V.
The following equation describes VOCTRACK behavior:
The values of VOCLTH and VOCHTH are set relative to
VOCTRACK. In the example shown in Figure 16,
VOCLTH is given as –7 V and VOCHTH as +2 V. This
implies that the VOCLTH threshold is located 7 V below
the prevailing value of VOCTRACK, while the VOCHTH
threshold is located 2 V above the prevailing value of
VOCTRACK.
Therefore, the VOCLTH and VOCHTH thresholds will
automatically track the battery voltage along with
VOCTRACK.
In order to provide an adequate level of adaptive
linefeed hysteresis between the on-hook to off-transition
and the off-hook to on-hook transition, VOCLTH is
programmed below VOCTRACK (e.g., –7 V relative to
VOCTRACK), and VOCHTH is programmed above
VOCTRACK (e.g., +2 V above VOCTRACK). Also,
VOCHTH must be less than VOV – 1 V to ensure that a
proper adaptive linefeed transition will occur in a
reduced battery scenario.
3.5. Ground Start Operation
To configure the dc feed for ground start operation, it is
necessary to write the LINEFEED register with the
value corresponding to either TIP-OPEN (LF[2:0] = 011)
or RING-OPEN (LF[2:0] = 111). The TIP-OPEN and
RING-OPEN linefeed modes place the indicated lead in
the OPEN state (>150 k
) while the other lead remains
active.
In ground start operation, an off-hook condition is
signaled by the CPE (Customer Premise Equipment) by
connecting the active lead to earth ground.
The active lead presents a 640
source impedance
before the adaptive linefeed transition (320
for a
discrete
bipolar
linefeed),
and
a
320
source
impedance after the adaptive linefeed transition, as
shown in Figure 17. As for loop start operation, the
adaptive linefeed transitions are governed by the
contents
of
the
VOCLTH
and
VOCHTH
RAM
addresses.
The OPEN lead presents a high-impedance (>150 k
).
Figure 17 illustrates the ground-start VRING/IRING
behavior using VOC = 48 V and ILIM =24mA in the
TIP-OPEN linefeed state. The ground key current
thresholds are programmable via the LONGLOTH and
LONGHITH RAM addresses. The LONGLPF RAM
address provides filtering of the measured longitudinal
currents, and the LONGDBI RAM address provides de-
bouncing. The LONGHI status bit in register LCRRTP
indicates when a ground key event has been detected.
Upon detecting a ground key event, the linefeed
automatically transitions to the FORWARD ACTIVE (if
initially in TIP-OPEN) or REVERSE ACTIVE (if initially
in RING-OPEN). See “3.11. Ground Key Detection” on
page 46 for additional details.
)
V
(
|
V
|
VOCTRACK
V
|
V
|
VOC
VOCTRACK
V
|
V
|
CM
OV
BAT
CM
OV
OC
BAT
CM
OV
OC
BAT
相關PDF資料 |
PDF描述 |
|---|---|
| MCP120-315GI/TO | IC SUPERVISOR ACTIVE LOW TO-92 |
| MAX6439UTFJYD3+T | IC BATTERY MON SNGL SOT23-6 |
| LHL13TB221K | INDUCTOR 220UH 1.3A RADIAL |
| 1838240-1 | CONN MALE M12 3POS STR 2M CABLE |
| MCP120-300HI/TO | IC SUPERVISOR ACTIVE LOW TO-92 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SI3225PPT-EVB | 制造商:SILABS 制造商全稱:SILABS 功能描述:EVALUATION BOARD FOR THE Si3225 DUAL PROSLIC |
| SI3225PPTX-EVB | 功能描述:音頻 IC 開發工具 Si3225 Eval Board RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| SI3225-X-FQ | 制造商:SILABS 制造商全稱:SILABS 功能描述:DUAL PROSLIC㈢ PROGRAMMABLE CMOS SLIC/CODEC |
| SI3225-X-GQ | 制造商:SILABS 制造商全稱:SILABS 功能描述:DUAL PROSLIC㈢ PROGRAMMABLE CMOS SLIC/CODEC |
| SI3226 | 制造商:SILABS 制造商全稱:SILABS 功能描述:Dual ProSLIC㈢ with DC-DC Controller |
發布緊急采購，3分鐘左右您將得到回復。