- 您現在的位置：買賣IC網 > PDF目錄11733 > ORT82G5-2FN680I (Lattice Semiconductor Corporation)IC TRANCEIVERS FPSC 680FPBGA PDF資料下載
參數資料
| 型號： | ORT82G5-2FN680I |
| 廠商： | Lattice Semiconductor Corporation |
| 文件頁數： | 29/119頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TRANCEIVERS FPSC 680FPBGA |
| 產品變化通告： | Product Discontinuation 01/Aug/2011 |
| 標準包裝： | 24 |
| 系列： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁
Lattice Semiconductor
ORCA ORT42G5 and ORT82G5 Data Sheet
17
Embedded Core/FPGA Logic Interface and 4:1 Multiplexer
These blocks provide the data formatting and transmit data and clock signal transfers between the Embedded Core
and the FPGA Logic. Control and status registers in the FPGA portion of the chip contain to control the transmit
logic and record status. These bits are passed to the core using the FPGA System Bus and are described in later
sections of this data sheet.
The low-speed transmit interface consists of a clock and 4 data bytes, each with an accompanying control bit. The
data bytes are conveyed to the MUX via the TWDxx[31:0] ports (where xx represents the channel label [AA,...,BD]
or [AC, AD, BC, BD]). The control bits are TCOMMAx[3:0] which dene whether the input byte is to be interpreted
as data or as a special character and TBIT9xx[3:0] which are used to force a negative disparity present state. The
data and control signals are synchronized to the transmit clock, TSYS_CLK_xx. Both the data and control are
strobed into the core on the rising edge of TSYS_CLK_xx. Note that each TBIT9xx[3:0] controls the disparity of the
encoded version of its corresponding data byte. Setting bit TBIT9AC[3] to 1, for instance, will force the 8b/10b
encoder to assess a current negative running disparity state. This will cause it to encode TWDAC[31:24] positively
(more 1’s than 0’s). Setting TBIT9xx to 0 will leave the encoder free to alternate between positive and negative
encoding to maintain a zero running disparity.
The MUX is responsible for taking 40 bits of data/control at the low-speed transmit interface and up-converting it to
10 bits of data/control at the SERDES transmit interface. The MUX has 2 clock domains - one based on the clock
received from the SERDES block and a second that comes from the FPGA at 1/4 the frequency of the SERDES
clock. The time sequence of interleaving data/control values is shown in Figure 4.
Figure 4. Transmit MUX Block Timing - Single Channel
SERDES Block
The SERDES block accepts either 8-bit data to be encoded or 10-bit unencoded data at the parallel input port from
the MUX/DEMUX block. It also accepts the reference clock at the REFCLK_[A:B] input and uses this clock to syn-
thesize the internal high-speed serial bit clock.
The internal STBC311xx clock is derived from the reference clock. The frequency of this clock depends on the set-
ting of the half-rate/full-rate control bit setting the mode of the SERDES and the frequency of the REFCLK_[A:B]
and/or that of the high-speed serial data. A falling edge on the STBC311xx clock port will cause a new data charac-
ter to be transferred into the SERDES block. The latency from the SERDES block input to the high-speed serial
output is 5 STBC311xx clock cycles, as shown in Figure 5.
p
q
r
s
t
xyz
STBDxx[9:0]
LATENCY = 4 TSYS_CLK_xx CLOCKS
TWDxx[31:24],
TSYS_CLK_xx
s
8
r
8
z
8
y
8
10-bit wide data
TWDxx[23:16],
TWDxx[15:8],
r
7-0,
y
7-0,
TCOMMAxx[3]
TCOMMAxx[2]
TCOMMAxx[1]
TCOMMAxx[0]
TWDxx[7:0],
s
7-0,
z
7-0,
TBIT9xx[0]
TBIT9xx[1]
TBIT9xx[2]
TBIT9xx[3]
q
9
r
9
s
9
z
9
y
9
x
9
p
7-0,
p
8
t
7-0,
q
8
t
8
x
8
q
7-0,
x
7-0,
p
9
t
9
相關PDF資料 |
PDF描述 |
|---|---|
| VI-J4H-IW-F4 | CONVERTER MOD DC/DC 52V 100W |
| VI-J4H-IW-F3 | CONVERTER MOD DC/DC 52V 100W |
| ORT82G5-1FN680C | IC TRANCEIVERS FPSC 680FPBGA |
| ORT82G5-2FN680C | IC TRANCEIVERS FPSC 680FPBGA |
| MSP430F4793IPZ | IC MCU 16BIT 60KB FLASH 100LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ORT82G5-2FN680I1 | 功能描述:FPGA - 現場可編程門陣列 10368 LUT 372 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256 |
| ORT82G5-3BM680C | 功能描述:FPGA - 現場可編程門陣列 10368 LUT 372 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256 |
| ORT82G5-3BM680C2 | 制造商:LATTICE 制造商全稱:Lattice Semiconductor 功能描述:0.6 to 3.7 Gbps XAUI and FC FPSCs |
| ORT82G5-3F680C | 功能描述:FPGA - 現場可編程門陣列 ORCA FPSC 2.7GBITS/s BP XCVR 643K RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256 |
| ORT82G5-3FN680C | 功能描述:FPGA - 現場可編程門陣列 ORCA FPSC 1.5V 3.7 G b Bpln Xcvr 643K Gt RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256 |
發布緊急采購，3分鐘左右您將得到回復。