參數資料
型號： ORT82G5-2FN680I
廠商： Lattice Semiconductor Corporation
文件頁數： 2/119頁
文件大?。?/td> 0K
描述： IC TRANCEIVERS FPSC 680FPBGA
產品變化通告： Product Discontinuation 01/Aug/2011
標準包裝： 24
系列： *
Lattice Semiconductor
ORCA ORT42G5 and ORT82G5 Data Sheet
10
System Bus
An on-chip, multimaster, 8-bit system bus with 1-bit parity facilitates communication among the MPI, conguration
logic, FPGA control, status registers, Embedded Block RAMs, as well as user logic. Utilizing the AMBA specica-
tion Rev 2.0 AHB protocol, the Embedded System Bus offers arbiter, decoder, master, and slave elements. Master
and slave elements are also available for the user-logic and a slave interface is used for control and status of the
embedded backplane transceiver portion of the device.
The system bus control registers can provide control to the FPGA such as signaling for reprogramming, reset func-
tions, and PLL programming. Status registers monitor INIT, DONE, and system bus errors. An interrupt controller is
integrated to provide up to eight possible interrupt resources. Bus clock generation can be sourced from the micro-
processor interface clock, conguration clock (for slave conguration modes), internal oscillator, user clock from
routing, or from the port clock (for JTAG conguration modes).
Phase-Locked Loops
Up to eight PLLs are provided on each Series 4 device, with four user PLLs generally provided for FPSCs. Pro-
grammable PLLs can be used to manipulate the frequency, phase, and duty cycle of a clock signal. Each PPLL is
capable of manipulating and conditioning clocks from 20 MHz to 200 MHz. Frequencies can be adjusted from 1/8x
to 8x, the input clock frequency. Each programmable PLL provides two outputs that have different multiplication fac-
tors but can have the same phase relationships. Duty cycles and phase delays can be adjusted in 12.5% of the
clock period increments. An automatic input buffer delay compensation mode is available for phase delay. Each
PPLL provides two outputs that can have programmable (12.5% steps) phase differences.
Embedded Block RAM
New 512 x 18 block-port RAM blocks are embedded in the FPGA core to signicantly increase the amount of mem-
ory and complement the distributed PFU memories. The EBRs include two write ports, two read ports, and two
byte lane enables which provide four-port operation. Optional arbitration between the two write ports is available,
as well as direct connection to the high-speed system bus.
Additional logic has been incorporated to allow signicant exibility for FIFO, constant multiply, and two-variable
multiply functions. The user can congure FIFO blocks with exible depths of 512K, 256K, and 1K including asyn-
chronous and synchronous modes and programmable status and error ags. Multiplier capabilities allow a multiple
of an 8-bit number with a 16-bit xed coefcient or vice versa (24-bit output), or a multiple of two 8-bit numbers (16-
bit output). On-the-y coefcient modications are available through the second read/write port.
Two 16 x 8-bit CAMs per embedded block can be implemented in single match, multiple match, and clear modes.
The EBRs can also be preloaded at device conguration time.
Conguration
The FPGAs functionality is determined by internal conguration RAM. The FPGAs internal initialization/congura-
tion circuitry loads the conguration data at power up or under system control. The conguration data can reside
externally in an EEPROM or any other storage media. Serial EEPROMs provide a simple, low pin-count method for
conguring FPGAs.
The RAM is loaded by using one of several conguration modes. Supporting the traditional master/slave serial,
master/slave parallel, and asynchronous peripheral modes, the Series 4 also utilizes its microprocessor interface
and Embedded System Bus to perform both programming and readback. Daisy chaining of multiple devices and
partial reconguration are also permitted.
Other conguration options include the initialization of the embedded-block RAM memories and FPSC memory as
well as system bus options and bit stream error checking. Programming and readback through the JTAG (IEEE
1149.2) port is also available meeting In-System Programming (ISP) standards (IEEE 1532 Draft).
相關PDF資料
PDF描述
VI-J4H-IW-F4 CONVERTER MOD DC/DC 52V 100W
VI-J4H-IW-F3 CONVERTER MOD DC/DC 52V 100W
ORT82G5-1FN680C IC TRANCEIVERS FPSC 680FPBGA
ORT82G5-2FN680C IC TRANCEIVERS FPSC 680FPBGA
MSP430F4793IPZ IC MCU 16BIT 60KB FLASH 100LQFP
相關代理商/技術參數
參數描述
ORT82G5-2FN680I1 功能描述:FPGA - 現場可編程門陣列 10368 LUT 372 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
ORT82G5-3BM680C 功能描述:FPGA - 現場可編程門陣列 10368 LUT 372 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
ORT82G5-3BM680C2 制造商:LATTICE 制造商全稱:Lattice Semiconductor 功能描述:0.6 to 3.7 Gbps XAUI and FC FPSCs
ORT82G5-3F680C 功能描述:FPGA - 現場可編程門陣列 ORCA FPSC 2.7GBITS/s BP XCVR 643K RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
ORT82G5-3FN680C 功能描述:FPGA - 現場可編程門陣列 ORCA FPSC 1.5V 3.7 G b Bpln Xcvr 643K Gt RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*