- 您現在的位置：買賣IC網 > PDF目錄25635 > MD80C52EXXX-16SBD (ATMEL CORP) 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CDIP40 PDF資料下載
參數資料
| 型號： | MD80C52EXXX-16SBD |
| 廠商： | ATMEL CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CDIP40 |
| 封裝： | 0.600 INCH, CERAMIC, DIP-40 |
| 文件頁數： | 161/198頁 |
| 文件大?。?/td> | 4822K |
| 代理商： | MD80C52EXXX-16SBD |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁當前第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁
65
8111C–MCU Wireless–09/09
AT86RF231
Overview
The implemented TX_ARET algorithm is shown in Figure 7-12 on page 64.
In TX_ARET mode, the AT86RF231 first executes the CSMA-CA algorithm, as defined by
IEEE 802.15.4-2006, section 7.5.1.4, initiated by a transmit start event. If the channel is IDLE a
frame is transmitted from the Frame Buffer. If the acknowledgement frame is requested the radio
transceiver additionally checks for an ACK reply.
The completion of the TX_ARET transmit transaction is indicated by an IRQ_3 (TRX_END)
interrupt.
Description
Configuration and address bits are to be set in TRX_OFF or PLL_ON state prior to switching to
TX_ARET mode. It is further recommended to transfer the PSDU data to the Frame Buffer in
advance. The transaction is started by either using pin 11 (SLP_TR), refer to Section 6.5
“Sleep/Wake-up and Transmit Signal (SLP_TR)” on page 27, or writing a TX_START command
to register 0x02 (TRX_STATE).
If the CSMA-CA detects a busy channel, it is retried as specified by the register bits
MAX_CSMA_RETRIES (register 0x2C, XAH_CTRL_0). In case that CSMA-CA does not detect
a clear channel after MAX_CSMA_RETRIES, it aborts the TX_ARET transaction, issues inter-
rupt IRQ_3 (TRX_END), and set the value of the TRAC_STATUS reg ister bits to
CHANNEL_ACCESS_FAILURE.
During transmission of a frame the radio transceiver parses bit 5 (ACK Request) of the MAC
header (MHR) frame control field of the PSDU data (PSDU octet #1) to be transmitted to check if
an ACK reply is expected.
If an ACK is expected, the radio transceiver automatically switches into receive mode to wait for
a valid ACK reply. After receiving an ACK frame the Frame Pending subfield of that frame is
parsed and the status register bits TRAC_STATUS are updated accordingly, refer to Table 7-12
on page 66. This receive procedure does not overwrite the Frame Buffer content. Transmit data
in the Frame Buffer is not changed during the entire TX_ARET transaction. Received frames
other than the expected ACK frame are discarded.
If no valid ACK is received or after timeout of 54 symbol periods (864 s), the radio transceiver
retries the entire transaction, (including CSMA-CA) until the maximum number of retransmis-
sions (as set by the register bits MAX_FRAME_RETRIES in register 0x2C (XAH_CTRL_0) is
exceeded.
After that, the microcontroller may read the value of the register bits TRAC_STATUS (register
0x02, TRX_STATE) to verify whether the transaction was successful or not. The register bits are
set according to the following cases, additional exit codes are described in Section 7.2.6 “Regis-
相關PDF資料 |
PDF描述 |
|---|---|
| MD80C52EXXX-20SB | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CDIP40 |
| MQ80C32E-36SC | 8-BIT, 36 MHz, MICROCONTROLLER, CQFP44 |
| MR80C52XXX-20:R | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CQCC44 |
| MQ80C32E-30/883 | 8-BIT, 30 MHz, MICROCONTROLLER, CQFP44 |
| MR80C52CXXX-16/883R | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CQCC44 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MD80C86 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS 16-Bit Microprocessor |
| MD80C862 | 制造商:Intel 功能描述:PROCESSOR:MICRO-PROCESSOR |
| MD80C86-2 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS 16-Bit Microprocessor |
| MD80C86-2/883 | 制造商:Intersil Corporation 功能描述:MPU 16BIT CMOS 8MHZ 40CDIP - Rail/Tube 制造商:Rochester Electronics LLC 功能描述:CPU 16BILT 5V CMOS 8MHZ 40CDIP - Bulk |
| MD80C86-2/B | 制造商:Intersil Corporation 功能描述:MPU 16BIT CMOS 8MHZ 40CDIP - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。