參數資料
型號: MD80C52EXXX-16SBD
廠商: ATMEL CORP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CDIP40
封裝: 0.600 INCH, CERAMIC, DIP-40
文件頁數: 131/198頁
文件大小: 4822K
代理商: MD80C52EXXX-16SBD
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁當前第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁
38
8111C–MCU Wireless–09/09
AT86RF231
A reset forces the radio transceiver into TRX_OFF state. If the device is still in the P_ON state it
remains in the P_ON state though.
A reset is initiated with pin /RST = L and the state is left after setting /RST = H. The reset pulse
should have a minimum length as specified in Section 12.4 “Digital Interface Timing Characteris-
tics” on page 157 see parameter 12.4.13.
During reset the microcontroller has to set the radio transceiver control pins SLP_TR and /SEL
to their default values.
An overview about the register reset values is provided in Table 14-1 on page 170.
7.1.3
Interrupt Handling
All interrupts provided by the AT86RF231 (see Table 6-9 on page 29) are supported in Basic
Operating Mode.
For example, interrupts are provided to observe the status of radio transceiver RX and
TX operations.
On receive IRQ_2 (RX_START) indicates the detection of a valid PHR first, IRQ_5 (AMI) an
address match and IRQ_3 (TRX_END) the completion of the frame reception.
On transmit IRQ_3 (TRX_END) indicates the completion of the frame transmission.
Figure 7-2 on page 39 shows an example for a transmit/receive transaction between two
devices and the related interrupt events in Basic Operating Mode. Device 1 transmits a frame
containing a MAC header (in this example of length 7), payload and valid FCS. The frame is
received by Device 2 which generates the interrupts during the processing of the incoming
frame. The received frame is stored in the Frame Buffer.
The first interrupt IRQ_2 (RX_START) signals the reception of a valid PHR.
If the received frame passes the address filter, refer to Section 7.2.3.5 “Frame Filtering” on page
61, an address match interrupt IRQ_5 (AMI) is issued after the reception of the MAC
header (MHR).
In Basic Operating Mode the third interrupt IRQ_3 (TRX_END) is issued at the end of the
received frame. In Extended Operating Mode, refer to Section 7.2 “Extended Operating Mode”
on page 47; the interrupt is only issued if the received frame passes the address filter and the
FCS is valid. Further exceptions are explained in Section 7.2 “Extended Operating Mode” on
Processing delay t
相關PDF資料
PDF描述
MD80C52EXXX-20SB 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CDIP40
MQ80C32E-36SC 8-BIT, 36 MHz, MICROCONTROLLER, CQFP44
MR80C52XXX-20:R 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CQCC44
MQ80C32E-30/883 8-BIT, 30 MHz, MICROCONTROLLER, CQFP44
MR80C52CXXX-16/883R 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CQCC44
相關代理商/技術參數
參數描述
MD80C86 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS 16-Bit Microprocessor
MD80C862 制造商:Intel 功能描述:PROCESSOR:MICRO-PROCESSOR
MD80C86-2 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS 16-Bit Microprocessor
MD80C86-2/883 制造商:Intersil Corporation 功能描述:MPU 16BIT CMOS 8MHZ 40CDIP - Rail/Tube 制造商:Rochester Electronics LLC 功能描述:CPU 16BILT 5V CMOS 8MHZ 40CDIP - Bulk
MD80C86-2/B 制造商:Intersil Corporation 功能描述:MPU 16BIT CMOS 8MHZ 40CDIP - Rail/Tube