- 您現在的位置：買賣IC網 > PDF目錄377895 > MB86967PFV (FUJITSU LTD) LAN Controller with PC Card, ISA Bus, and General-purpose Bus Interfaces PDF資料下載
參數資料
| 型號： | MB86967PFV |
| 廠商： | FUJITSU LTD |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | LAN Controller with PC Card, ISA Bus, and General-purpose Bus Interfaces |
| 中文描述： | 1 CHANNEL(S), 10M bps, LOCAL AREA NETWORK CONTROLLER, PQFP80 |
| 封裝： | PLASTIC, LQFP-80 |
| 文件頁數： | 29/129頁 |
| 文件大?。?/td> | 1499K |
| 代理商： | MB86967PFV |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁
29
MB86967
packets are loaded into the transmit buffer, the system turns the transmitter on to initiate transmission. Observing
the media access protocol, the MB86967 defers transmitting to carrier from other nodes, minimum interpacket
gap intervals and backoff intervals, if any, and then begins to serialize the data. It generates the Preamble field
at the beginning, and calculates and appends the CRC field at the end. Figure 7 illustrates the standard packet
format. The serialized signal is routed to the transceiver section which encodes the data into the required
Manchester code, appends an end-of-packet delimiter.
The transmitter transmits the packets in the transmit buffer in the order in which they were loaded. If a collision
is detected by the transceiver, the transmitter automatically retransmits the packet until successful or until 16
consecutive attempts have ended in collision. In the latter case, depending on the mode selection made at
initialization time, the transmitter continues to try to transmit the same packet starting again with a collision count
of zero, skips the current packet and tries to transmit the next packet starting with a collision count of zero, or
halts and waits for instruction from the host. In the last case, the host can elect to terminate transmission attempts
by setting ENADLC, DLCR6<7> to one, continue to attempt to transmit the same packet (collision counter reset),
or skip the current packet and try to transmit the next packet(collision count is zero).
8.3 Backoff Generator
A 17-bit pseudo-random number generator clocked at the 10 MHz bit rate provides the collision backoff function.
Distances between stations become part of the randomizing function. The number generator is sampled at the
time of collision, masking all but the appropriate number of bits specified by the 8802-3 backoff algorithm. This
value is then counted down at the slot-time rate (512 bit times) to generate the backoff interval. For a first collision,
only one bit is used, giving a backoff of either 51.2 microseconds or 0. For a second consecutive collision, two
bits are used, and so forth, up to ten bits. From the tenth to the 16th collisions, 10 bits are used. This generates
a pseudo-random backoff interval of from 0 to 52.38 ms, the so-called ‘binary exponential backoff’ for collisions
per the 8802-3 standard.
8.4 Transmit Error Processing
The MB86967 provides four transmit error status bits in its Transmit Status Register (DLCR0) for reporting the
four possible transmit errors. The errors are: 1) loss of carrier during transmission, which usually indicates a
medium fault or a collision, 2) collision, 3) 16 consecutive collisions and 4) jabber error, which occurs if the length
of a single transmission substantially exceeds the time required to transmit a maximum length packet conforming
to the standard. The latter three can be enabled separately to generate interrupts.
A status bit in the Transmit Status Register is set in case a collision terminates transmission. Collision counter
DLCR4<7:4>, automatically increments after each collision up to the sixteenth collision, at which time it rolls
over to zero. Another status bit indicates that sixteen consecutive attempts to transmit a packet have been made
and all have been terminated by collision. The occurrence of 16 collisions may indicate a network problem, such
as a disconnected cable or terminator, that produces false collisions. While rare, 16 collisions may normally occur.
Figure 7 Packet Format
PREAMBLE
DESTINATION
ADDRESSSOURCE
ADDRESS
LENGTH
DATA
46-1500
CRC
8
6
6
2
4
LENGTHS SHOWN IN BYTES
相關PDF資料 |
PDF描述 |
|---|---|
| MB86977 | IP PACKET FORWARDING ENGINE |
| MB86977PFV-G-BND | IP PACKET FORWARDING ENGINE |
| MB86H20 | SmartMPEG |
| MB86H21 | MPEG-2 Decoder with Integrated NDS ICAM |
| MB86H22 | MPEG-2 Decoder for ext. Temperature Range |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB86977 | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:IP PACKET FORWARDING ENGINE |
| MB86977PFV-G-BND | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:IP PACKET FORWARDING ENGINE |
| MB86A21PMC-G-BNDE1 | 制造商:FUJITSU 功能描述: |
| MB86A21PMC-G-JNE1 | 制造商:FUJITSU 功能描述: |
| MB86A22PMC-ES-BNDE1 | 制造商:FUJITSU 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。