參數資料
型號: ISP1161ABM
廠商: NXP SEMICONDUCTORS
元件分類: 總線控制器
英文描述: Full-speed Universal Serial Bus single-chip host and device controller
中文描述: UNIVERSAL SERIAL BUS CONTROLLER, PQFP64
封裝: 7 X 7 MM, 1.40 MM HEIGHT, PLASTIC, MS-026, SOT-414-1, LQFP-64
文件頁數: 89/134頁
文件大?。?/td> 587K
代理商: ISP1161ABM
Philips Semiconductors
ISP1161A
Full-speed USB single-chip host and device controller
Product data
Rev. 03 — 23 December 2004
89 of 134
9397 750 13962
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
the DcDMACounter register. When the internal counter completes the transfer as
programmed in the DcDMACounter, an EOT condition is generated and the DMA
operation stops.
Short packet:
Normally, the transfer byte count must be set via a control endpoint
before any DMA transfer takes place. When a short packet has been enabled as EOT
indicator (SHORTP = 1), the transfer size is determined by the presence of a short
packet in the data. This mechanism permits the use of a fully autonomous data
transfer protocol.
When reading from an OUT endpoint, reception of a short packet at an OUT token
will stop the DMA operation after transferring the data bytes of this packet.
[1]
The DMA transfer stops. However, no interrupt is generated.
12.4.2
Isochronous endpoints
A DMA transfer to/from an isochronous endpoint can be terminated by any of the
following conditions (bit names refer to the DcDMAConfiguration register, see
Table 86
):
An external End-Of-Transfer signal occurs on input EOT
The DMA transfer completes as programmed in the DcDMACounter register
(CNTREN = 1)
An End-Of-Packet (EOP) signal is detected
DMA operation is disabled by clearing bit DMAEN.
Table 73:
EOT condition
EOT input
DcDMACounter register
Summary of EOT conditions for a bulk endpoint
OUT endpoint
EOT is active
transfer completes as
programmed in the
DcDMACounter register
Short packet
IN endpoint
EOT is active
transfer completes as
programmed in the
DcDMACounter register
counter reaches zero in the
middle of the buffer
DMAEN = 0
[1]
short packet is received and
transferred
DMAEN = 0
[1]
DMAEN bit in
DcDMAConfiguration register
Table 74:
EOT condition
EOT input active
DMA Counter register zero
End-Of-Packet
Recommended EOT usage for isochronous endpoints
OUT endpoint
do not use
do not use
preferred
IN endpoint
preferred
preferred
do not use
相關PDF資料
PDF描述
ISP1161 Full-speed Universal Serial Bus single-chip host and device controller
ISP1161A1 Universal Serial Bus single-chip host and device controller
ISP1161A1BD Universal Serial Bus single-chip host and device controller
ISP1161A1BM Universal Serial Bus single-chip host and device controller
ISP1161BD Full-speed Universal Serial Bus single-chip host and device controller
相關代理商/技術參數
參數描述
ISP1161ABM,518 功能描述:USB 接口集成電路 DO NOT USE ORDER ISP1161A1BM RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1161ABM,551 功能描述:USB 接口集成電路 DO NOT USE ORDER ISP1161A1BM RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1161ABM,557 功能描述:USB 接口集成電路 DO NOT USE ORDER ISP1161A1BM RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1161ABM-S 功能描述:IC USB HOST CTRL FULL-SPD 64LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN(6x6) 包裝:* 其它名稱:Q6396337A
ISP1161ABM-T 功能描述:IC USB HOST CTRL FULL-SPD 64LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN(6x6) 包裝:* 其它名稱:Q6396337A