參數資料
型號: DS2152L+
廠商: Maxim Integrated Products
文件頁數: 52/97頁
文件大?。?/td> 0K
描述: IC TXRX T1 1CHIP ENHNCD 100-LQFP
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 90
功能: 單芯片收發器
接口: T1
電路數: 1
電源電壓: 4.75 V ~ 5.25 V
電流 - 電源: 75mA
工作溫度: 0°C ~ 70°C
安裝類型: 表面貼裝
封裝/外殼: 100-LQFP
供應商設備封裝: 100-LQFP(14x14)
包裝: 管件
包括: DSX-1 和 CSU 線路補償發生器,HDLC 控制器,帶內回路代碼發生器和檢測器
產品目錄頁面: 1429 (CN2011-ZH PDF)
DS2152
56 of 97
11.3 Minimum Delay Synchronous RSYSCLK/TSYSCLK Mode
In applications where the DS2152 is connected to backplanes that are frequency-locked to the recovered
T1 clock (i.e., the RCLK output), the full two-frame depth of the on-board elastic stores is really not
needed. In fact, in some delay-sensitive applications the normal two-frame depth may be excessive. If the
CCR3.7 bit is set to 1, then the receive elastic store (and also the transmit elastic store if it is enabled) will
be forced to a maximum depth of 32 bits instead of the normal 386 bits. In this mode, RSYSCLK and
TSYSCLK must be tied together and they must be frequency-locked to RCLK. All the slip contention
logic in the DS2152 is disabled (since slips cannot occur). Also, since the buffer depth is no longer two
frames deep, the DS2152 must be set up to source a frame pulse at the RSYNC pin and this output must
be tied to the TSSYNC input. On power-up after the RSYSCLK and TSYSCLK signals have locked to
the RCLK signal, the elastic store reset bit (CCR3.6) should be toggled from 0 to 1 to ensure proper
operation.
相關PDF資料
PDF描述
DS2153Q-A7+T&R IC TXRX E1 1-CHIP 5V 44-PLCC
DS2154LNA2+ IC TXRX E1 5V 100-LQFP
DS2154L IC TXRX E1 1CHIP 5V ENH 100-LQFP
DS2155LN IC TXRX T1/E1/J1 1-CHIP 100-LQFP
DS2156LN+ IC TXRX T1/E1/J1 1-CHIP 100-LQFP
相關代理商/技術參數
參數描述
DS2152L+ 功能描述:網絡控制器與處理器 IC Enhanced T1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS2152L-ES 制造商:DALL 功能描述:
DS2152LN 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS2152LN+ 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS2153DK 功能描述:KIT DESIGN TXRX E1 DS2153 RoHS:否 類別:編程器,開發系統 >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 傳感器類型:CMOS 成像,彩色(RGB) 傳感范圍:WVGA 接口:I²C 靈敏度:60 fps 電源電壓:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相關產品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP