- 您現在的位置：買賣IC網 > PDF目錄380161 > CY4615 (Cypress Semiconductor Corp.) EZ-USB AT2⑩ USB 2.0 to ATA/ATAPI Bridge PDF資料下載
參數資料
| 型號： | CY4615 |
| 廠商： | Cypress Semiconductor Corp. |
| 英文描述： | EZ-USB AT2⑩ USB 2.0 to ATA/ATAPI Bridge |
| 中文描述： | 的EZ - USB AT2⑩個USB 2.0到ATA / ATAPI的橋 |
| 文件頁數： | 25/26頁 |
| 文件大小： | 193K |
| 代理商： | CY4615 |
CY7C68300
Document #: 38-08011 Rev. *B
Cypress Semiconductor Corporation, 2002. The information contained herein is subject to change without notice. Cypress Semiconductor Corporation assumes no responsibility for the use
of any circuitry other than circuitry embodied in a Cypress Semiconductor product. Nor does it convey or imply any license under patent or other rights. Cypress Semiconductor does not authorize
its products for use as critical components in life-support systems where a malfunction or failure may reasonably be expected to result in significant injury to the user. The inclusion of Cypress
Semiconductor products in life-support systems application implies that the manufacturer assumes all risk of such use and in doing so indemnifies Cypress Semiconductor against all charges.
Page 25 of 26
14.0
Other Design Considerations
Certain design considerations must be followed to ensure proper operation of the EZ-USB AT2. The following items should be
taken into account when designing a USB device with the EZ-USB AT2.
14.1
Power must be applied to the EZ-USB AT2 before, or at the same time as the ATA/ATAPI device. If power is supplied to the drive
first, the EZ-USB AT2 will start up in an undefined state. Designs that utilize separate power supplies for the EZ-USB AT2 and
the ATA/ATAPI device are not recommended.
Proper Power-up Sequence
14.2
The EZ-USB AT2 does not fully support IDE removable media devices. Changes in media state are not reported to the operating
system so users will be unable to eject/reinsert media properly. This may result in lost or corrupted data.
IDE Removable Media Devices
14.3
The size of the ATA/ATAPI device
’
s buffer can greatly affect the overall data transfer performance. Care should be taken to ensure
that devices have large enough buffers to handle the flow of data to/from the drive. The exact buffer size needed depends on a
number of variables, but a good rule of thumb is:
(aprox min buffer size) = (data rate) * (seek time + rotation time + other)
where (other) may include things like time to switch heads, power-up a laser, etc. Devices with buffers that are too small to handle
the extra data may perform considerably slower than expected.
Devices With Small Buffers
14.4
When the AT2 detects a lack of USB activity from the host, it enters an idle mode and waits for USB host activity to resume. While
in this idle mode, the core logic is still functioning and power consumption remains at its active level. Because of this, the AT2 is
not intended for use in battery or bus powered designs. Also, care should be taken to ensure that the AT2 does not draw power
from VBUS, since such a design will not meet USB specifications for standby current.
USB Idle Mode
15.0
Disclaimers, Trademarks, and Copyrights
Purchase of I
2
C components from Cypress, or one of its sublicensed Associated Companies, conveys a license under the Philips
I
2
C Patent Rights to use these components in an I
2
C system, provided that the system conforms to the I
2
C Standard Specification
as defined by Philips. EZ-USB AT2 is a trademark, and EZ-USB is a registered trademark, of Cypress Semiconductor. All product
and company names mentioned in this document are the trademarks of their respective holders.
Figure 13-2. Plot of the Solder Mask (White Area)
Figure 13-3. X-ray Image of the Assembly
相關PDF資料 |
PDF描述 |
|---|---|
| CY53120 | Neuron Chip Network Processor(Neuron 芯片網絡處理器) |
| CY53150 | Neuron Chip Network Processor(Neuron 芯片網絡處理器) |
| CY5474FCT138T | 1-of-8 Decoder |
| CY54FCT163TLCC | 4-Bit Binary Counter |
| CY54FCT163TQSOP | 4-Bit Binary Counter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CY4615A | 功能描述:開發板和工具包 - 其他處理器 Development Board COM RoHS:否 制造商:Freescale Semiconductor 產品:Development Systems 工具用于評估:P3041 核心:e500mc 接口類型:I2C, SPI, USB 工作電源電壓: |
| CY4615B | 功能描述:界面開發工具 Reference Design Kit COM RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
| CY4616 | 制造商:Cypress Semiconductor 功能描述:HIGH SPEED USB TO ATA - Bulk |
| CY4617 | 功能描述:開發板和工具包 - 其他處理器 Development Board COM RoHS:否 制造商:Freescale Semiconductor 產品:Development Systems 工具用于評估:P3041 核心:e500mc 接口類型:I2C, SPI, USB 工作電源電壓: |
| CY4617-CF | 制造商:Cypress Semiconductor 功能描述:USB LS DEVELOPMENT KIT - Bulk |
發布緊急采購，3分鐘左右您將得到回復。