- 您現在的位置：買賣IC網 > PDF目錄366550 > AM79C974 (Advanced Micro Devices, Inc.) PCnetTM-SCSI Combination Ethernet and SCSI Controller for PCI Systems PDF資料下載
參數資料
| 型號： | AM79C974 |
| 廠商： | Advanced Micro Devices, Inc. |
| 英文描述： | PCnetTM-SCSI Combination Ethernet and SCSI Controller for PCI Systems |
| 中文描述： | PCnetTM -的SCSI結合以太網和SCSI控制器PCI系統 |
| 文件頁數： | 132/153頁 |
| 文件大?。?/td> | 838K |
| 代理商： | AM79C974 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁當前第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁
AMD
P R E L I M I N A R Y
132
Am79C974
them to multiplex logic that can map these outputs to in-
terrupt controller inputs by means of software.
REQ
and
GNT
(pins 123, 124, 126,
and 127)
The Am53C974 uses pins 127 and 124 (
REQ
and
GNT
)
for bus master arbitration, while the Am79C790 uses
pins 126 and 123. The Am79C974 uses pins 127 and
124 (
REQA
and
GNTA
) for bus arbitration from the SCSI
controller, and it uses pins 126 and 123 (
REQB
and
GNTB
) for arbitration for the Ethernet controller. The
motherboard can connect both pairs of signals to its bus
arbitration logic through jumpers or zero Ohm series re-
sistors. One pair of resistors or jumpers would be omit-
ted for a SCSI only product, and the other pair would be
omitted for an Ethernet only product. Both pairs would
be inserted for a product with both SCSI and Ethernet.
If the motherboard uses a PCI controller that allows a
limited number of bus masters, you may have to omit
one PCI slot or define one slot to be slave only for a prod-
uct with both SCSI and Ethernet on the motherboard.
IDSEL (Pins 9 and 10)
The Am53C974 uses pin 9 for IDSEL, which is a chip se-
lect for the PCI configuration space, while the
Am79C790 uses pin 10 for IDSEL. The Am79C974,
which has two separate configuration spaces, uses pin
9 (IDSELA) to access the configuration space for the
SCSI controller and pin 10 (IDSELB) for the Ethernet
controller. IDSEL is used only during configuration cy-
cles, which are defined by the command on the C/
BE
lines during the address phase.
A typical way to generate the IDSEL signals on a
motherboard is to connect a separate address line to
each of the IDSEL pins of the various PCI devices and
expansion slots. Since a typical PCI motherboard will
not have more than 10 PCI devices and slots, two of the
high order address lines can be connected directly to
pins 9 and 10 of the AMD device. The Am79C970 will
respond only to configuration cycles when pin 10 is ac-
tive and will ignore configuration cycles when pin 9 is ac-
tive. The Am53C794 will respond only to configuration
cycles when pin 9 is active.
Clocks (Pins 60, 97, and 99)
The Am53C974 requires two clock inputs: SCSICLK1
(pin 60) and SCSICLK2 (pin 97). These clock inputs can
be driven by the same clock source. The Am79C790 re-
quires either a crystal connected to the XTAL1 and
XTAL2 pins (97 and 99) or an external oscillator con-
nected to XTAL1. The Am79C974 requires both a clock
input for SCSICLK (pin 60) and either a crystal con-
nected to the XTAL1 and XTAL2 pins (97 and 99) or an
external oscillator connected to XTAL1.
To satisfy all of these requirements, the motherboard
can connect pin 60 to pin 97 through a jumper or zero
Ohm resistor. For the SCSI only product, the oscillator
or crystal should be omitted and the jumper inserted.
For the Ethernet-only product the oscillator or crystal
should be inserted and the jumper omitted. It does not
matter whether or not the SCSI oscillator is included.
For the combination SCSI plus Ethernet product, the
crystal and the SCSI oscillator should be included, and
the jumper must be omitted.
Figure F-1 illustrates these connections.
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C974KCW | PCnetTM-SCSI Combination Ethernet and SCSI Controller for PCI Systems |
| AM79C975 | PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
| AM79C973 | PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
| AM79C973KCW | PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
| AM79C975KCW | PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C974KC | 制造商:Advanced Micro Devices 功能描述: |
| AM79C974KC/W | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LAN Node Controller |
| AM79C974KCW | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnetTM-SCSI Combination Ethernet and SCSI Controller for PCI Systems |
| AM79C975 | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
發布緊急采購，3分鐘左右您將得到回復。