- 您現在的位置：買賣IC網 > PDF目錄366550 > AM79C960KC (ADVANCED MICRO DEVICES INC) PCnetTM-ISA Single-Chip Ethernet Controller PDF資料下載
參數資料
| 型號： | AM79C960KC |
| 廠商： | ADVANCED MICRO DEVICES INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | PCnetTM-ISA Single-Chip Ethernet Controller |
| 中文描述： | 2 CHANNEL(S), 10M bps, LOCAL AREA NETWORK CONTROLLER, PQFP120 |
| 封裝： | CARRIER RING, PLASTIC, QFP-120 |
| 文件頁數： | 65/127頁 |
| 文件大?。?/td> | 814K |
| 代理商： | AM79C960KC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁當前第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁
P R E L I M I N A R Y
AMD
1-407
Am79C960
Transmit Mode Select (AUI
Mode only)
Low Receive Threshold. When
LRT = “1”, the internal twisted
pair receive thresholds are re-
duced by 4.5 dB below the
standard 10BASE-T value (ap-
proximately
3/5)
unsquelch threshold for the RXD
circuit will be 180–312 mV peak.
When LRT = “0”, the unsquelch
threshold for the RXD circuit will
be the standard 10BASE-T
value, 300–520 mV peak.
In either case, the RXD circuit
post squelch threshold will be
one half of the unsquelch
threshold.
This bit only has meaning when
the 10BASE-T network interface
is selected.
Read/write accessible only when
STOP bit is set. Cleared by
RESET.
Transmit Mode Select. TSEL
controls the levels at which the
AUI drivers rest when the AUI
transmit port is idle. When TSEL
= 0, DO+ and DO- yield “zero” dif-
ferential to operate transformer
coupled loads (Ethernet 2 and
802.3). When TSEL = 1, the DO+
idles at a higher value with re-
spect to DO- , yielding a logical
HIGH state (Ethernet 1).
This bit only has meaning when
the AUI network interface is
selected.
Read/write accessible only when
STOP bit is set. Cleared by
RESET.
Port Select bits allow for software
controlled selection of the net-
work medium. Medium selection
can be over ridden by the
MAUSEL pin if the XMAUSEL bit
in the ISA Configuration Register
is set.
Read/write accessible only when
STOP bit is set. Cleared by
RESET.
The network port configuration
are as follows:
LRT
and
the
TSEL
8-7
PORTSEL
[1:0]
PORTSEL[1:0]
0 0
0 1
1 0
1 1
Network Port
AUI
10BASE-T
GPSI*
Reserved
*Refer to the section on General Purpose Serial Interface for
detailed information on accessing GPSI.
6
INTL
Internal Loopback. See the de-
scription of LOOP, CSR15.2.
Read/write accessible only when
STOP bit is set.
5
DRTY
Disable Retry. When DRTY = “1”,
PCnet-ISA controller will attempt
only one transmission. If DRTY =
“0”, PCnet-ISA controller will
attempt 16 retry attempts before
signaling a retry error.
Read/write accessible only when
STOP bit is set.
4
FCOLL
Force Collision. This bit allows
the collision logic to be tested.
PCnet-ISA controller must be in
internal loopback for FCOLL to
be valid. If FCOLL = “1”, a colli-
sion will be forced during
loopback transmission attempts;
a Retry Error will ultimately re-
sult. If FCOLL = “0”, the Force
Collision logic will be disabled.
Read/write accessible only when
STOP bit is set.
3
DXMTFCS
Disable Transmit CRC (FCS).
When DXMTFCS = 0, the trans-
mitter will generate and append a
FCS to the transmitted frame.
When DXMTFCS = 1, the FCS
logic is allocated to the receiver
and no FCS is generated or sent
with the transmitted frame.
See also the ADD_FCS bit in
TMD1. If DXMTFCS is set, no
FCS will be generated. If both
DXMTFCS is set and ADD_FCS
is clear for a particular frame, no
FCS
ADD_FCS is set for a particular
frame, the state of DXMTFCS is
ignored and a FCS will be ap-
pended on that frame by the
transmit circuitry.
will
be
generated. If
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C960KCW | PCnetTM-ISA Single-Chip Ethernet Controller |
| AM79C961AKCW | PCnet ⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA |
| AM79C961AKC | PCnet ⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA |
| AM79C961A | PCnet ⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA |
| AM79C961AKIW | PCnet⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C960KC/W | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LAN Node Controller |
| AM79C960KCW | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnetTM-ISA Single-Chip Ethernet Controller |
| AM79C961 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Am79C961 - PCnet-ISA+ Jumperless Single-Chip Ethernet Controller for ISA |
| AM79C961/AM79C961A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Using the Am79C961/Am79C961A (PCnet-ISA+/PCnet-ISA II) Survival Guide? 134KB (PDF) |
發布緊急采購，3分鐘左右您將得到回復。