參數資料
型號： 376
廠商： Intel Corp.
英文描述： DIODE SCHOTTKY DUAL-DUAL SERIES 30V 200mW 0.38V-vf 200mA-IFM 1mA-IF 0.2uA-IR SOT-363 3K/REEL
中文描述： 376TM，高性能32位嵌入式處理器
文件頁數： 58/95頁
文件大?。?/td> 1293K
代理商： 376
376 EMBEDDED PROCESSOR
4.5 Self-Test Signature
Upon completion of self-test (if self-test was re-
quested by driving BUSY LOW at the falling edge of
RESET) the EAX register will contain a signature of
00000000H indicating the 80376 passed its self-test
of microcode and major PLA contents with no prob-
lems detected. The passing signature in EAX,
00000000H, applies to all 80376 revision levels. Any
non-zero signature indicates the 80376 unit is faulty.
4.6 Component and Revision
Identifiers
To assist 80376 users, the 80376 after reset holds a
component identifier and revision identifier in its DX
register. The upper 8 bits of DX hold 33H as identifi-
cation of the 80376 component. (The lower nibble,
03H, refers to the Intel386
TM
architecture. The up-
per nibble, 30H, refers to the third member of the
Intel386 family). The lower 8 bits of DX hold an
8-bit unsigned binary number related to the compo-
nent revision level. The revision identifier will, in gen-
eral, chronologically track those component step-
pings which are intended to have certain improve-
ments or distinction from previous steppings. The
80376 revision identifier will track that of the 80386
where possible.
The revision identifier is intended to assist 80376
users to a practical extent. However, the revision
identifier value is not guaranteed to change with ev-
ery stepping revision, or to follow a completely uni-
form numerical sequence, depending on the type or
intention of revision, or manufacturing materials re-
quired to be changed. Intel has sole discretion over
these characteristics of the component.
Table 4.7. Component and
Revision Identifier History
80376 Stepping Name
Revision Identifier
A0
05H
B
08H
4.7 Coprocessor Interfacing
The 80376 provides an automatic interface for the
Intel 80387SX numeric floating-point coprocessor.
The 80387SX coprocessor uses an I/O mapped in-
terface driven automatically by the 80376 and as-
sisted by three dedicated signals: BUSY, ERROR
and PEREQ.
As the 80376 begins supporting a coprocessor in-
struction, it tests the BUSY and ERROR signals to
determine if the coprocessor can accept its next in-
struction. Thus, the BUSY and ERROR inputs elimi-
nate the need for any ‘‘preamble’’ bus cycles for
communication between processor and coproces-
sor. The 80387SX can be given its command op-
code immediately. The dedicated signals provide
instruction synchronization, and eliminate the need
of using the 80376 WAIT opcode (9BH) for 80387SX
instruction synchronization (the WAIT opcode was
required when the 8086 or 8088 was used with the
8087 coprocessor).
Custom coprocessors can be included in 80376
based systems by memory-mapped or I/O-mapped
interfaces. Such coprocessor interfaces allow a
completely custom protocol, and are not limited to a
set of coprocessor protocol ‘‘primitives’’. Instead,
memory-mapped or I/O-mapped interfaces may use
all applicable 80376 instructions for high-speed co-
processor communication. The BUSY and ERROR
inputs of the 80376 may also be used for the custom
coprocessor interface, if such hardware assist is de-
sired. These signals can be tested by the 80376
WAIT opcode (9BH). The WAIT instruction will wait
until the BUSY input is inactive (interruptable by an
NMI or enabled INTR input), but generates an ex-
ception 16 fault if the ERROR pin is active when the
BUSY goes (or is) inactive. If the custom coproces-
sor interface is memory-mapped, protection of the
addresses used for the interface can be provided
with the segmentation mechanism of the 80376. If
the custom interface is I/O-mapped, protection of
the interface can be provided with the 80376 IOPL
(I/O Privilege Level) mechanism.
The 80387SX numeric coprocessor interface is I/O
mapped as shown in Table 4.8. Note that the
80387SX coprocessor interface addresses are be-
yond the 0H-0FFFFH range for programmed I/O.
When the 80376 supports the 80387SX coproces-
sor, the 80376 automatically generates bus cycles to
the coprocessor interface addresses.
Table 4.8 Numeric Coprocessor Port Addresses
Address in 80376
I/O Space
80387SX
Coprocessor Register
8000F8H
8000FCH
8000FEH
Opcode Register
Operand Register
Operand Register
58
相關PDF資料
PDF描述
37LV128-TISN DIODE ZENER SINGLE 200mW 2.7Vz 5mA-Izt 0.0741 20uA-Ir 1 SOD-323 3K/REEL
37LV128-TL DIODE ZENER SINGLE 150mW 2.7Vz 5mA-Izt 0.074 20uA-Ir 1 SOD-523 3K/REEL
37LV128-TP DIODE/SM, ZEN 30V .5MA 0.41W +/-5% SOD-123
37LV128-TSN 36K, 64K, and 128K Serial EPROM Family
37LV128-IL 36K, 64K, and 128K Serial EPROM Family
相關代理商/技術參數
參數描述
376 制造商:Pro-Signal 功能描述:; Supply Voltage:28VDC; Lamp Base Type:M
37-6.8 制造商:Distributed By MCM 功能描述:Resistor 1/2W 6.8 Ohm Flameproof, Bag of 20 制造商:MCM 功能描述:1/2 Watt Flameproof Resistors, Resistance: 6.8 Ohm, Tolerance: 5 %, Quantity: 20 per bag
37-6.8K 制造商:Distributed By MCM 功能描述:Resistor 1/2W 6.8K Ohm Flameproof, Bag of 20 制造商:MCM 功能描述:RESISTOR 1/2W 6.8K OHM FLAMPRF20 PER BAG
376/377-1ZM 制造商:Rayovac 功能描述:SILVER ELECTRONIC BTRY 1PK MERCURY FREE
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*