TABLE 10: UART CHANNEL [7:0] I
參數資料
型號: XR16M598IQ100-F
廠商: Exar Corporation
文件頁數: 20/58頁
文件大?。?/td> 0K
描述: IC UART FIFO 16B OCTAL 100QFP
標準包裝: 66
特點: *
通道數: 8
FIFO's: 16 字節
規程: RS485
電源電壓: 1.62 V ~ 3.63 V
帶自動流量控制功能:
帶IrDA 編碼器/解碼器:
帶故障啟動位檢測功能:
帶調制解調器控制功能:
安裝類型: 表面貼裝
封裝/外殼: 100-BQFP
供應商設備封裝: 100-QFP(14x20)
包裝: 托盤
TABLE 10: UART CHANNEL [7:0] INTERRUPT SOURCE ENCODING AND CLEARING
PRIORITY
Bit
2
Bit
1
Bit
0
INTERRUPT SOURCE(S) AND CLEARING
x
0
0 None or wake-up indicator
1
0
1 RXRDY & RX Line Status (logic OR of LSR[4:1]). RXRDY INT clears by reading data in the RX
FIFO until it falls below the trigger level; RX Line Status INT cleared after reading LSR register.
2
0
1
0 RXRDY Time-out: Cleared same way as RXRDY INT.
3
0
1
1 TXRDY, THR or TSR (auto RS485 mode) empty, clears after reading ISR register.
4
1
0
0 MSR, RTS/CTS or DTR/DSR delta or Xoff/Xon or special character detected. The first two
clears after reading MSR register; Xoff/Xon or special char. detect INT clears after reading ISR
register.
5
1
0
1 Reserved.
6
1
0 Reserved.
7
1
1 TIMER Time-out, shows up as a channel 0 INT. It clears after reading the TIMERCNTL register.
Reserved in other channels.
XR16M598
27
REV. 1.0.0
1.62V TO 3.63V HIGH PERFORMANCE OCTAL UART WITH 16-BYTE FIFO
3.1.2
General Purpose 16-bit Timer/Counter [TIMERMSB, TIMELSB, TIMER, TIMECNTL] (DEFAULT
0XXX-XX-00-00)
The 598 includes a 16-bit general purpose timer/counter. Its clock source may be selected from internal crystal
oscillator or externally on pin TMRCK. The timer can be set to be a single-shot for a one-time event or re-
triggerable for a periodic signal. An interrupt may be generated when the timer times out and will show up as a
Channel 0 interrupt (see Table 10). It is controlled through 4 configuration registers [TIMERCNTL, TIMER,
TIMELSB, TIMERMSB]. These registers provide start/stop and re-triggerable or one-shot operation (see
below). The time-out output of the Timer can be set to generate an interrupt for system or event
alarm.
3.1.2.1
TIMERMSB [7:0] and TIMERLSB [7:0]
TIMERMSB and TIMERLSB form a 16-bit value. The least-significant bit of the timer is being bit-0 of the
TIMERLSB with most-significant-bit being bit-7 in TIMERMSB. Notice that these registers do not hold the
current counter value when read. Default value is zero (timer disabled) upon powerup and reset.
TIMERMSB Register
Bit-15 Bit-14 Bit-13 Bit-12 Bit-11 Bit-10
Bit-9 Bit-8
TIMERLSB Register
Bit-7
Bit-6
Bit-5
Bit-4
Bit-3
Bit-2
Bit-1 Bit-0
16-Bit Timer/Counter Programmable Registers
3.1.2.2
TIMER [7:0] Reserved
3.1.2.3
TIMERCNTL [7:0] Register
The bits 3:0 of this register are used to issue commands. The commands are self-clearing, so reading this
register does not show the last written command. Reading this register returns a value of 0x01 when there is a
Timer interrupt pending and 0x00 at all other times.
相關PDF資料
PDF描述
XR16M654IQ100-F IC UART FIFO 64B QUAD 100QFP
XR16M670IL32-F IC UART FIFO 32B 32QFN
XR16M680IM48-F IC UART FIFO 32B 48TQFP
XR16M681IL32-F IC UART FIFO 64B 32QFN
XR16M698IQ100-F IC UART FIFO 32B OCTAL 100QFP
相關代理商/技術參數
參數描述
XR16M654 制造商:EXAR 制造商全稱:EXAR 功能描述:1.62V TO 3.63V QUAD UART WITH 64-BYTE FIFO
XR16M654D 制造商:EXAR 制造商全稱:EXAR 功能描述:1.62V TO 3.63V QUAD UART WITH 64-BYTE FIFO
XR16M654DIV-0A-EVB 功能描述:界面開發工具 Eval Board for XR16M654DIV-0A RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
XR16M654DIV-0B-EVB 功能描述:界面開發工具 Eval Board for XR16M654DIV-0B RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
XR16M654DIV64 制造商:EXAR 制造商全稱:EXAR 功能描述:1.62V TO 3.63V QUAD UART WITH 64-BYTE FIFO