參數(shù)資料
型號: UCB1500
廠商: NXP SEMICONDUCTORS
元件分類: 總線控制器
英文描述: PCI to AC97 bridge/host controller
中文描述: PCI BUS CONTROLLER, PQFP80
封裝: 12 X 12 MM, 1.40 MM HEIGHT, PLASTIC, MS-026, SOT-315-1, LQFP-80
文件頁數(shù): 21/58頁
文件大?。?/td> 1001K
代理商: UCB1500
Philips Semiconductors
UCB1500
PCI to AC97 bridge/host controller
Objective specification
Rev. 01 — 4 February 2000
21 of 58
9397 750 06854
Philips Electronics N.V. 2000. All rights reserved.
8.1.3
[0011]: Receive DMA #1 Descriptor table pointer (DTP) register
8.1.4
[0012]: Receive DMA #1 FIFO count register
8.1.5
[0013]: Receive DMA #1 command register
Table 25: Receive DMA #1 DPT register bit description
Bit
Description
15-0
Descriptor Table Pointer [31:16]
Bits 31-16 of receive DMA #1 Descriptor Table Pointer.
Table 26: Receive DMA #1 FIFO count register bit description
Bit
Description
15(r)
Open PCI Master Cycle
(For internal use only): This bit is set if there is an outstanding PCI master cycle
as a result of PCI retry termination by the target. Software should wait for this bit
to be cleared when initiating another DMA transfer right after an aborted DMA
transfer.
14
DTP Invalid Bit Mask
If this bit is set to ‘1’, the receive DMA engine will not stop even if the current
descriptor fetched has the invalid bit set.
13-7
Reserved.
6-0(r)
Receive DMA #1 FIFO count
(For internal use only) number of received bytes that is still in the internal 64-byte
FIFO.
Table 27: Receive DMA #1 Command Register bit description
Bit
Description
15-14
Threshold level
Specifies the level at which data is transferred from the 64-byte FIFO to main
memory. Recommended setting is for at least 16 bytes threshold.
00 = 4 bytes, data will be transferred to memory as soon as there is at least
4 bytes of receive data in the receive FIFO
01 = 16 bytes
10 = 32 bytes
11 = 48 bytes
Buffer Overrun auto recovery
(for internal user only)
If set, UCB1500 will automatically recover from buffer overrun without user
intervention. Upon detecting an overrun condition, UCB1500 will clear the invalid
bit of the current descriptor, flush the internal FIFO, and then resume the DMA
cycle. UCB1500 keeps track of the number of DMA errors caused by buffer
overrun and will generate the auto recovery cycle until the count reaches 15h at
which time the DMA cycle is aborted.
Receive DMA #1 Abort status
This read-only bit is set if the receive channel has been aborted as a result of a
PCI abort or a software abort or a DMA error. The condition is cleared by writing
a ‘1’ to the receive DMA clear abort bit, bit 5 of this register.
13
12(r)
相關PDF資料
PDF描述
UCC1913D Very low drop voltage regulators with inhibit
UCC1913DTR Analog IC
UCC1913J Very low drop voltage regulators with inhibit
UCC1913N Very low drop voltage regulators with inhibit
UCC1926DS Very low drop voltage regulators with inhibit
相關代理商/技術參數(shù)
參數(shù)描述
UCB1510 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:AC97 digital modem codec
UCB15-101T-RC 制造商:ALLIED 制造商全稱:Allied Components International 功能描述:Ultra Current Beads
UCB1510DB 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:AC97 digital modem codec
UCB15-121T-RC 制造商:ALLIED 制造商全稱:Allied Components International 功能描述:Ultra Current Beads
UCB15-600T-RC 制造商:ALLIED 制造商全稱:Allied Components International 功能描述:Ultra Current Beads