- 您現在的位置：買賣IC網 > PDF目錄373745 > TSS463D Industrial Control IC PDF資料下載
參數資料
| 型號： | TSS463D |
| 英文描述： | Industrial Control IC |
| 中文描述： | 工業控制IC |
| 文件頁數： | 38/52頁 |
| 文件大?。?/td> | 268K |
| 代理商： | TSS463D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁當前第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
TSS461C
38
Rev. D (22 Feb 01)
11. Messages Types
There are 5 basic message types defined in the TSS461C. Two of them (transmit and receive message types) correspond
to the normal frame, and the rest correspond to the different versions of reply frames.
Transmit Message
RNW
RTR
Transmitted
Received
Initial
setup
0
0
0
Dont care
After transmission
0
0
1
Unchanged
To transmit a normal data frame on the VAN bus, the user must program an identifier as a Transmit Message. The
TSS461C will then transmit this message on the bus until it has succeeded or the retry count is exceeded.
Receive Message
RNW
RTR
Transmitted
Received
Initial
setup
0
1
Dont care
0
After transmission
0
1
Unchanged
1
The opposite of the transmit message type is the Receive Message type. This message type will not generate any frames
on the bus. Instead it will listen to the bus until a frame passes that matches its identifier, with the mask taken into
account, and then receive the data in that frame.
The data received will be stored in the message buffer and the length of the message received is stored in the first byte
of the message buffer.
The actual identifier received is stored in the identifier register itself. This identifier may differ from the identifier
specified in the register due to the effect of the mask register.
Normally this should not interfere with the next identifier comparison since the bits that may differ are masked via the
mask register.
Reply Request Message
RNW
RTR
Transmitted
Received
Initial
setup
1
1
0
0
After
transmission
(Waiting
for reply)
1
1
1
0
After
reception
(of reply)
1
1
1
1
The Reply Request Message type is a demand to transmit on the VAN bus a reply request. When this message type
is programmed, three things can happen.
In the first case no other modules on the bus responded with an in-frame reply, and in this case the TSS461C will set
the message type to the after transmission state. When this message type is programmed, the TSS461C will listen on
the bus for a deferred reply frame matching this identifier, without transmitting the reply request.
The second case is that another module on the bus replies with an in-frame reply. In this case the message type will
pass immediatly into the after reception state, without passing the after transmission state.
相關PDF資料 |
PDF描述 |
|---|---|
| TSS463R | Industrial Control IC |
| TSS461E | VAN Data Link Controller |
| TSS461E-TDRA-9 | VAN Data Link Controller |
| TSS461E-TERA-9 | VAN Data Link Controller |
| TSS461E-TRDZ-9 | VAN Data Link Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSS463R | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Industrial Control IC |
| TSS463VAN | 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:Van Controller Serial Interface |
| TSS47 | 功能描述:瓷片電容器 100V 20% 0.047uF RoHS:否 制造商:Vishay/Cera-Mite 電容:0.01 uF 容差:20 % 電壓額定值:3 kV 工作溫度范圍:- 25 C to + 105 C 損耗因數 DF: 端接類型:Radial 產品:High Voltage Ceramic Disc Capacitors |
| TSS4B01G | 功能描述:整流器 4.0 Amp 50 Volt 150 Amp IFSM RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel |
| TSS4B01G C2 | 制造商:SKMI/Taiwan 功能描述:Diode Rectifier Bridge Single 50V 4A 4-Pin TS4B Tube |
發布緊急采購，3分鐘左右您將得到回復。