- 您現在的位置：買賣IC網 > PDF目錄373745 > TSS463D Industrial Control IC PDF資料下載
參數資料
| 型號： | TSS463D |
| 英文描述： | Industrial Control IC |
| 中文描述： | 工業控制IC |
| 文件頁數： | 17/52頁 |
| 文件大?。?/td> | 268K |
| 代理商： | TSS463D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
TSS461C
17
Rev. D (22 Feb 01)
8. Diagnosis System
The purpose of the diagnosis system is to detect any short or open circuits on either the DATA or DATA lines
and to permit, if it is possible, to carry the communications on the non-defective line.
The diagnosis system is based on the assumption that three separate line receivers are connected to the VAN bus (c.f.
Figure 3. ):
One of the line receivers is connected in differential mode, sensing both DATA and DATA signals, and is connected
to the RxD0 input.
The other two line receivers are operating in single wire mode and are sensing only one of the two VAN bus signals:
the line receiver sensing DATA is connected to RxD1,
the line receiver sensing DATA is connected to RxD2.
The diagnosis system analyses and compares the data sent over both VAN lines. So, the diagnosis system executes a
digital filtering and transition analyses. In order to perform its investigation, three internal signals are generated, RI
(
Return to Idle)
, SDC (
Synchronous Diagnosis Clock)
and TIP (
Transmission In Progress
).
One of four operating modes can be chosen to manage the results of the diagnosis system.
8.1. Diagnosis States
If the diagnosis system finds a failure on either of the VAN bus signals, it changes from nominal to degraded mode,
and connects the line receiver not coupled to the failing signal to the reception logic.
When the diagnosis system finds that the failing signal is working again, it returns to nominal mode and re-connects
the differential line receiver to the reception logic.
A major error occurs when both the VAN bus signals are failed.
NONIMAL
MAJOR
ERROR
DEGRATED
DATA
DEGRATED
DATA
- Failure during the frame.
- Default of transitions on the valid input between 2 consecutive SDC rising edges.
- Protocol fault
- In specified selection mode, every RI pulse when an EOF is detected or through an active SDC.
- In automatic selection mode and SDC active, no failure sampled by 2 consecutive SDC rising edges.
- General reset
Figure 17. Diagnosis States
相關PDF資料 |
PDF描述 |
|---|---|
| TSS463R | Industrial Control IC |
| TSS461E | VAN Data Link Controller |
| TSS461E-TDRA-9 | VAN Data Link Controller |
| TSS461E-TERA-9 | VAN Data Link Controller |
| TSS461E-TRDZ-9 | VAN Data Link Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSS463R | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Industrial Control IC |
| TSS463VAN | 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:Van Controller Serial Interface |
| TSS47 | 功能描述:瓷片電容器 100V 20% 0.047uF RoHS:否 制造商:Vishay/Cera-Mite 電容:0.01 uF 容差:20 % 電壓額定值:3 kV 工作溫度范圍:- 25 C to + 105 C 損耗因數 DF: 端接類型:Radial 產品:High Voltage Ceramic Disc Capacitors |
| TSS4B01G | 功能描述:整流器 4.0 Amp 50 Volt 150 Amp IFSM RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel |
| TSS4B01G C2 | 制造商:SKMI/Taiwan 功能描述:Diode Rectifier Bridge Single 50V 4A 4-Pin TS4B Tube |
發布緊急采購，3分鐘左右您將得到回復。