參數資料
型號: TSS463D
英文描述: Industrial Control IC
中文描述: 工業控制IC
文件頁數: 1/52頁
文件大?。?/td> 268K
代理商: TSS463D
TSS461C
1
Rev. D (22 Feb 01)
1. Description
Cost optimization in car manufacturing is of extreme importance today. Solutions to this problem often implies the
use of more advanced and intelligent electronic circuits.
The TSS461C is such a circuit, which allows the transfer of all the status information needed in a car or truck over a
single low-cost wire pair, thereby minimizing the electrical wire usage.
It can be used to interconnect powerful functions (ABS, dashboard, power train control) and to control and interface
car body electronics (lights, wipers, power window...).
The TSS461C is fully compliant with the ISO standard ISO/11519-3. This standard supports a wide range of
applications such as low-cost remote controlled switches, typically used for lamp control, up to complex, highly
autonomous, distributed systems like engine controls, which require fast and secure data transfers.
The TSS461C is a microprocessor interfaced line controller for mid to high complexity bus-masters and listeners like
injection/ignition control calculators, dashboard controllers and car stereo or mobile telephone CPUs.
The microprocessor interface consists of a 256 byte RAM and register area divided into 11 control registers, 14 channel
register sets and 128 bytes of general purpose RAM, used as a message storage area, and a 6-source maskable interrupt.
The circuit operates in the RAM using DMA techniques, controlled by the channel and control registers. This allows
virtually any microprocessor to interface with ease to the TSS461C, and to use the free RAM as a scratch pad.
Messages are encoded in enhanced Manchester code, and an optional pulsed code for use with an optical or radio link,
at a maximum bit rate of 1 Mbit/s. The TSS461C analyzes the messages received or transmitted according to 6 different
criterias including some higher level checks.
In addition the bus interface has three separate inputs with automatic source diagnosis and selection, allowing for
multibus listening or the automatic selection of the most reliable source at any time if several line receivers are
connected to the same bus.
2. Features
Fully compliant to VAN specification ISO/11519.3.
Handles all specified module types.
Handles all specified message types.
Handles retransmission of frames on contention and errors.
3 separate line inputs with automatic diagnosis and selection.
1 Mbit/s maximum transfer rate.
Normal or pulsed (optical and radio mode) coding.
INTEL, NEC, TI and MOTOROLA compatible 8-bit microprocessor interface.
Multiplexed address and data bus.
Idle and sleep modes.
128 bytes of general purpose RAM.
DMA capabilities for message handling.
14 identifier registers with all bits individually maskable.
6-source maskable interrupt including an interrupt-on-reset to detect glitches on the reset pin.
Integrated crystal or resonator oscillator with internal baud rate generator and buffered clock output.
Single +5V power supply.
0.8
μ
m CMOS technology.
SOP 24 packaging.
Vehicle Area Network Data Link Controller
相關PDF資料
PDF描述
TSS463R Industrial Control IC
TSS461E VAN Data Link Controller
TSS461E-TDRA-9 VAN Data Link Controller
TSS461E-TERA-9 VAN Data Link Controller
TSS461E-TRDZ-9 VAN Data Link Controller
相關代理商/技術參數
參數描述
TSS463R 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Industrial Control IC
TSS463VAN 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:Van Controller Serial Interface
TSS47 功能描述:瓷片電容器 100V 20% 0.047uF RoHS:否 制造商:Vishay/Cera-Mite 電容:0.01 uF 容差:20 % 電壓額定值:3 kV 工作溫度范圍:- 25 C to + 105 C 損耗因數 DF: 端接類型:Radial 產品:High Voltage Ceramic Disc Capacitors
TSS4B01G 功能描述:整流器 4.0 Amp 50 Volt 150 Amp IFSM RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel
TSS4B01G C2 制造商:SKMI/Taiwan 功能描述:Diode Rectifier Bridge Single 50V 4A 4-Pin TS4B Tube