- 您現在的位置：買賣IC網 > PDF目錄373745 > TSS463D Industrial Control IC PDF資料下載
參數資料
| 型號： | TSS463D |
| 英文描述： | Industrial Control IC |
| 中文描述： | 工業控制IC |
| 文件頁數： | 18/52頁 |
| 文件大?。?/td> | 268K |
| 代理商： | TSS463D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
TSS461C
18
Rev. D (22 Feb 01)
Status bits give permanent information on the diagnosis performed, whatever the programmed operating mode. This
is encoded over three bits: Sa, Sb and Sc.
Sa and Sb bits indicate the four possible states of the VAN bus
Table 1. Status bits: Sa & Sb
Sa
Sb
Communication
Mode
nominal
0
0
Fault
no fault on VAN bus
Status
differential communication on DATA and DATA
Mode
degraded on DATA
0
1
Fault
fault on DATA
Status
communication on DATA
Mode
degraded on DATA
1
0
Fault
fault on DATA
Status
communication on DATA
Mode
major error
1
1
Fault
fault on DATA and DATA
Status
no communication on DATA and DATA (attempt to communicate alternatively on
DATA then DATA every SDC period)
Sc bit sets to 1 as soon as one of the three inputs (RXD2, RXD1, RXD0) differs from the others in the input
comparison analysis performs by the diagnosis system, S2 is set.
The only ways to reset this status bit are through the RI signal or a general reset.
8.2. Internal Operations
8.2.1. Digital Filtering
If several spurious pulses occur during one bit, the diagnosis for defective conductor may be corrupted. To avoid such
errors, digital filters are implemented.
Filtering operation is based on sampling of the comparator output signals. A transition is taken into account only if
it is observed over five samples (1/16
th
of timeslot).
8.2.2. Transition Analyses
These analyses are continuously done on the effective edges on comparators after digital filtering.
Asynchronous diagnosis
The asynchronous diagnosis is done by comparing the number of edges on DATA and DATA.
If four edges are detected on one input and no edges on the other during the same peiod, the second input is
considered faulty and the diagnosis mode will change to one of the degraded modes.
Synchronous diagnosis
The synchronous diagnosis counts the number of edges on the data input connected to the reception logic during
one SDC period.
If there are less than four edges during one SDC period, the diagnosis mode will change to the major error mode.
相關PDF資料 |
PDF描述 |
|---|---|
| TSS463R | Industrial Control IC |
| TSS461E | VAN Data Link Controller |
| TSS461E-TDRA-9 | VAN Data Link Controller |
| TSS461E-TERA-9 | VAN Data Link Controller |
| TSS461E-TRDZ-9 | VAN Data Link Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSS463R | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Industrial Control IC |
| TSS463VAN | 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:Van Controller Serial Interface |
| TSS47 | 功能描述:瓷片電容器 100V 20% 0.047uF RoHS:否 制造商:Vishay/Cera-Mite 電容:0.01 uF 容差:20 % 電壓額定值:3 kV 工作溫度范圍:- 25 C to + 105 C 損耗因數 DF: 端接類型:Radial 產品:High Voltage Ceramic Disc Capacitors |
| TSS4B01G | 功能描述:整流器 4.0 Amp 50 Volt 150 Amp IFSM RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel |
| TSS4B01G C2 | 制造商:SKMI/Taiwan 功能描述:Diode Rectifier Bridge Single 50V 4A 4-Pin TS4B Tube |
發布緊急采購，3分鐘左右您將得到回復。