- 您現在的位置：買賣IC網 > PDF目錄385945 > TPS2306EVM-001 (Texas Instruments, Inc.) TPS2306 Dual Sequencing Hot Swap Power Manager Evaluation Module and Interface Card(雙序列熱交換電源管理器件TPS2306的評估板與接口卡) PDF資料下載
參數資料
| 型號： | TPS2306EVM-001 |
| 廠商： | Texas Instruments, Inc. |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | TPS2306 Dual Sequencing Hot Swap Power Manager Evaluation Module and Interface Card(雙序列熱交換電源管理器件TPS2306的評估板與接口卡) |
| 中文描述： | TPS2306熱插拔雙測序電源管理評估模塊和接口卡（雙序列熱交換電源管理器件TPS2306的評估板與接口卡） |
| 文件頁數： | 16/19頁 |
| 文件大?。?/td> | 462K |
| 代理商： | TPS2306EVM-001 |
SLUU094
16
TPS2306 Dual Sequencing Hot Swap Power Manager
To modify the IMAX levels of the EVM, appropriate resistor values are determined using equation 5. For a
desired IMAXx value, the value of R3 or R4 (R
IMAXx
in the equation) is given by:
IMAXx
RSNSx
(1.1)
(1.5 V) R14
RIMAXx
Where:
IMAXx = the desired current level for Channel x, and
R
SNSx
= the value of that Channel
’
s current sense resistor
As an example, the Channel 1 IMAX current of the TPS2306 EVM, as supplied from the factory, is a nominal
2 A. Using equation 5, the value of R3 is found as follows:
R3
IMAX1
1.1
R1
1.5 V
R14
(2.0 )
1.1
(0.05
1.5 V
)
15 k
909
For additional details on setting the IMAX levels, refer to the TPS2306 device data sheet.
4.5
Optional Soft-Start With the TPS2306
The TPS2306 can be used with or without inrush soft-start. Without soft-start, when the output turn-on conditions
are met, the load currents virtually step to the programmed IMAX level, where they are limited during the start-up
transient. Once the loads
’
input bulk capacitance is charged to the input dc levels, the sourcing current tapers
to the steady-state load level. In this configuration, the TPS2306 provides constant-current charging of the
loads
’
capacitance. To test this mode of operation, the user should remove capacitors C3 (for Channel 1) and
C4 (for Channel 2).
Even with the current-limiting function provided by the internal LCA control, some power distribution systems
may still be sensitive to the di/dt event that occurs when the pass FETs are first turned on. For these applications,
inrush slew-rate control (soft-start) is easily implemented with the TPS2306, by installing capacitors in parallel
with the IMAX programming resistors. The TPS2306 EVM is designed to demonstrate the soft-start capability
of the device. Capacitors C3 and C4 are installed to program the slew rates to two very different curves. Adding
a capacitor in parallel with the IMAX resistor applies an RC time-constant to the reference voltage generation
at the IMAXx pins of the device. Due to the closed-loop control provided by the internal amplifiers during output
ramp-up, the load current supplied also ramps with a corresponding RC characteristic. For the TPS2306 EVM,
Channel 1 sourcing current has a time constant of only (0.056
μ
F) * (909
) = 51
μ
s, while the Channel 2 constant
is on the order of (1.2
μ
F) * (365
)
440
μ
s.
For additional information on establishing the inrush current profile, and a discussion about its effect on load
start-up times, refer to the device data sheet.
(5)
(6)
相關PDF資料 |
PDF描述 |
|---|---|
| TPS2310PW | DUAL HOT SWAP POWER CONTROLLER WITH INTERDEPENDENT CIRCUIT BREAKER AND POWER-GOOD REPORTING |
| TPS2311PW | DUAL HOT SWAP POWER CONTROLLER WITH INTERDEPENDENT CIRCUIT BREAKER AND POWER-GOOD REPORTING |
| TPS2320D | DUAL HOT SWAP POWER CONTROLLER WITH INDEPENDENT CIRCUIT BREAKER |
| TPS2320PW | DUAL HOT SWAP POWER CONTROLLER WITH INDEPENDENT CIRCUIT BREAKER |
| TPS2321D | DUAL HOT SWAP POWER CONTROLLER WITH INDEPENDENT CIRCUIT BREAKER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS230QP | 制造商:Texas Instruments 功能描述: |
| TPS2310IPW | 功能描述:熱插拔功率分布 3-13V Dual w/Intrdpt Chl Circuit Breaking RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS2310IPWG4 | 功能描述:熱插拔功率分布 3-13V Dual w/Intrdpt Chl Circuit Breaking RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS2310IPWR | 功能描述:熱插拔功率分布 3-13V Dual w/Intrdpt Chl Circuit Breaking RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS2310IPWRG4 | 功能描述:熱插拔功率分布 3-13V Dual w/Intrdpt Chl Circuit Breaking RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。