- 您現在的位置：買賣IC網 > PDF目錄368672 > TMS320LC542-40 Digital Signal Processor PDF資料下載
參數資料
| 型號： | TMS320LC542-40 |
| 元件分類： | 數字信號處理 |
| 英文描述： | Digital Signal Processor |
| 中文描述： | 數字信號處理器 |
| 文件頁數： | 29/111頁 |
| 文件大?。?/td> | 1426K |
| 代理商： | TMS320LC542-40 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁
TMS320C54x, TMS320LC54x, TMS320VC54x
FIXED-POINT DIGITAL SIGNAL PROCESSORS
SPRS039C – FEBRUARY 1996 – REVISED DECEMBER 1999
29
POST OFFICE BOX 1443
HOUSTON, TEXAS 77251–1443
host-port interface (’542, ’545, ’548, and ’549 only) (continued)
Data transfers of 16-bit words occur as two consecutive bytes with a dedicated pin (HBIL) indicating whether
the high or low byte is being transmitted. Two control pins, HCNTL1 and HCNTL0, control host access to the
HPIA, HPI data (with an optional automatic address increment), or the HPIC. The host can interrupt the DSP
device by writing to HPIC. The DSP device can interrupt the host with a dedicated HINT pin that the host can
acknowledge and clear.
The HPI has two modes of operation, shared-access mode (SAM) and host-only mode (HOM). In SAM, the
normal mode of operation, both the DSP device and the host can access HPI memory. In this mode,
asynchronous host accesses are resynchronized internally and, in case of conflict, the host has access priority
and the DSP device waits one cycle. The HOM capability allows the host to access HPI memory while the DSP
device is in IDLE2 (all internal clocks stopped) or in reset mode. The host can therefore access the HPI RAM
while the DSP device is in its optimal configuration in terms of power consumption.
The HPI control register has two data strobes, HDS1 and HDS2, a read/write strobe HR/W, and an address
strobe HAS, to enable a glueless interface to a variety of industry-standard host devices. The HPI is interfaced
easily to hosts with multiplexed address/data bus, separate address and data buses, one data strobe and a
read/write strobe, or two separate strobes for read and write.
The HPI supports high-speed back-to-back accesses.
In the SAM, the HPI can handle one byte every five DSP device periods—that is, 64 MBps with a 40-MIPS
DSP, or 160 MBps with a 100-MIPS DSP. The HPI is designed so that the host can take advantage of this
high bandwidth and run at frequencies up to (f n)
÷
5, where n is the number of host cycles for an external
access and f is the DSP device frequency.
In HOM, the HPI supports high-speed back-to-back host accesses at 1 byte every 50 ns—that is, 160 MBps
with a -40 or faster DSP.
serial ports
The ’54x devices provide high-speed full-duplex serial ports that allow direct interface to other ’54x devices,
codecs, and other devices in a system. There is a standard serial port, a time-division-multiplexed (TDM) serial
port, and a buffered serial port (BSP). The ’549 devices provides a misalignment detection feature to that allows
the device to detect when a word or words are lost in the serial data line.
The general-purpose serial port utilizes two memory-mapped registers for data transfer: the data-transmit
register (DXR) and the data-receive register (DRR). Both of these registers can be accessed in the same
manner as any other memory location. The transmit and receive sections of the serial port each have associated
clocks, frame-synchronization pulses, and serial-shift registers; and serial data can be transferred either in
bytes or in 16-bit words. Serial port receive and transmit operations can generate their own maskable transmit
and receive interrupts (XINT and RINT), allowing serial-port transfers to be managed through software. The ’54x
serial ports are double-buffered and fully static.
The TDM port allows the device to communicate through time-division multiplexing with up to seven other ’54x
devices with TDM ports. Time-division multiplexing is the division of time intervals into a number of subintervals
with each subinterval representing a prespecified communications channel. The TDM port serially transmits
16-bit words on a single data line (TDAT) and destination addresses on a single address line (TADD). Each
device can transmit data on a single channel and receive data from one or more of the eight channels, providing
a simple and efficient interface for multiprocessing applications. A frame synchronization pulse occurs once
every 128 clock cycles, corresponding to the transmission of one 16-bit word on each of the eight channels. Like
the general-purpose serial port, the TDM port is double-buffered on both input and output data.
The buffered serial port (BSP) consists of a full-duplex double-buffered serial-port interface and an
auto-buffering unit (ABU). The serial port block of the BSP is an enhanced version of the standard serial port.
The ABU allows the serial port to read/write directly to the ’54x internal memory using a dedicated bus
independent of the CPU. This results in minimal overhead for serial port transactions and faster data rates.
相關PDF資料 |
PDF描述 |
|---|---|
| TMS320LC542-50 | Digital Signal Processor |
| TMS320UVC5409 | 16-Bit Digital Signal Processor |
| TMS320UVC5402 | Fixed-Point Digital Signal Processor(定點DSP) |
| TMS320VC5409PGE-100 | 16-Bit Digital Signal Processor |
| TMS320VC5409GGU-100 | 16-Bit Digital Signal Processor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TMS320LC542PBK1-50 | 功能描述:數字信號處理器和控制器 - DSP, DSC Dig Signal Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| TMS320LC542PBK2-50 | 功能描述:數字信號處理器和控制器 - DSP, DSC Dig Signal Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| TMS320LC542PGE1-40 | 功能描述:數字信號處理器和控制器 - DSP, DSC Dig Signal Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| TMS320LC542PGE1-50 | 功能描述:數字信號處理器和控制器 - DSP, DSC Dig Signal Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| TMS320LC542PGE2-40 | 功能描述:數字信號處理器和控制器 - DSP, DSC Dig Signal Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。