- 您現在的位置：買賣IC網 > PDF目錄379343 > SAF7846HL (NXP Semiconductors N.V.) One chip CD audio device with integrated MP3-WMA decoder PDF資料下載
參數資料
| 型號： | SAF7846HL |
| 廠商： | NXP Semiconductors N.V. |
| 元件分類： | 存儲器 |
| 英文描述： | One chip CD audio device with integrated MP3-WMA decoder |
| 封裝： | SAF7843HL/M295<SOT486-1 (LQFP144)|<<http://www.nxp.com/packages/SOT486-1.html<1<Always Pb-free,;SAF7849HL/M245<SOT486-1 (LQFP144)|<<http://www.nxp.com/packages/SOT486-1.h |
| 文件頁數： | 26/93頁 |
| 文件大小： | 396K |
| 代理商： | SAF7846HL |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁
SAF784X_2
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 02 — 9 May 2008
26 of 93
NXP Semiconductors
SAF784x
One chip CD audio device with integrated MP3/WMA decoder
correction range of
±
42 LSB steps (more than the whole ADC range). This offset
compensation (offset comp) value can be programmed via register OffsetComp, and will
be regulated in hardware as soon as the AOC is turned on.
The AOC will regulate the offset comp value such that the measured offset stays within a
window programmed by register OffsetBound. The offset comp value decreases if the
offset is above this window, and increases if the offset is below the window. If an inversion
occurs on the RF signal between analog and digital, the reaction of this loop can be
inverted by programming OffsetBound bit OFFSETINV.
The offset changes are not sent to the analog offset subtraction directly, but are integrated
over time. Only if, on average, an offset increase or decrease is requested, this will result
in a real offset increase or decrease of the analog addition. This can also be read back via
register OffsetComp. The AOC, together with the noise filter on the peak detector,
prevents RF noise causing over-sensitive offset regulation. To further reduce sensitive
behavior, a hysteresis window with a width of one offset step has been added between the
integrator and offset comp value. The bandwidth of the offset loop will determine how fast
it reacts to fingerprints and other defects; it is programmed via register OffsetIntegBW. It is
also possible to limit the range of the offset comp value by programming a maximum and
minimum boundary by register OffsetCompBoundHi and OffsetCompBoundLo.
AGC/AOC general and rules-of-thumb:
The AGC and AOC hardware regulation loops
can be enabled or disabled separately via register AGCAOCControl. This register also
allows the use of a ‘slow’ AGC and/or AOC loop. In this case the programmed loop
bandwidth is decreased with an extra factor of 128. In this mode the loops will be too slow
to react to defects, but can be used for a slow software-like gain and/or offset regulation to
regulate the average gain and offset over the disc comfortably within a specified range.
An important feature is the AGCAOCControl bit DISHOLDNOLOCK, which disables
holding of the AGC and AOC loops during defects (triggered by the defect detector, see
Section “Defect detector” on page 26
while the HF PLL is not in lock. This feature avoids
permanent lockups of the loops caused by a small amplitude triggering the defect
detector, which in return would hold the AGC loop.
The following things should be taken into account as general ‘rules-of-thumb’:
The amplitude thresholds should not be programmed too close to each other: allow at
least two gain steps (1.6 dB) from lower to higher boundary and vice versa to avoid an
over-sensitive AGC.
The offset boundary should not be programmed too tight:
±
8 is a good value to avoid
an over-sensitive AOC.
The bandwidth of the loops should never be programmed to be too wide (‘fast’) with
respect to the peak detector measurement window, to avoid an unstable loop. If the
PDwindow = 2
n
f
clk(sys)
(Hz) wide, the bandwidth of the loops should never be higher than
2
-(n+1)
(Hz).
Defect detector:
The defect detector detects the presence of black or white dots in the
RF stream, and freezes some signal conditioning and bit recovery logic during these
defects. This prevents the control loops inside this logic drifting away from their optimal
point of operation when there is no RF present, so that they can recover very fast when
good RF is present again.
相關PDF資料 |
PDF描述 |
|---|---|
| SAF7847HL | One chip CD audio device with integrated MP3-WMA decoder |
| SAF7849HL | One chip CD audio device with integrated MP3-WMA decoder |
| SB-015 | GMR Digital Sensor Evaluation Kit |
| SB10100F | ISOLATION SCHOTTKY BARRIER RECTIFIERS |
| SB1040F | ISOLATION SCHOTTKY BARRIER RECTIFIERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SAF7846HL/M210,557 | 功能描述:音頻 DSP 1 chip CD Audio Dev w/Integrated decoder RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| SAF7847HL/M201,557 | 功能描述:音頻 DSP 1 chip CD Audio Dev w/Integrated decoder RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| SAF7849HL/M245,557 | 功能描述:音頻 DSP IC AUD DECODER RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| SAF7849HL/M295,557 | 功能描述:音頻 DSP IC AUD DECODER RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| SAF7860HL/M2,557 | 制造商:NXP Semiconductors 功能描述:DSP |
發布緊急采購，3分鐘左右您將得到回復。