- 您現在的位置：買賣IC網 > PDF目錄368096 > PPC440EPx-NpAfffTs (Applied Micro Circuits Corp.) PowerPC 440EPx Embedded Processor PDF資料下載
參數資料
| 型號： | PPC440EPx-NpAfffTs |
| 廠商： | Applied Micro Circuits Corp. |
| 英文描述： | PowerPC 440EPx Embedded Processor |
| 中文描述： | 嵌入式處理器的PowerPC 440EPx |
| 文件頁數： | 91/94頁 |
| 文件大?。?/td> | 738K |
| 代理商： | PPC440EPX-NPAFFFTS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁當前第91頁第92頁第93頁第94頁
440EPx – PPC440EPx Embedded Processor
Revision 1.26 – October 15, 2007
Preliminary Data Sheet
AMCC Proprietary
91
Initialization
The PPC440EPx provides the option for setting initial parameters based on default values or by reading them from
a slave PROM attached to the IIC0 bus (see “Serial EEPROM” below). Some of the default values can be altered
by strapping on external pins (see “Strapping” below).
Strapping
While the SysReset input pin is low (system reset), the state of certain I/O pins is read to enable certain default
initial conditions prior to PPC440EPx start-up. The actual capture instant is the nearest reference clock edge
before the deassertion of reset. These pins must be strapped using external pull-up (logical 1) or pull-down
(logical 0) resistors to select the desired default conditions. These pins are used for strap functions only during
reset. Following reset they are used for normal functions. The signal names assigned to the pins for normal
operation are shown in parentheses following the pin number.
Note:
When UART0_DCD, UART0_DSR and UART0_CTS are used functionally, the pin straps should be isolated
from the UART transceiver during reset as the transceiver may overdrive the pin straps and cause the PPC440EPx
to read incorrect straps.
The following table lists the strapping pins along with their functions and strapping options:
Function
Option
Pin Strapping
C28
(UART0_DCD)
C29
(UART0_DSR)
A29
(UART0_CTS)
Serial device is disabled. Each of the six options (A–
F) is a combination of boot source, boot-source
width, and clock frequency specifications. Refer to
the IIC Bootstrap Controller chapter in the
PPC440EPx Embedded Processor User’s Manual
for details.
A
0
0
0
B
0
0
1
C
0
1
0
D
0
1
1
E
1
0
0
F
1
1
0
Serial device is enabled. The option being selected is
the IIC0 slave address that will respond with
strapping data.
G (0xA8)
1
0
1
H (0xA4)
1
1
1
Serial EEPROM
During reset, initial conditions other than those obtained from the strapping pins can be read from a ROM device
connected to the IIC0 port. At the de-assertion of reset, if the bootstrap controller is enabled, the PPC440EPx
sequentially reads 16 B from the ROM device on the IIC0 port and sets the SDR0_SDSTP0, SDR0_SDSTP1,
SDR0_SDSTP2 and SDR0_SDSTP3 registers accordingly.
The initialization settings and their default values are covered in detail in the
PowerPC 440EPx User’s Manual
.
Table 27. Strapping Pin Assignments
相關PDF資料 |
PDF描述 |
|---|---|
| PPC440EPx-SpAfffTs | PowerPC 440EPx Embedded Processor |
| PPC440EP | Power PC 440EP Embedded Processor |
| PPC440EP-3pbfffCx | Power PC 440EP Embedded Processor |
| PPC440GP-3CC333C | Power PC 440GP Embedded Processor |
| PPC440GP-3CC400C | Power PC 440GP Embedded Processor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PPC440EPX-NTA400E | 制造商:AMCC 功能描述:32 BIT POWERPC CORE, UP TO 667 MHZ, 2 10/100/1000 ETHERNET, - Trays |
| PPC440EPX-NTA400EZ | 制造商:AMCC 功能描述:32 BIT POWERPC CORE, UP TO 667 MHZ, 2 10/100/1000 ETHERNET, - Tape and Reel |
| PPC440EPX-NTA533E | 制造商:AMCC 功能描述:32 BIT POWERPC CORE, UP TO 667 MHZ, 2 10/100/1000 ETHERNET, - Trays |
| PPC440EPX-NTA533EZ | 制造商:AMCC 功能描述:32 BIT POWERPC CORE, UP TO 667 MHZ, 2 10/100/1000 ETHERNET, - Tape and Reel |
| PPC440EPX-NTA667E | 制造商:AMCC 功能描述:32 BIT POWERPC CORE, UP TO 667 MHZ, 2 10/100/1000 ETHERNET, - Trays |
發布緊急采購，3分鐘左右您將得到回復。