參數資料
型號: MSP34X1G
廠商: Electronic Theatre Controls, Inc.
英文描述: Multistandard Sound Processor Family with Virtual Dolby Surround
中文描述: 多標準聲音處理器系列與虛擬杜比環繞聲
文件頁數: 96/104頁
文件大?。?/td> 871K
代理商: MSP34X1G
MSP 34x1G
PRELIMINARY DATA SHEET
96
Micronas
6.4.4. NICAM Error Rate Register
Average error rate of the NICAM reception in a time
interval of 182 ms, which should be close to 0. The ini-
tial and maximum value of ERROR_RATE is 2047.
This value is also active if the NICAM bit of
MODE_REG is not set. Since the value is achieved by
filtering, a certain transition time (approx. 0.5 sec) is
unavoidable. Acceptable audio may have error rates
up to a value of 700 int. Individual evaluation of this
value by the controller and an appropriate threshold
may define the fallback mode from NICAM to FM/
AM-Mono in case of poor NICAM reception.
The bit error rate per second (BER) can be calculated
by means of the following formula:
BER = ERROR_RATE * 12.3*10
6
/s
6.4.5. PLL_CAPS Readback Register
It is possible to read out the actual setting of the
PLL_CAPS. In standard applications, this register is
not of interest for the customer.
6.4.6. AGC_GAIN Readback Register
It is possible to read out the actual setting of
AGC_GAIN in Automatic Gain Mode. In standard
applications, this register is not of interest for the cus-
tomer.
6.4.7. Automatic Search Function for FM-Carrier
Detection in Satellite Mode
The AM demodulation ability of the MSP 34x1G offers
the possibility to calculate the
field strength
of the
momentarily selected FM carrier, which can be read
out by the controller. In SAT receivers, this feature can
be used to make automatic FM carrier search possi-
ble.
For this, the MSP has to be switched to AM-mode
(MODE_REG[8]), FM-Prescale must be set to
7F
hex
=
+
127
dec
, and the FM DC notch (see section
6.5.7.)
must be switched off. The sound-IF frequency
range must now be
scanned
in the MSP-channel 2 by
means of the programmable quadrature mixer with an
appropriate incremental frequency (i.e. 10 kHz). After
each incrementation, a field strength value is available
at the quasi-peak detector output (quasi-peak detector
source must be set to FM), which must be examined
for relative maxima by the controller. This results in
either continuing search or switching the MSP back to
FM demodulation mode.
During the search process, the FIR2 must be loaded
with the coefficient set
AUTOSEARCH
, which
enables small bandwidth, resulting in appropriate field
strength characteristics. The absolute field strength
value (can be read out of
quasi-peak detector output
FM1
) also gives information on whether a main FM
carrier or a subcarrier was detected; and as a practical
consequence, the FM bandwidth (FIR1/2) and the
deemphasis (50
μ
s or adaptive) can be switched
accordingly.
Due to the fact that a constant demodulation frequency
offset of a few kHz leads to a DC level in the demodu-
lated signal, further fine tuning of the found carrier can
be achieved by evaluating the
DC Level Readout
FM1
. Therefore, the FM DC Notch must be switched
on, and the demodulator part must be switched back to
FM-demodulation mode.
For a detailed description of the automatic search
function, please refer to the corresponding MSP Win-
dows software.
ERROR_RATE
00 57
hex
Error free
0000
hex
maximum error rate
07FF
hex
PLL_CAPS
02 1F
hex
L
minimum frequency
1111 1111
FF
hex
nominal frequency
0101 0110
RESET
56
hex
maximum frequency
0000 0000
00
hex
PLL_CAPS
02 1F
hex
H
PLL open
xxxx xxx0
PLL closed
xxxx xxx1
AGC_GAIN
02 1E
hex
max. amplification
(20 dB)
0001 0100
14
hex
min. amplification
(3 dB)
0000 0000
00
hex
相關PDF資料
PDF描述
MSP600-3-K-5-N-1 NEW HIGH ACCURACY, DIGITALLY COMPENSATED EMI/RFI PROTECTED STAINLESS STEEL ISOLATED PRESSURE TRANSDUCER
MSP600-3-K-5-N-4 NEW HIGH ACCURACY, DIGITALLY COMPENSATED EMI/RFI PROTECTED STAINLESS STEEL ISOLATED PRESSURE TRANSDUCER
MSP600-3-P-3-N-1 NEW HIGH ACCURACY, DIGITALLY COMPENSATED EMI/RFI PROTECTED STAINLESS STEEL ISOLATED PRESSURE TRANSDUCER
MSP600-3-P-3-N-4 NEW HIGH ACCURACY, DIGITALLY COMPENSATED EMI/RFI PROTECTED STAINLESS STEEL ISOLATED PRESSURE TRANSDUCER
MSP600-3-P-4-N-1 NEW HIGH ACCURACY, DIGITALLY COMPENSATED EMI/RFI PROTECTED STAINLESS STEEL ISOLATED PRESSURE TRANSDUCER
相關代理商/技術參數
參數描述
MSP34X2G 制造商:MICRONAS 制造商全稱:MICRONAS 功能描述:Multistandard Sound Processor Family with Dolby Surround Pro Logic
MSP34X5G 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MSP 34x5G Multistandard Sound Processor Family
MSP34X7G 制造商:MICRONAS 制造商全稱:MICRONAS 功能描述:Multistandard Sound Processor Family
MSP3B10000FS14E3 功能描述:線繞電阻器 - SMD MSP 3 B 1K 1% BA100 e3 RoHS:否 制造商:Ohmite 電阻:4.99 Ohms 容差:1 % 功率額定值:2 W 外殼代碼 - in:4023 外殼代碼 - mm:10357 溫度系數:50 PPM / C 系列:RW2 工作溫度范圍:- 55 C to + 125 C 封裝:Bulk
MSP3B10000JS14E3 功能描述:線繞電阻器 - SMD MSP 3 B 1K 5% BA100 e3 RoHS:否 制造商:Ohmite 電阻:4.99 Ohms 容差:1 % 功率額定值:2 W 外殼代碼 - in:4023 外殼代碼 - mm:10357 溫度系數:50 PPM / C 系列:RW2 工作溫度范圍:- 55 C to + 125 C 封裝:Bulk