參數資料
型號: MSP34X1G
廠商: Electronic Theatre Controls, Inc.
英文描述: Multistandard Sound Processor Family with Virtual Dolby Surround
中文描述: 多標準聲音處理器系列與虛擬杜比環繞聲
文件頁數: 15/104頁
文件大?。?/td> 871K
代理商: MSP34X1G
PRELIMINARY DATA SHEET
MSP 34x1G
Micronas
15
2.6.3. Loudspeaker Requirements
The loudspeakers used and their positioning inside the
TV set will greatly influence the performance of the vir-
tualizer. The algorithm works with the direct sound
path. Reflected sound waves reduce the effect. So it
s
most important to have as much direct sound as possi-
ble, compared to indirect sound.
To obtain the approval for a TV set, Dolby Laboratories
require mounting the loudspeakers in front of the set.
Loudspeakers radiating to the side of the TV set will
not produce convincing effects. Good directionality of
the loudspeakers towards the listener is optimal.
The virtualizer was specially developed for implemen-
tation in TV sets. Even for rather small stereo TV's,
sufficient sound effects can be obtained. For small
sets, the loudspeaker placement should be to the side
of the CRT; for large screen sets (or 16:9 sets), mount-
ing the loudspeakers below the CRT is acceptable
(large separation is preferred, low frequency speakers
should be outmost to avoid cancellation effects). Using
external loudspeakers with a large stereo base will not
create optimal effects.
The loudspeakers should be able to reproduce a wide
frequency range. The most important frequency range
starts from 160 Hz and ranges up to 5 kHz.
Great care has to be taken with systems that use one
common subwoofer: A single loudspeaker cannot
reproduce virtual sound locations. The crossover fre-
quency must be lower than 120 Hz.
2.6.4. Cabinet Requirements
During listening tests at Dolby Laboratories,
no reso-
nances
in the cabinet should occur.
Good material to check for resonances are the Dolby
Trailers or other dynamic sound tracks.
2.7. SCART Signal Routing
2.7.1. SCART DSP In and SCART Out Select
The SCART DSP Input Select and SCART Output
Select blocks include full matrix switching facilities. To
design a TV set with four pairs of SCART-inputs and
two pairs of SCART-outputs, no external switching
hardware is required. The switches are controlled by
the ACB user register (see page 41).
2.7.2. Stand-by Mode
If the MSP 34x1G is switched off by first pulling
STANDBYQ low and then (after >1
μ
s delay) switching
off DVSUP and AVSUP, but keeping AHVSUP
(
Stand-by
-mode
), the SCART switches maintain
their position and function. This allows the copying
from SCART-input to SCART-output in the TV set
s
stand-by mode.
In case of power on or starting from stand-by (switch-
ing on the DVSUP and AVSUP, RESETQ going high
2 ms later), all internal registers except the ACB regis-
ter (page 41) are reset to the default configuration (see
Table 3
5 on page 20). The reset position of the ACB
register becomes active after the first I
2
C transmission
into the Baseband Processing part. By transmitting the
ACB register first, the reset state can be redefined.
相關PDF資料
PDF描述
MSP600-3-K-5-N-1 NEW HIGH ACCURACY, DIGITALLY COMPENSATED EMI/RFI PROTECTED STAINLESS STEEL ISOLATED PRESSURE TRANSDUCER
MSP600-3-K-5-N-4 NEW HIGH ACCURACY, DIGITALLY COMPENSATED EMI/RFI PROTECTED STAINLESS STEEL ISOLATED PRESSURE TRANSDUCER
MSP600-3-P-3-N-1 NEW HIGH ACCURACY, DIGITALLY COMPENSATED EMI/RFI PROTECTED STAINLESS STEEL ISOLATED PRESSURE TRANSDUCER
MSP600-3-P-3-N-4 NEW HIGH ACCURACY, DIGITALLY COMPENSATED EMI/RFI PROTECTED STAINLESS STEEL ISOLATED PRESSURE TRANSDUCER
MSP600-3-P-4-N-1 NEW HIGH ACCURACY, DIGITALLY COMPENSATED EMI/RFI PROTECTED STAINLESS STEEL ISOLATED PRESSURE TRANSDUCER
相關代理商/技術參數
參數描述
MSP34X2G 制造商:MICRONAS 制造商全稱:MICRONAS 功能描述:Multistandard Sound Processor Family with Dolby Surround Pro Logic
MSP34X5G 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MSP 34x5G Multistandard Sound Processor Family
MSP34X7G 制造商:MICRONAS 制造商全稱:MICRONAS 功能描述:Multistandard Sound Processor Family
MSP3B10000FS14E3 功能描述:線繞電阻器 - SMD MSP 3 B 1K 1% BA100 e3 RoHS:否 制造商:Ohmite 電阻:4.99 Ohms 容差:1 % 功率額定值:2 W 外殼代碼 - in:4023 外殼代碼 - mm:10357 溫度系數:50 PPM / C 系列:RW2 工作溫度范圍:- 55 C to + 125 C 封裝:Bulk
MSP3B10000JS14E3 功能描述:線繞電阻器 - SMD MSP 3 B 1K 5% BA100 e3 RoHS:否 制造商:Ohmite 電阻:4.99 Ohms 容差:1 % 功率額定值:2 W 外殼代碼 - in:4023 外殼代碼 - mm:10357 溫度系數:50 PPM / C 系列:RW2 工作溫度范圍:- 55 C to + 125 C 封裝:Bulk