228
SAM9G45 [DATASHEET]
6438K–ATARM–12-Feb-13
22.4
Initialization Sequence
The addresses given are for example purposes only. The real address depends on implementation in the product.
22.4.1
SDR-SDRAM Initialization
The initialization sequence is generated by software. The SDR-SDRAM devices are initialized by the following
sequence:
1.
2.
Program the features of the SDR-SDRAM device into the Timing Register (asynchronous timing (trc, tras,
etc.)), and into the Configuration Register (number of columns, rows, cas latency) (see
Section 22.8.3 on3.
For low-power SDRAM, temperature-compensated self refresh (TCSR), drive strength (DS) and partial
A minimum pause of 200 μs is provided to precede any signal toggle.
4.
A NOP command is issued to the SDR-SDRAM. Program NOP command into Mode Register, the appli-
to any SDR-SDRAM address to acknowledge this command. Now the clock which drives SDR-SDRAM
device is enabled.
5.
An all banks precharge command is issued to the SDR-SDRAM. Program all banks precharge command
254). Perform a write access to any SDR-SDRAM address to acknowledge this command.
6.
Eight auto-refresh (CBR) cycles are provided. Program the auto refresh command (CBR) into Mode Reg-
a write access to any SDR-SDRAM location eight times to acknowledge these commands.
7.
A Mode Register set (MRS) cycle is issued to program the parameters of the SDR-SDRAM devices, in
particular CAS latency and burst length. The application must set Mode to 3 in the Mode Register (see
mand. The write address must be chosen so that BA[1:0] are set to 0. For example, with a 16-bit 128 MB
SDR-SDRAM (12 rows, 9 columns, 4 banks) bank address, the SDRAM write access should be done at
the address 0x20000000.
Note:
This address is for example purposes only. The real address is dependent on implementation in the product.
8.
For low-power SDR-SDRAM initialization, an Extended Mode Register set (EMRS) cycle is issued to pro-
gram the SDR-SDRAM parameters (TCSR, PASR, DS). The application must set Mode to 5 in the Mode
edge this command. The write address must be chosen so that BA[1] is set to 1 and BA[0] is set to 0. For
example, with a 16-bit 128 MB SDRAM, (12 rows, 9 columns, 4 banks) bank address the SDRAM write
access should be done at the address 0x20800000.
9.
The application must go into Normal Mode, setting Mode to 0 in the Mode Register (see
Section 22.8.1 onpage 254) and perform a write access at any location in the SDRAM to acknowledge this command.
10. Write the refresh rate into the count field in the DDRSDRC Refresh Timer register (see
page 255).
(Refresh rate = delay between refresh cycles). The SDR-SDRAM device requires a refresh every 15.625
μs or 7.81 μs. With a 100 MHz frequency, the refresh timer count register must to be set with (15.625*100
MHz) = 1562 i.e. 0x061A or (7.81*100 MHz) = 781 i.e. 0x030d
After initialization, the SDR-SDRAM device is fully functional.