- 您現在的位置：買賣IC網 > PDF目錄11205 > MB91F267APMC-GE1 (Fujitsu Semiconductor America Inc)IC MCU FLASH 128KB FLASH 64LQFP PDF資料下載
參數資料
| 型號： | MB91F267APMC-GE1 |
| 廠商： | Fujitsu Semiconductor America Inc |
| 文件頁數： | 22/53頁 |
| 文件大小： | 0K |
| 描述： | IC MCU FLASH 128KB FLASH 64LQFP |
| 標準包裝： | 1 |
| 系列： | FR MB91265A |
| 核心處理器： | FR60Lite RISC |
| 芯體尺寸： | 32-位 |
| 速度： | 33MHz |
| 連通性： | UART/USART |
| 外圍設備： | DMA，WDT |
| 輸入/輸出數： | 49 |
| 程序存儲器容量： | 128KB（128K x 8） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 4K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 4 V ~ 5.5 V |
| 數據轉換器： | A/D 11x8/10b |
| 振蕩器型： | 外部 |
| 工作溫度： | -40°C ~ 105°C |
| 封裝/外殼： | 64-LQFP |
| 包裝： | 托盤 |
| 其它名稱： | 865-1092 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁
31
8183F–AVR–06/12
ATtiny24A/44A/84A
6.5
Register Description
6.5.1
OSCCAL – Oscillator Calibration Register
Bits 7:0 – CAL[7:0]: Oscillator Calibration Value
The Oscillator Calibration Register is used to trim the Calibrated Internal RC Oscillator to
remove process variations from the oscillator frequency. A pre-programmed calibration value is
automatically written to this register during chip reset, giving the Factory calibrated frequency as
specified in Table 20-2 on page 175. The application software can write this register to change
the oscillator frequency. The oscillator can be calibrated to frequencies as specified in Table 20-
2 on page 175. Calibration outside that range is not guaranteed.
Note that this oscillator is used to time EEPROM and Flash write accesses, and these write
times will be affected accordingly. If the EEPROM or Flash are written, do not calibrate to more
than 8.8 MHz. Otherwise, the EEPROM or Flash write may fail.
The CAL7 bit determines the range of operation for the oscillator. Setting this bit to 0 gives the
lowest frequency range, setting this bit to 1 gives the highest frequency range. The two fre-
quency ranges are overlapping, in other words a setting of OSCCAL = 0x7F gives a higher
frequency than OSCCAL = 0x80.
The CAL[6:0] bits are used to tune the frequency within the selected range. A setting of 0x00
gives the lowest frequency in that range, and a setting of 0x7F gives the highest frequency in the
range. See “Calibrated 8 MHz RC Oscillator Frequency vs. OSCCAL Value” on page 238 for typ-
ical frequencies.
To ensure stable operation of the MCU the calibration value should be changed in small. A vari-
ation in frequency of more than 2% from one cycle to the next can lead to unpredicatble
behavior. Changes in OSCCAL should not exceed 0x20 for each calibration. It is required to
ensure that the MCU is kept in Reset during such changes in the clock frequency.
6.5.2
CLKPR – Clock Prescale Register
Bit 7 – CLKPCE: Clock Prescaler Change Enable
The CLKPCE bit must be written to logic one to enable change of the CLKPS bits. The CLKPCE
bit is only updated when the other bits in CLKPR are simultaniosly written to zero. CLKPCE is
cleared by hardware four cycles after it is written or when the CLKPS bits are written. Rewriting
the CLKPCE bit within this time-out period does neither extend the time-out period, nor clear the
CLKPCE bit.
Bits 6:4 – Res: Reserved Bits
These bits are reserved in the ATtiny24A/44A/84A and will always read as zero.
Bit
765
432
10
CAL7
CAL6
CAL5
CAL4
CAL3
CAL2
CAL1
CAL0
OSCCAL
Read/Write
R/W
Initial Value
Device Specific Calibration Value
Bit
7
6
5
4
32
10
CLKPCE
–
CLKPS3
CLKPS2
CLKPS1
CLKPS0
CLKPR
Read/Write
R/W
R
R/W
Initial Value
0
See Bit Description
相關PDF資料 |
PDF描述 |
|---|---|
| ADUC7034BCPZ-RL | IC MCU FLASH 32K ANLG IO 48LFCSP |
| ADUC7126BSTZ126IRL | IC MCU 16/32B 126KB FLASH 80LQFP |
| AT91SAM7S256C-MU-999 | IC MCU ARM7 256KB FLASH 64-VQFN |
| AT90USB1287-MUR | MCU AVR 128K FLASH 16MHZ 64QFN |
| AT90USB1287-AUR | MCU AVR 128K FLASH 16MHZ 64TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB91F267APMC-GS | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Proprietary Microcontrollers |
| MB91F267APMC-GSE1 | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Proprietary Microcontrollers |
| MB91F267N | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Proprietary Microcontroller |
| MB91F267NA | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Proprietary Microcontrollers |
| MB91F267NAPMC-G | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Proprietary Microcontrollers |
發布緊急采購，3分鐘左右您將得到回復。