- 您現在的位置：買賣IC網 > PDF目錄11205 > MB91F267APMC-GE1 (Fujitsu Semiconductor America Inc)IC MCU FLASH 128KB FLASH 64LQFP PDF資料下載
參數資料
| 型號： | MB91F267APMC-GE1 |
| 廠商： | Fujitsu Semiconductor America Inc |
| 文件頁數： | 21/53頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MCU FLASH 128KB FLASH 64LQFP |
| 標準包裝： | 1 |
| 系列： | FR MB91265A |
| 核心處理器： | FR60Lite RISC |
| 芯體尺寸： | 32-位 |
| 速度： | 33MHz |
| 連通性： | UART/USART |
| 外圍設備： | DMA，WDT |
| 輸入/輸出數： | 49 |
| 程序存儲器容量： | 128KB（128K x 8） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 4K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 4 V ~ 5.5 V |
| 數據轉換器： | A/D 11x8/10b |
| 振蕩器型： | 外部 |
| 工作溫度： | -40°C ~ 105°C |
| 封裝/外殼： | 64-LQFP |
| 包裝： | 托盤 |
| 其它名稱： | 865-1092 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁
30
8183F–AVR–06/12
ATtiny24A/44A/84A
6.2.6
Default Clock Source
The device is shipped with CKSEL = “0010”, SUT = “10”, and CKDIV8 programmed. The default
clock source setting is therefore the Internal Oscillator running at 8.0 MHz with longest start-up
time and an initial system clock prescaling of 8, resulting in 1.0 MHz system clock. This default
setting ensures that all users can make their desired clock source setting using an in-system or
high-voltage programmer.
At low voltages (below 2.7V), it should be noted that unprogramming the CKDIV8 fuse may
result in overclocking. At low voltages the devices are rated for maximum 4 MHz operation (see
Section 20.3 on page 174), but routing the clock signal from the internal oscillator directly to the
system clock line will run the device at 8 MHz.
6.3
System Clock Prescaler
The ATtiny24A/44A/84A system clock can be divided by setting the “CLKPR – Clock Prescale
Register” on page 31. This feature can be used to decrease power consumption when the
requirement for processing power is low. This can be used with all clock source options, and it
will affect the clock frequency of the CPU and all synchronous peripherals. clk
I/O, clkADC, clkCPU,
and clk
FLASH are divided by a factor as shown in Table 6-11 on page 32.
6.3.1
Switching Time
When switching between prescaler settings, the System Clock Prescaler ensures that no
glitches occur in the clock system and that no intermediate frequency is higher than neither the
clock frequency corresponding to the previous setting, nor the clock frequency corresponding to
the new setting.
The ripple counter that implements the prescaler runs at the frequency of the undivided clock,
which may be faster than the CPU’s clock frequency. Hence, it is not possible to determine the
state of the prescaler – even if it were readable, and the exact time it takes to switch from one
clock division to another cannot be exactly predicted.
From the time the CLKPS values are written, it takes between T1 + T2 and T1 + 2*T2 before the
new clock frequency is active. In this interval, 2 active clock edges are produced. Here, T1 is the
previous clock period, and T2 is the period corresponding to the new prescaler setting.
6.4
Clock Output Buffer
The device can output the system clock on the CKOUT pin. To enable the output, the CKOUT
fuse has to be programmed. This mode is suitable when the chip clock is used to drive other cir-
cuits on the system. Note that the clock will not be output during reset and that the normal
operation of the I/O pin will be overridden when the fuse is programmed. Any clock source,
including the internal RC Oscillator, can be selected when the clock is output on CKOUT. If the
System Clock Prescaler is used, it is the divided system clock that is output.
相關PDF資料 |
PDF描述 |
|---|---|
| ADUC7034BCPZ-RL | IC MCU FLASH 32K ANLG IO 48LFCSP |
| ADUC7126BSTZ126IRL | IC MCU 16/32B 126KB FLASH 80LQFP |
| AT91SAM7S256C-MU-999 | IC MCU ARM7 256KB FLASH 64-VQFN |
| AT90USB1287-MUR | MCU AVR 128K FLASH 16MHZ 64QFN |
| AT90USB1287-AUR | MCU AVR 128K FLASH 16MHZ 64TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB91F267APMC-GS | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Proprietary Microcontrollers |
| MB91F267APMC-GSE1 | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Proprietary Microcontrollers |
| MB91F267N | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Proprietary Microcontroller |
| MB91F267NA | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Proprietary Microcontrollers |
| MB91F267NAPMC-G | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Proprietary Microcontrollers |
發布緊急采購，3分鐘左右您將得到回復。