- 您現在的位置：買賣IC網 > PDF目錄383236 > L6256 (意法半導體) 12V COMBO PDF資料下載
參數資料
| 型號： | L6256 |
| 廠商： | 意法半導體 |
| 英文描述： | 12V COMBO |
| 中文描述： | 12V的組合 |
| 文件頁數： | 7/28頁 |
| 文件大?。?/td> | 258K |
| 代理商： | L6256 |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
SATURATED SEEK BIT
The processor can command the VCM amplifiers
to hard saturate, in the polarity determined by the
sign bit of the DAC. The saturation detector bit is
not the echo of this bit, but is a separate compa-
rator bit representing the true state of the ampli-
fier. Thus, it can be used for loopback testing of
the DOLPHIN.
VCM CURRENT SENSE AMPLIFIER
The input differential voltage of the amplifier can
be limited to low voltage, but common mode re-
jection is very high. The amplifier is capable of
operating smoothly when the VCM amplifiers are
saturated, providing no input charge buildup or
other anomalies. Charge does not build up on
the inputs even when VCM inductance forces the
inputs substantially above the supply or below
ground.
SATURATION DETECTOR
This detector notifies the processor when the
commanded VCM current does not match the ac-
tual VCM current. The threshold is set by
VC_Sat.
Fault Detection
UV DETECTION
The power supply undervoltage protection is set
up for the appropriate tolerances, and causes a
low signal on POR\. A small hysteresis is in-
cluded on the voltage comparators, and band-
width limiting techniques are used. Current limit
from the 3.3V regulator has been added to the
POR error inputs.
POWER ON RESET (see appendix B)
The power on reset circuit provides the following
functions:
●
A retriggerable one shot of several millisec-
onds.
●
An interlock circuit which provides for dis-
charge of the one shot, and a clamp to hold
the POR\ line low during the timing interval.
●
Circuitry to pull POR\ high quickly after the 1
shot has timed out.
●
A current source or weak pullup to pull the
POR\ line high against external leakage cur-
rents.
Undervoltage conditions override external inputs
and force POR\ low. External inputs do not cause
pulse stretching; all internal inputs do.
PCBA in-circuit testing can arbitrarily pull this line
low as necessary to restart the system. Alter-
nately, a 1 milliamp current can be introduced to
the timing capacitor to speed up the POR timeout.
THERMAL LIMIT
The thermal limit of the chip is set for
THlimit
with
THhyst
degrees of hysteresis. Thermal limit is a
relative voltage, above
Thwarn
for tolerance rea-
sons, and must protect the part; it indicates that
thermal limit is taking place by disabling the serial
port (see serial port section). A park and a spin-
dle driver tristate is performed when thermal limit
occurs.
THERMAL WARNING
Thermal warning is made available to the proces-
sor as a status bit in every register, to allow a
modified control algorithm strategy that reduces
power dissipation and drops chip temperature.
PARK CIRCUIT
The park circuit provides smooth head retraction.
In Park, the VCM is switched to voltage mode.
Bout
is grounded. The A amplifier’s positive in-
put is switched from the normal half supply refer-
ence down to
Vpark
, and
Aout
applies the volt-
age determined by
Vpark
and
Rp1
and
Rp2
. This
damps any motion that may been in progress and
causes the head to retract into the latch.
L6256
7/28
相關PDF資料 |
PDF描述 |
|---|---|
| L6258E | PWM CONTROLLED - HIGH CURRENT DMOS UNIVERSAL MOTOR DRIVER |
| L6258EX | PWM CONTROLLED - HIGH CURRENT DMOS UNIVERSAL MOTOR DRIVER |
| L6260 | 4.5 - 5.5V DISK DRIVER SPINDLE & VCM, POWER & CONTROL COMBO’S |
| L6268 | 12V DISK DRIVE SPINDLE & VCM, POWER & CONTROL “COMBO” |
| L6269 | 12V DISK DRIVE SPINDLE & VCM, POWER & CONTROL “COMBO” |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L6258 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:PWM controlled high current DMOS universal motor driver |
| L6258_07 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:PWM controlled high current DMOS universal motor driver |
| L6258A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Stepper Motor Controller/Driver |
| L6258E | 功能描述:馬達/運動/點火控制器和驅動器 Dual Full Bridge RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| L6258E_07 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:PWM controlled high current DMOS universal motor driver |
發布緊急采購，3分鐘左右您將得到回復。