參數資料
型號： ISP1761BE,551
廠商： NXP SEMICONDUCTORS
元件分類： 總線控制器
英文描述： UNIVERSAL SERIAL BUS CONTROLLER, PQFP128
封裝： 14 X 20 MM, 1.40 MM HEIGHT, PLASTIC, MS-026, SOT425-1, LQFP-128
文件頁數： 82/164頁
文件大?。?/td> 767K
代理商： ISP1761BE,551
ISP1761_5
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 05 — 13 March 2008
23 of 163
NXP Semiconductors
ISP1761
Hi-Speed USB OTG controller
3. Dene the IRQ polarity as active LOW or active HIGH in INTR_POL (bit 2) of the HW
Mode Control register. These settings must match IRQ settings of the host processor.
By default, interrupt is level-triggered and active LOW.
4. Program the individual Interrupt Enable bits in the HcInterruptEnable register. The
software will need to clear the Interrupt Status bits in the HcInterrupt register before
enabling individual interrupt enable bits.
Additional IRQ characteristics can be adjusted in the Edge Interrupt Count register, as
necessary, applicable only when IRQ is set to be edge-active; a pulse of a dened width is
generated every time IRQ is active.
Bits 15 to 0 of the Edge Interrupt Count register dene the IRQ pulse width. The maximum
pulse width that can be programmed is FFFFh, corresponding to a 1 ms pulse width. This
setting is necessary for certain processors that may require a different minimum IRQ
pulse width from the default value. The default IRQ pulse width set at power-on is
approximately 500 ns.
Bits 31 to 24 of the Edge Interrupt Count register dene the minimum interval between two
interrupts to avoid frequent interrupts to the CPU. The default value of 00h attributed to
these bits determines the normal IRQ generation, without any delay. When a delay is
programmed and the IRQ becomes active after the respective delay, several IRQ events
may have already occurred.
All the interrupt events are represented by the respective bits allocated in the HcInterrupt
register. There is no mechanism to show the order or the moment occurrence of an
interrupt.
The asserted bits in the HcInterrupt register can be cleared by writing back the same
value to the HcInterrupt register. This means that writing logic 1 to each of the set bits will
reset that corresponding bits to the initial inactive state.
The IRQ generation rules that apply according to the preceding settings are:
If an event of interrupt occurs but the respective bit in the Interrupt Enable register is
not set, then the respective HcInterrupt register bit is set but the interrupt signal is not
asserted.
An interrupt will be generated when interrupt is enabled and the respective bit in the
Interrupt Enable register is set.
For a level trigger, an interrupt signal remains asserted until the processor clears the
HcInterrupt register by writing logic 1 to clear the HcInterrupt register bits that are set.
If an interrupt is made edge-sensitive and is asserted, writing to clear the HcInterrupt
register will not have any effect because the interrupt will be asserted for a prescribed
amount of clock cycles.
The clock stopping mechanism does not affect the generation of an interrupt. This is
useful during the suspend and resume cycles, when an interrupt is generated to
signal a wake-up event.
The IRQ generation can also be conditioned by programming the IRQ Mask OR and IRQ
Mask AND registers.
相關PDF資料
PDF描述
ISP1761BE,518 UNIVERSAL SERIAL BUS CONTROLLER, PQFP128
ITR8307 SPECIALTY OPTOELECTRONIC DEVICE
IXF1010 10 CHANNEL(S), 1000M bps, LOCAL AREA NETWORK CONTROLLER, CBGA552
JANTX1N3595US-1 0.15 A, SILICON, SIGNAL DIODE
JAN1N3595US-1 0.15 A, SILICON, SIGNAL DIODE
相關代理商/技術參數
參數描述
ISP1761BEGE 功能描述:IC USB CTRL HI-SPEED 128LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A
ISP1761BE-S 功能描述:IC USB CONTROLLER 128LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A
ISP1761BE-T 功能描述:USB 接口集成電路 USB HS OTG CNTROLLER RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1761BEUM 功能描述:IC USB OTG CONTROLLER HS 128LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A
ISP1761ET 功能描述:USB 接口集成電路 USB 2.0 HS OTG HOST RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*