參數資料
型號： IDT5V9885TNLGI
廠商： IDT, Integrated Device Technology Inc
文件頁數： 38/39頁
文件大?。?/td> 0K
描述： IC CLOCK GEN PLL 500MHZ 28VFQFPN
標準包裝： 490
類型： *
PLL： 帶旁路
輸入： LVCMOS，LVTTL
輸出： LVCMOS，LVDS，LVPECL，LVTTL
電路數： 1
比率 - 輸入:輸出： 2:6
差分 - 輸入:輸出： 無/是
頻率 - 最大： 500MHz
除法器/乘法器： 是/無
電源電壓： 3 V ~ 3.6 V
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 28-VFQFN 裸露焊盤
供應商設備封裝： 28-VFQFPN（6x6）
包裝： 托盤
其它名稱： 800-2580
8
INDUSTRIALTEMPERATURERANGE
IDT5V9885T
3.3V EEPROMPROGRAMMABLECLOCKGENERATOR
Note that the actual 10-bit post-divider value has a 2 added to the integer value Q and the outputs are routed through another div/2 block. The post-divider
should never be disabled unless the output bank will never be used during normal operation. The output frequency range for LVTTL outputs are from 4.9KHz
to 200MHz. The output frequency range for LVPECL/LVDS outputs are from 4.9KHz to 500MHz.
SPREAD SPECTRUM GENERATION
PLL0 and PLL1 support spread spectrum generation capability, which users have the option of turning on and off. Spread spectrum profile, frequency, and
spread are fully programmable (within limits). The programmable spread spectrum generation parameters are TSSC[3:0], NSSC[3:0], SS_OFFSET[5:0],
SD[3:0], DITH, and X2 bits. These bits are in the memory address range of 0x60 to 0x67 for PLL0 and 0x68 to 0x6F for PLL1. The spread spectrum generation
on PLL0 & PLL1 can be enabled/disabled using the TSSC[3:0] bits. To enable spread spectrum, set TSSC > '0' and set NSSC, SD[3:0], SD[5:0], and the
A[3:0] in the total M value accordingly. And to disable, set TSSC = '0'.
TSSC[3:0]
These bits are used to determine the number of phase/frequency detector cycles per spread spectrum cycle (ssc) steps. The modulation frequency can be
calculated with the TSSC bits in conjunction with the NSSC bits. Valid TSSC integer values for the modulation frequency range from 5 to 14.
NSSC[3:0]
These bits are used to determine the number of delta-encoded samples used for a single quadrant of the spread spectrum waveform. All four quadrants
of the spread spectrum waveform are mirror images of each other. The modulation frequency is also calculated based off the NSSC bits in conjunction with the
TSSC bits. Valid NSSC integer values range from 1 to 6.
SS_OFFSET[5:0]
These bits are used to program the fractional offset with respect to the nominal M integer value. For center spread, the SS_OFFSET should be set to '0' so
the spread spectrum waveform is about the nominal M (Mnom) value. For down spread, the SS_OFFSET > '0' so the spread spectrum wavform is about the
(Mideal-1=Mnom)value. Thedownspreadpercentagecanbethoughtofintermsofcenterspread. Forexample,adownspreadof-1%canalsobeconsidered
as a center spread of ±0.5% but with Mnom shifted down by one and offset. The SS_OFFSET has integer values ranging from 0 to 63.
SD[3:0]
These bits are used to shape the profile of the spread spectrum waveform. These are delta-encoded samples of the waveform. There are twelve sets of
SD samples for each PLL. The NSSC bits determine how many of these samples are used for the waveform. The sum of these delta-encoded samples (sigma-
delta-encoded samples) determine the amount of spread and should not exceed (63 - SS_OFFSET). The maximum spread is inversely proportional to the
nominal M integer value.
DITH
This bit is for dithering the sigma-delta-encoded samples. This will randomize the least-significant bit of the input to the spread spectrum modulator. Set the
bit to '1' to enable dithering.
X2
This bit will double the total value of the sigma-delta-encoded-samples which will increase the amplitude of the spread spectrum waveform by a factor of two.
When X2 is '0', the amplitude remains nominal but if set to '1', the amplitude is increased by x2.
The following equations govern how the spread spectrum is set:
TSSC = TSSC[3:0] + 2
(Eq. 7)
NSSC = NSSC[3:0] * 2
(Eq. 8)
SD[3:0]K = SJ+1(unencoded) - SJ(unencoded)
(Eq. 9)
where SJis the unencoded sample out of a possible 12 and SDK is the delta-encoded sample out of a possible 12.
Amplitude = (2*N[11:0] + A[3:0] + 1) * Spread% / 100
(Eq. 10)
2
if 1 < Amp < 2, then set X2 bit to '1'.
相關PDF資料
PDF描述
X9251TS24Z-2.7 IC XDCP QUAD 256TAP 100K 24-SOIC
X9268US24IZ IC XDCP DUAL 256TAP 50K 24-SOIC
X9268TS24IZ IC XDCP DUAL 256TAP 100K 24-SOIC
ICS87949AYILF IC CLK GENERATOR /1 /2 52-LQFP
VI-26V-MW CONVERTER MOD DC/DC 5.8V 100W
相關代理商/技術參數
參數描述
IDT5V9885TNLGI8 制造商:Integrated Device Technology Inc 功能描述:IC CLOCK GEN PLL 500MHZ 28VFQFPN
IDT5V9885TPFGI 功能描述:IC CLOCK GEN PLL 500MHZ 32TQFP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:2,000 系列:- 類型:PLL 頻率合成器 PLL:是 輸入:晶體 輸出:時鐘 電路數:1 比率 - 輸入:輸出:1:1 差分 - 輸入:輸出:無/無 頻率 - 最大:1GHz 除法器/乘法器:是/無 電源電壓:4.5 V ~ 5.5 V 工作溫度:-20°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-LSSOP（0.175"，4.40mm 寬） 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:NJW1504V-TE1-NDNJW1504V-TE1TR
IDT5V9885TPFGI8 制造商:Integrated Device Technology Inc 功能描述:IC CLOCK GEN PLL 500MHZ 32TQFP
IDT5V9888NLGI 功能描述:IC CLK GEN 3.3V EEPROM 28-VFQFPN RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:39 系列:- 類型:* PLL:帶旁路 輸入:時鐘 輸出:時鐘 電路數:1 比率 - 輸入:輸出:1:10 差分 - 輸入:輸出:是/是 頻率 - 最大:170MHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:*
IDT5V9888NLGI8 功能描述:IC CLK GEN 3.3V EEPROM 28-VFQFPN RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:39 系列:- 類型:* PLL:帶旁路 輸入:時鐘 輸出:時鐘 電路數:1 比率 - 輸入:輸出:1:10 差分 - 輸入:輸出:是/是 頻率 - 最大:170MHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:*
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*