- 您現在的位置：買賣IC網 > PDF目錄9227 > ADF4360-9BCPZRL7 (Analog Devices Inc)IC SYNTHESIZER W/ADJ VCO 24LFCSP PDF資料下載
參數資料
| 型號： | ADF4360-9BCPZRL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 16/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SYNTHESIZER W/ADJ VCO 24LFCSP |
| 標準包裝： | 1 |
| 類型： | 扇出配送，整數-N，合成器（RF） |
| PLL： | 是 |
| 輸入： | CMOS |
| 輸出： | 時鐘 |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 1:2 |
| 差分 - 輸入:輸出： | 無/無 |
| 頻率 - 最大： | 400MHz |
| 除法器/乘法器： | 是/無 |
| 電源電壓： | 3 V ~ 3.6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 24-LFCSP-VQ（4x4） |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 551 (CN2011-ZH PDF) |
| 其它名稱： | ADF4360-9BCPZRL7DKR |
Data Sheet
ADF4360-9
Rev. C | Page 23 of 24
OUTPUT MATCHING
There are a number of ways to match the VCO output of the
ADF4360-9 for optimum operation; the most basic is to use a
51 resistor to VVCO. A dc bypass capacitor of 100 pF is connected
in series, as shown in Figure 33. Because the resistor is not
frequency dependent, this provides a good broadband match.
The output power in the circuit in Figure 33 typically gives
9 dBm output power into a 50 load.
100pF
07139-
030
RFOUT
VVCO
50
51
Figure 33. Simple Output Stage
A better solution is to use a shunt inductor (acting as an RF
choke) to VVCO. This gives a better match and, therefore, more
output power.
Experiments have shown that the circuit shown in Figure 34
provides an excellent match to 50 over the operating range of
the ADF4360-9. This gives approximately 0 dBm output power
across the specific frequency range of the ADF4360-9 using the
recommended shunt inductor, followed by a 100 pF dc-blocking
capacitor.
L
100pF
07139-
031
RFOUT
VVCO
50
Figure 34. Optimum Output Stage
The recommended value of this inductor changes with the VCO
center frequency. Figure 35 shows a graph of the optimum
inductor value vs. center frequency.
CENTER FREQUENCY (MHz)
INDUC
T
ANCE
(
n
H)
300
250
150
200
100
0
50
0
100
200
300
500
400
07139-
032
Figure 35. Optimum Shunt Inductor vs. Center Frequency
Both complementary architectures can be examined using the
EV-ADF4360-9EB1Z evaluation board. If the user does not
need the differential outputs available on the ADF4360-9, the
user should either terminate the unused output with the same
circuitry as much as possible or combine both outputs using a
balun. Alternatively, instead of the LC balun, both outputs can
be combined using a 180° rat-race coupler.
If the user is only using DIVOUT and does not use the RF
outputs, it is still necessary to terminate both RF output pins
with a shunt inductor/resistor to VVCO and also a dc bypass
capacitor and a 50 load. The circuit in Figure 33 is probably
the simplest and most cost-effective solution. It is important
that the load on each pin be balanced because an unbalanced
load is likely to cause stability problems. Terminations should
be identical as much as possible.
相關PDF資料 |
PDF描述 |
|---|---|
| X9317WV8Z-2.7T1 | IC XDCP SGL 100TAP 10K 8-TSSOP |
| X9317WM8Z-2.7T1 | IC XDCP SGL 100TAP 10K 8-MSOP |
| X9429WS16IZ-2.7T1 | IC POT DGTL SGL 10K OHM 16-SOIC |
| M83723/76A20288 | CONN PLUG 28POS STRAIGHT W/PINS |
| X9418WS24ZT1 | IC XDCP DUAL 64TAP 10K 24-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADF4360-EVAL | 制造商:Analog Devices 功能描述:INTEGRATED SYNTHESIZER AND VCO - Trays |
| ADF4602 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Single-Chip, Multiband 3G Femtocell Transceiver |
| ADF4602-1XCPZ | 制造商:Analog Devices 功能描述:SINGLE-CHIP, MULTIBAND 3G FEMTOCELL TRANSCEIVER - Rail/Tube |
| ADF4602-1XCPZ-RL | 制造商:Analog Devices 功能描述: |
| ADF4602BCPZ | 制造商:Analog Devices 功能描述:RF Transceiver 3.3V 40-Pin LFCSP EP 制造商:Analog Devices 功能描述:ADF4602: SINGLE-CHIP, MULTIBAND 3G FEMTOCELL TRANSCEIVER - Trays |
發布緊急采購，3分鐘左右您將得到回復。