參數資料
型號: AD1846JP
廠商: ANALOG DEVICES INC
元件分類: 消費家電
英文描述: Low Cost Parallel-Port 16-Bit SoundPort Stereo Codec
中文描述: SPECIALTY CONSUMER CIRCUIT, PQCC68
封裝: PLASTIC, LCC-68
文件頁數: 9/28頁
文件大?。?/td> 277K
代理商: AD1846JP
AD1846
REV. A
–9–
(Continued from page 1)
8
7
4
2
4
5
DIR
G
AEN
SA19:2
SA1
SA0
IOWC
IORC
DATA7:0
ADDRESS
DECODE
DRQ<X>
DRQ<Y>
DAK<X>
DAK<Y>
IRQ<Z>
A
B
ISA BUS
8
18
CS
A1
A0
WR
RD
DATA7:0
DBDIR
DBEN
PDRQ
CDRQ
PDAK
CDAK
INT
AD1846
Figure 1. Interface to ISA Bus
T he pair of 16-bit outputs from the ADCs is available over a
byte-wide bidirectional interface that also supports 16-bit digital
input to the DACs and control information. T he AD1846 can
accept and generate 16-bit twos-complement PCM linear digital
data, 8-bit unsigned magnitude PCM linear data, and 8-bit
μ
-law or A-law companded digital data.
T he
DACs are preceded by a digital interpolation filter. An
attenuator provides independent user volume control over each
DAC channel. Nyquist images and shaped quantization noise
are removed from the DACs’ analog stereo output by on-chip
switched-capacitor and continuous-time filters. T wo stereo pairs
of auxiliary line-level inputs can also be mixed in the analog do-
main with the DAC output.
AUDIO FUNCT IONAL DE SCRIPT ION
T his section overviews the functionality of the AD1846 and is
intended as a general introduction to the capabilities of the de-
vice. As much as possible, detailed reference information has
been placed in “Control Registers” and other sections. T he user
is not expected to refer repeatedly to this section.
Analog Inputs
T he AD1846 SoundPort Stereo Codec accepts stereo line-level
and mic-level inputs. LINE, MIC, and AUX 1 inputs and post-
mixed DAC output analog stereo signals are multiplexed to the
internal programmable gain amplifier (PGA) stage.
T he PGA following the input multiplexer allows independent
selectable gains for each channel from 0 to 22.5 dB in +1.5 dB
steps. T he Codec can operate either in a global stereo mode or
in a global mono mode with left channel inputs appearing at
both channel outputs.
Analog Mixing
AUX 1 and AUX 2 analog stereo signals can be mixed in the ana-
log domain with the DAC output. Each channel of each auxil-
iary analog input can be independently gained/attenuated from
+12 dB to –34.5 dB in –1.5 dB steps or completely muted. T he
post mixed DAC output is available on OUT externally and as
an input to the ADCs.
Even if the AD1846 is not playing back data from its DACs, the
analog mix function can still be active.
Analog-to-Digital Datapath
T he AD1846
ADCs incorporate a fourth order modulator.
A single pole of passive filtering is all that is required for anti-
aliasing the analog input because of the ADC’s high 64 times
oversampling ratio. T he ADCs include linear phase digital deci-
mation filters that low-pass filter the input to 0.4
3
F
S
. (“F
S
’’ is
the word rate or “sampling frequency”). ADC input overrange
conditions will cause bits to be set that can be read.
Each channel of the mic inputs can be amplified digitally by
+18 dB to compensate for the voltage swing differences between
line levels and typical condenser microphone levels. T his +18
dB digital gain is enabled with the same control bits (LMGE
and RMGE) as the +20 dB analog gain in the AD1848.
Digital-to-Analog Datapath
T he
DACs contain a programmable attenuator and a low-
pass digital interpolation filter. T he anti-imaging interpolation
filter oversamples by 64 and digitally filters the higher frequency
images. T he attenuator allows independent control of each
DAC channel from 0 dB to –94.5 dB in 1.5 dB steps plus full
mute. T he DACs’
noise shapers also oversample by 64 and
convert the signal to a single bit stream. T he DAC outputs are
then filtered in the analog domain by a combination of switched-
capacitor and continuous-time filters. T hey remove the very
high frequency components of the DAC bitstream output. No
external components are required. Phase linearity at the analog
output is achieved by internally compensating for the group
delay variation of the analog output filters.
Changes in DAC output attenuation take effect only on zero
crossings, thereby eliminating “zipper” noise. Each channel has
its own independent zero-crossing detector and attenuator
change control circuitry. A timer guarantees that requested vol-
ume changes will occur even in the absence of an input signal
that changes sign. T he time-out period is 8 milliseconds at a
48 kHz sampling rate and 48 milliseconds at an 8 kHz sampling
rate. (T ime out [ms]
384/F
S
[kHz].)
Digital Mixing
Stereo digital output from the ADCs can be mixed digitally with
the input to the DACs. Digital output from the ADCs going out
of the data port is unaffected by the digital mix. Along the digi-
tal mix datapath, the 16-bit linear output from the ADCs is
attenuated by an amount specified with control bits. Both chan-
nels of the monitor data are attenuated by the same amount.
(Note that internally the AD1846 always works with 16-bit
PCM linear data, digital mixing included; format conversions
take place at the input and output.)
相關PDF資料
PDF描述
AD1849KP Serial-Port 16-Bit SoundPort Stereo Codec
AD1851 16-Bit, 16×Fs PCM Audio DACs(16位,單片PCM音頻D/A轉換器)
AD1892JR Integrated Digital Receiver/Rate Converter
AD1892JRRL Integrated Digital Receiver/Rate Converter
AD1892 Integrated Digital Receiver/Rate Converter(數字音頻接收器/采樣率轉換器)
相關代理商/技術參數
參數描述
AD1846JP-REEL 制造商:Analog Devices 功能描述:
AD1847 制造商:AD 制造商全稱:Analog Devices 功能描述:Serial-Port 16-Bit SoundPort Stereo Codec
AD1847JP 制造商:Rochester Electronics LLC 功能描述:- Bulk
AD1847JP-REEL 制造商:Rochester Electronics LLC 功能描述:- Tape and Reel
AD1847JST 制造商:AD 制造商全稱:Analog Devices 功能描述:Serial-Port 16-Bit SoundPort Stereo Codec