Rev. 1.1
19
C8051F410/1/2/3
1.
System Overview
C8051F41x devices are fully integrated, low power, mixed-signal system-on-a-chip MCUs. Highlighted fea-
tures are listed below. Refer to
Table 1.1 for specific product feature selection.
High-speed pipelined 8051-compatible microcontroller core (up to 50 MIPS)
In-system, full-speed, non-intrusive debug interface (on-chip)
True 12-bit 200 ksps ADC with analog multiplexer and 24 analog inputs
Two 12-bit Current Output DACs
Precision programmable 24.5 MHz internal oscillator
Up to 32 kB bytes of on-chip Flash memory
2304 bytes of on-chip RAM
SMBus/I2C, Enhanced UART, and SPI serial interfaces implemented in hardware
Four general-purpose 16-bit timers
Programmable Counter/Timer Array (PCA) with six capture/compare modules and Watchdog Timer
function
Hardware smaRTClock (Real Time Clock) operates down to 1 V with 64 bytes of Backup RAM and a
Backup Voltage Regulator
Hardware CRC Engine
On-chip Power-On Reset, VDD Monitor, and Temperature Sensor
On-chip Voltage Comparators
Up to 24 Port I/O
With on-chip Power-On Reset, VDD monitor, Watchdog Timer, and clock oscillator, the C8051F41x devices
are truly standalone system-on-a-chip solutions. The Flash memory can be reprogrammed even in-circuit,
providing non-volatile data storage, and also allowing field upgrades of the 8051 firmware. User software
has complete control of all peripherals, and may individually shut down any or all peripherals for power
savings.
The on-chip Silicon Laboratories 2-Wire (C2) Development Interface allows non-intrusive (uses no on-chip
resources), full speed, in-circuit debugging using the production MCU installed in the final application. This
debug logic supports inspection and modification of memory and registers, setting breakpoints, single
stepping, run and halt commands. All analog and digital peripherals are fully functional while debugging
using C2. The two C2 interface pins can be shared with user functions, allowing in-system programming
and debugging without occupying package pins.
Each device is specified for 2.0-to-2.75 V operation (supply voltage can be up to 5.25 V using on-chip reg-
ulator) over the industrial temperature range (–45 to +85 °C). The C8051F41x are available in 28-pin QFN
(also referred to as MLP or MLF) or 32-pin LQFP packages.