- 您現在的位置：買賣IC網 > PDF目錄98199 > TDA8295HN/C2 (NXP SEMICONDUCTORS) AM/FM, AUDIO/VIDEO DEMODULATOR, PQCC40 PDF資料下載
參數資料
| 型號： | TDA8295HN/C2 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 接收器 |
| 英文描述： | AM/FM, AUDIO/VIDEO DEMODULATOR, PQCC40 |
| 封裝： | 6 X 6 MM, 0.85 MM HEIGHT, PLASTIC, MO-220, SOT618-1, HVQFN-40 |
| 文件頁數： | 69/83頁 |
| 文件大小： | 3440K |
| 代理商： | TDA8295HN/C2 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁當前第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁
TDA8295_C2_2
NXP B.V. 2009. All rights reserved.
Product data sheet
Rev. 02 — 27 November 2009
71 of 83
NXP Semiconductors
TDA8295
Digital global standard low IF demodulator for analog TV and FM radio
13.3 DAC connection
This DAC has a differential current output capable of driving a doubly terminated 75
Ω
transmission line without external buffers. But it can also be used in single-ended
applications. In that case both outputs still need proper termination. The off-chip resistive
load must be connected to ground.
With the B_DA_V and B_DA_S coarse output level adjustment registers, the output
current can be increased (linearly) up to two times. However, the maximum output voltage
at both V_IOUTP, V_IOUTN and S_IOUTP, S_IOUTN output nodes still is 1.5 V.
DNL and INL increase when the external biasing resistor is increased. When higher load
resistances are used, distortion will increase linearly. About 12 dB increase in harmonic
distortion is expected at 150
Ω.
Several measures can be taken in order to reach good performance. Decouple the
VDDA(DAC1)(3V3) and the VDDA(DAC2)(3V3) supplies with at least 100 nF. Place the external
bias resistor close to the chip. Do not add decoupling capacitance to pin RSET.
The following relation gives the value of the full-scale current IFS in function of the bias
resistance value, FineControl (B_REF) and CoarseControl (B_DA_V or B_DA_S):
(1)
7 ≤ FineControl ≤ +7
0
≤ CoarseControl ≤ 63
For programming of FineControl (B_REF) see Table 55, for CoarseControl signals
13.4 ADC connection
The input signals of the ADC (IF_POS and IF_NEG) can be either AC coupled by means
of two capacitors or connected directly to the inputs (DC coupled). This selection is done
by programming of DCIN, see Table 51.
In case of AC coupling, DCIN should be set to logic 0, which enables two resistive dividers
between VDDA(ADC)(3V3) and VSSD1 take care of the correct DC biasing of the input signals.
In case only a single-ended input signal is available, this signal should be connected to
the IF_POS input by means of a coupling capacitor whereas the IF_NEG input should be
connected to ground using a similar capacitor.
In case the input signal is DC coupled, the input resistor network can be switched off by
setting the DCIN bit to logic 1. When using the ADC in this mode, the Common mode level
of the input signals should be at 0.5
× V
DDA(ADC)(3V3). In case of single-ended operation,
the input signal should be connected directly to the IF_POS input and the IF_NEG input
should be connected to a voltage equal to the Common mode level of the input signal
(0.5
× V
DDA(ADC)(3V3)).
The peak-to-peak input range can be set to 1 V (p-p) or 2 V (p-p) by programming of
GAINSET (see Table 51). With a differential input the performances of the ADC are
slightly better with GAINSET = 0 whereas with a single-ended input they are slightly better
with GAINSET = 1.
I
FS
1.216
RSET
-------------
100
FineControl
–
--------------------------------------------
×
1
5
---
×
64
CoarseControl
+
48
------------------------------------------------
×
64
×
=
相關PDF資料 |
PDF描述 |
|---|---|
| TDA8310AN | SPECIALTY CONSUMER CIRCUIT, PDIP52 |
| TDA8310N | SPECIALTY CONSUMER CIRCUIT, PDIP52 |
| TDA8315T-T | COLOR SIGNAL DECODER, PDSO24 |
| TDA8315TD | COLOR SIGNAL DECODER, PDSO24 |
| TDA8362N | SPECIALTY CONSUMER CIRCUIT, PDIP52 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA8296 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Digital global standard low IF demodulator for analog TV and FM radio |
| TDA8296HN | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Digital global standard low IF demodulator for analog TV and FM radio |
| TDA8296HN/C1,518 | 功能描述:調節器/解調器 DIGITAL GLOBAL IF DEMODULATOR RoHS:否 制造商:Texas Instruments 封裝 / 箱體:PVQFN-N24 封裝:Reel |
| TDA8296HN/C1,551 | 功能描述:調節器/解調器 DIGITAL GLOBAL IF DEMODULATOR RoHS:否 制造商:Texas Instruments 封裝 / 箱體:PVQFN-N24 封裝:Reel |
| TDA8296HN/C1,557 | 功能描述:調節器/解調器 DIGITAL GLOBAL IF DEMODULATOR RoHS:否 制造商:Texas Instruments 封裝 / 箱體:PVQFN-N24 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。