參數資料
型號： TAS5711PHPR
廠商： Texas Instruments
文件頁數： 26/66頁
文件大小： 0K
描述： IC AMP AUD DGTL 20W 2CH 48HTQFP
標準包裝： 1
類型： D 類
輸出類型： 2 通道（立體聲，2.1）或 4 通道（四路）
在某負載時最大輸出功率 x 通道數量： 21W x 2 @ 8 歐姆
電源電壓： 8 V ~ 26 V
特點： 消除爆音，數字輸入，I²C，I²S，靜音，短路和熱保護，關機，音量控制
安裝類型： 表面貼裝
供應商設備封裝： 48-HTQFP（7x7）
封裝/外殼： 48-TQFP 裸露焊盤
包裝： 標準包裝
產品目錄頁面： 860 (CN2011-ZH PDF)
其它名稱： 296-25564-6
A6
A5
A4
A3
A2
A1
A0
R/W ACK A7
A6
A5
A4
A3
A2
A1
A0
ACK
D7
D6
D5
D4
D3
D2
D1
D0 ACK
Start
Condition
Stop
Condition
Acknowledge
I CDevice Addressand
2
Read/WriteBit
Subaddress
DataByte
T0036-01
D7
D0 ACK
Stop
Condition
Acknowledge
I CDevice Addressand
2
Read/WriteBit
Subaddress
LastDataByte
A6
A5
A1
A0 R/W ACK A7
A5
A1
A0
ACK D7
ACK
Start
Condition
Acknowledge
FirstDataByte
A4
A3
A6
OtherDataBytes
ACK
Acknowledge
D0
D7
D0
T0036-02
SLOS600A – DECEMBER 2009 – REVISED AUGUST 2010
www.ti.com
During multiple-byte read operations, the DAP responds with data, a byte at a time, starting at the subaddress
assigned, as long as the master device continues to respond with acknowledges. If a particular subaddress does
not contain 32 bits, the unused bits are read as logic 0.
During multiple-byte write operations, the DAP compares the number of bytes transmitted to the number of bytes
that are required for each specific subaddress. For example, if a write command is received for a biquad
subaddress, the DAP expects to receive five 32-bit words. If fewer than five 32-bit data words have been
received when a stop command (or another start command) is received, the data received is discarded.
Supplying a subaddress for each subaddress transaction is referred to as random I2C addressing. The TAS5711
also supports sequential I2C addressing. For write transactions, if a subaddress is issued followed by data for
that subaddress and the 15 subaddresses that follow, a sequential I2C write transaction has taken place, and the
data for all 16 subaddresses is successfully received by the TAS5711. For I2C sequential write transactions, the
subaddress then serves as the start address, and the amount of data subsequently transmitted, before a stop or
start is transmitted, determines how many subaddresses are written. As was true for random addressing,
sequential addressing requires that a complete set of data be transmitted. If only a partial set of data is written to
the last subaddress, the data for the last subaddress is discarded. However, all other data written is accepted;
only the incomplete data is discarded.
Single-Byte Write
As shown in Figure 47, a single-byte data write transfer begins with the master device transmitting a start
condition followed by the I2C device address and the read/write bit. The read/write bit determines the direction of
the data transfer. For a write data transfer, the read/write bit will be a 0. After receiving the correct I2C device
address and the read/write bit, the DAP responds with an acknowledge bit. Next, the master transmits the
address byte or bytes corresponding to the TAS5711 internal memory address being accessed. After receiving
the address byte, the TAS5711 again responds with an acknowledge bit. Next, the master device transmits the
data byte to be written to the memory address being accessed. After receiving the data byte, the TAS5711 again
responds with an acknowledge bit. Finally, the master device transmits a stop condition to complete the
single-byte data write transfer.
Figure 47. Single-Byte Write Transfer
Multiple-Byte Write
A multiple-byte data write transfer is identical to a single-byte data write transfer except that multiple data bytes
are transmitted by the master device to the DAP as shown in Figure 48. After receiving each data byte, the
TAS5711 responds with an acknowledge bit.
Figure 48. Multiple-Byte Write Transfer
32
Copyright 2009–2010, Texas Instruments Incorporated
Product Folder Link(s): TAS5711
相關PDF資料
PDF描述
AD7899ARZ-1 IC ADC 14BIT 400KSPS 5V 28SOIC
HIN202ECBNZ IC 2DRVR/2RCVR RS232 5V 16-SOIC
HIN202CPZ IC TXRX RS-232 5V 16-PDIP
AD7856ARSZ IC ADC 14BIT 8CHAN 5V 24SSOP
VI-B4J-MX-F3 CONVERTER MOD DC/DC 36V 75W
相關代理商/技術參數
參數描述
TAS5713 制造商:TI 制造商全稱:Texas Instruments 功能描述:25-W DIGITAL AUDIO POWER AMPLIFIER WITH EQ AND DRC
TAS5713_10 制造商:TI 制造商全稱:Texas Instruments 功能描述:25-W DIGITAL AUDIO POWER AMPLIFIER WITH EQ AND DRC
TAS5713_101 制造商:TI 制造商全稱:Texas Instruments 功能描述:25-W DIGITAL AUDIO POWER AMPLIFIER WITH EQ AND DRC
TAS5713PHP 功能描述:音頻放大器 Digital Audio Power Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TAS5713PHP 制造商:Texas Instruments 功能描述:Audio Power Amplifier IC 制造商:Texas Instruments 功能描述:IC, AUDIO PWR AMP, CLASS D, 25W HTQFP-48
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*