- 您現在的位置：買賣IC網 > PDF目錄98145 > ST72774S9T1/XXX (STMICROELECTRONICS) 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP44 PDF資料下載
參數資料
| 型號： | ST72774S9T1/XXX |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP44 |
| 封裝： | TQFP-44 |
| 文件頁數： | 10/144頁 |
| 文件大小： | 1280K |
| 代理商： | ST72774S9T1/XXX |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁
ST72774/ST727754/ST72734
107/144
DDC INTERFACE (Cont’d)
4.8.5.2 DDC/CI - Factory Alignment Interface
4.8.5.2.1 Functional Description
Refer to the CR, SR1 and SR2 registers in Section
4.8.6. for the bit definitions.
The DDC/CI interface works as an I/O interface
between the microcontroller and the DDC2Bi,
EDDC or Factory alignment protocols. It receives
and transmits data in Slave I2C mode using an
interrupt or polled handshaking.
The interface is connected to the I2C bus by a data
pin (SDAD) and a clock pin (SCLD) configured as
open drain.
The DDC/CI interface has five internal register
locations.
Two of them are used for initialization of the
interface:
– Own Address Register OAR
– Control register CR
The following four registers are used during data
transmission/reception:
– Data Register DR
– Control Register CR
– Status Register 1 SR1
– Status Register 2 SR2
The interface decodes an I2C or DDC2Bi address
stored by software in the OAR register and/or the
EDDC address (60h/61h) as its default hardware
address.
After a reset, the interface is disabled.
4.8.5.2.2 I2C Modes
s
General description
In I2C mode, the interface can operate in the
following modes:
– Slave transmitter/receiver
Both start and stop conditions are generated by
the master. The I2C clock (SCL) is always
received by the interface from a master, but the
interface is able to stretch the clock line.
The interface is capable of recognizing both its
own programmable address (7-bit) and its default
hardware address (Enhanced DDC address: 60h/
61h). The Enhanced DDC address detection may
be enabled or disabled by software. It never
recognizes the Start byte (01h) whatever its own
address is.
s
Slave Mode
As soon as a start condition is detected, the
address is received from the SDA line and sent to
the shift register; then it is compared with the
programmable address of the interface or the
Enhanced DDC address (if selected by software).
Address not matched: the interface ignores it
and waits for another Start condition.
Address matched: the following events occur in
sequence:
– Acknowledge pulse is generated if the ACK bit is
set.
– EVF and ADSL bits are set.
– An interrupt is generated if the ITE bit is set.
Then the interface waits for a read of the SR1
register, holding the SCL line low (see Figure 67
Transfer sequencing EV1).
Next, the DR register must be read to determine
from the least significant bit if the slave must enter
Receiver or Transmitter mode.
相關PDF資料 |
PDF描述 |
|---|---|
| ST72E734J6D0 | 8-BIT, UVPROM, 8 MHz, MICROCONTROLLER, CDIP42 |
| ST72T774S9T1 | 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PQFP44 |
| ST7294C6B6 | 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PDIP28 |
| ST72T94C6M6 | 8-BIT, OTPROM, MICROCONTROLLER, PDSO28 |
| ST72C171K2B6 | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PDIP32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ST727X4-EMU2B | 制造商:STMicroelectronics 功能描述:REALTIME EMULATOR BOARD - Bulk |
| ST727X4-EPB/US | 制造商:STMicroelectronics 功能描述:PROGRAMMER - Bulk |
| ST-7-28 | 功能描述:XFRMR PWR 115V 14VAC 2.6A RoHS:是 類別:變壓器 >> 功率 系列:ST 標準包裝:1 系列:260 類型:標準 最大功率:65 VA 主線圈:雙 副線圈:三路，中心抽頭 在某電流時的串聯輸出電壓:500 VAC @ 85mA，5 VAC @ 2A，6.3 VAC @ 2A 在某電流時的并聯輸出電壓:- 安裝類型:底座安裝 尺寸/尺寸:102.36mm L x 67.31mm W 高度 - 座高（最大）:66.80mm 端接類型:導線引線 |
| ST7-28 | 制造商:SUPERWORLD 制造商全稱:Superworld Electronics 功能描述:POWER TRANSFORMER |
| ST7-28B56 | 功能描述:電源變壓器 SPLIT BOBBIN HORZ MOUNT XFMR RoHS:否 制造商:Triad Magnetics 功率額定值:12 VA 初級電壓額定值:115 V / 230 V 次級電壓額定值:12 V / 24 V 安裝風格:SMD/SMT 一次繞組:Dual Primary Winding 二次繞組:Dual Secondary Winding 長度:2.5 in 寬度:2 in 高度:1.062 in |
發布緊急采購，3分鐘左右您將得到回復。