- 您現在的位置：買賣IC網 > PDF目錄15834 > SI3216MDC1-EVB (Silicon Laboratories Inc)DAUGHTER CARD W/SI3201 INTERFACE PDF資料下載
參數資料
| 型號： | SI3216MDC1-EVB |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 64/122頁 |
| 文件大?。?/td> | 0K |
| 描述： | DAUGHTER CARD W/SI3201 INTERFACE |
| 標準包裝： | 1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁當前第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁
Si3216
46
Rev. 1.0
Not
Recommended
fo
r N
ew
D
esi
gn
s
subscriber loop via the ITIPP and IRINGP pins through
an off-chip current buffer (IBUF), which is implemented
using transistors Q1 and Q2 (see Figure on page 22).
Gm is referenced to an off-chip resistor (R15).
The ProSLIC also provides a means of compensating
for degraded subscriber loop conditions involving
excessive line capacitance (leakage). The CLC[1:0] bits
of direct Register 10 increase the ac signal magnitude
to compensate for the additional loss at the high end of
the audio frequency range. The default setting of
CLC[2:0] assumes no line capacitance.
When 600 + 1 F or 900 + 2.16 F impedances are
selected, an internal reference resistor is removed from
the impedance synthesis circuit to accommodate an
external resistor, RZREF, inserted into the application
circuit as shown in Figure 25.
Figure 25. RZREF External Resistor Placement
2.7. Clock Generation
The ProSLIC generates the necessary internal clock
frequencies from the PCLK input. PCLK must be
synchronous to the 8 kHz FSYNC clock and run at one
of the following rates: 256kHz, 512kHz, 768kHz,
1.024 MHz, 1.536 MHz, 2.048 MHz, 4.096 MHz, or
8.192 MHz. The ratio of the PCLK rate to the FSYNC
rate is determined via a counter clocked by PCLK. The
three-bit ratio information is automatically transferred
into an internal register, PLL_MULT, following a reset of
the ProSLIC. The internal PLL_MULT register is used to
control the internal PLL, which multiplies PCLK as
needed to generate the 16.384 MHz rate needed to run
the internal filters and other circuitry.
The PLL clock synthesizer settles very quickly following
powerup. However, the settling time depends on the
PCLK frequency and it can be approximately predicted
by the following equation:
2.8. Interrupt Logic
The ProSLIC is capable of generating interrupts for the
following events:
Loop current/ring ground detected
Ring trip detected
Power alarm
Active timer 1 expired
Inactive timer 1 expired
Active timer 2 expired
Inactive timer 2 expired
Ringing active timer expired
Ringing inactive timer expired
Indirect register access complete
The interface to the interrupt logic consists of six
registers. Three interrupt status registers contain 1 bit
for each of the above interrupt functions. These bits are
set when an interrupt is pending for the associated
resource. Three interrupt enable registers also contain 1
bit for each interrupt function. In the case of the interrupt
enable registers, the bits are active high. Refer to the
appropriate
functional
description
section
for
operational details of the interrupt functions.
When a resource reaches an interrupt condition, it
signals an interrupt to the interrupt control block. The
interrupt control block then sets the associated bit in the
interrupt status register if the enable bit for that interrupt
is set. The INT pin is an open-drain output and a NOR
of the bits of the interrupt status registers. Therefore, if a
bit in the interrupt status registers is asserted, IRQ
asserts low. Upon receiving the interrupt, the interrupt
handler should read interrupt status registers to
determine which resource is requesting service. To
clear a pending interrupt, write the desired bit in the
appropriate interrupt status register to 1. Writing a 0 has
no effect. This provides a mechanism for clearing
individual
bits
when
multiple
interrupts
occur
simultaneously. While the interrupt status registers are
non-zero, the INT pin will remain asserted.
2.9. Serial Peripheral Interface
The control interface to the ProSLIC is a 4-wire interface
modeled after commonly-available microcontroller and
serial peripheral devices. The interface consists of a
clock (SCLK), chip select (CS), serial data input (SDI),
and serial data output (SDO). Data is transferred a byte
at a time with each register access consisting of a pair
write operation in the SPI bus.
The first byte of the pair is the command/address byte.
The MSB of this byte indicates a register read when 1
and a register write when 0. The remaining seven bits of
to TIP
to RING
Si3216
STIPAC
SRINGAC
R
ZREF
C3
C4
R8
R9
For 600 + 1
F, R
ZREF = 12 k and C3, C4 = 100 nF
For 900 + 2.16
F, R
ZREF = 18 k and C3, C4 = 220 nF
T
SETTLE
64
F
PCLK
-----------------
=
相關PDF資料 |
PDF描述 |
|---|---|
| RSC12DRYN | CONN EDGECARD 24POS DIP .100 SLD |
| MCP120-270DI/TO | IC SUPERVISOR 2.70V LOW TO92 |
| MAX6439UTFGVD7+T | IC BATTERY MON SNGL SOT23-6 |
| 1838236-2 | CONN MALE M12 3POS STR 3M CABLE |
| RMC12DRYN | CONN EDGECARD 24POS DIP .100 SLD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SI3216MDCQ1-EVB | 功能描述:子卡和OEM板 Si3216M QFN DAUGHTER CARD RoHS:否 制造商:BeagleBoard by CircuitCo 產品:BeagleBone LCD4 Boards 用于:BeagleBone - BB-Bone - Open Source Development Kit |
| SI3216MDCQX-EVB | 功能描述:子卡和OEM板 Si3216M QFN DAUGHTER CARD RoHS:否 制造商:BeagleBoard by CircuitCo 產品:BeagleBone LCD4 Boards 用于:BeagleBone - BB-Bone - Open Source Development Kit |
| SI3216MDCX-EVB | 功能描述:DAUGHTER CARD W/DISCRETE INTRFC RoHS:否 類別:編程器，開發系統 >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 傳感器類型:CMOS 成像，彩色（RGB） 傳感范圍:WVGA 接口:I²C 靈敏度:60 fps 電源電壓:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相關產品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP |
| SI3216M-FT | 功能描述:IC SLIC/CODEC 1CH 38TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 電信 系列:ProSLIC® 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:* |
| SI3216M-GT | 功能描述:IC SLIC/CODEC 1CH 38TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 電信 系列:ProSLIC® 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:* |
發布緊急采購，3分鐘左右您將得到回復。