- 您現在的位置：買賣IC網 > PDF目錄98051 > PC34704BEP (FREESCALE SEMICONDUCTOR INC) 8-CHANNEL POWER SUPPLY MANAGEMENT CKT, QCC56 PDF資料下載
參數資料
| 型號： | PC34704BEP |
| 廠商： | FREESCALE SEMICONDUCTOR INC |
| 元件分類： | 電源管理 |
| 英文描述： | 8-CHANNEL POWER SUPPLY MANAGEMENT CKT, QCC56 |
| 封裝： | 7 X 7 MM, 1 MM HEIGHT, 0.40 MM PITCH, ROHS COMPLIANT, QFN-56 |
| 文件頁數： | 8/50頁 |
| 文件大?。?/td> | 2010K |
| 代理商： | PC34704BEP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁
Analog Integrated Circuit Device Data
16
Freescale Semiconductor
34704
FUNCTIONAL DESCRIPTION
INTRODUCTION
FUNCTIONAL DESCRIPTION
INTRODUCTION
The 34704 is an multi-channel power management IC
(PMIC) meant to address power management needs for
various multimedia applications microprocessors in various
configurations with a target overall efficiency of > 80% at
typical loads.
The 34704 accepts an input voltage from various sources:
1 cell Li-Ion/Polymer (2.7V to 4.2V)
5.0V USB supply or AC wall adapter
The different channels are:
REG1, REG3, REG6, and REG8 use internal
compensation, while REG2, REG4, REG5, and REG7 use
external compensation.
The switching frequency of all regulators except REG6, 7,
& 8 can be selected through the FREQ pin between 750kHz
and 2.0MHz in 250kHz steps, when operating from a Li-Ion
battery. The high frequency operation is meant to minimize
the size of external components while lower operating
frequencies will allow for higher efficiency. REG7 is limited to
operate at a lower frequency to minimize switching noise
induced by driving the external switching MOSFET, but also
can operate at the 1.0MHz value with proper board layout.
REG 6, 7, and 8 switching frequency can be selected
between 250kHz and 1.0MHz in 250kHz steps through I2C.
For all regulators and at lower loads, a pulse skipping
mode is implemented to maintain high efficiency. The 34704
uses 4 different phases of switching for all regulators except
REG6, 7, and 8, to spread out the current draw by the
individual converters from the input supply over time, to
reduce the peak input current demand. This allows for better
EMI performance and reduction in the input filter
requirements.
Each regulator except REG1 uses an external feedback
resistor divider to set the output voltage. All output voltages
can be adjusted dynamically (Dynamic Voltage Scaling) on
the fly through an IC serial interface. All converters, except
REG1, utilize automatic soft-start by ramping the reference
voltage to the error amplifier to prevent sudden change in
duty cycle and output current/voltage at power up. REG1
(VG) will limit the inrush current by implementing a peak
current detect and a constant off time.
The 34704 is equipped with a dual function Power On/Off
pin (ONOFF). This pin can be controlled by a mechanical
switch to turn the device on or off. Pressing and releasing the
mechanical switch turns the 34704 on while pressing and
holding the switch for a time period (programmable through
I2C) turns the 34704 off. Enable/disable control is also
granted through I2C for groups of regulators and the whole
IC.
REGULATOR
REGULATOR TYPE
VOUT TYP (V)
IOUT TYP
(MA)
IOUT MAX
(MA)
TARGET APPLICATION
REG1(17)
Synchronous Boost
5.0
100
500
+5V REF
REG2
Synchronous Buck-Boost
2.8 / 3.3
200
500
P I/O
REG3
Synchronous Buck
1.2 / 1.5 / 1.8
150
550
P Core
REG4
Synchronous Buck-Boost
1.8 / 2.5
100
300
DDR
REG5
Synchronous Buck-Boost
3.3
150
500
P I/O
REG6(17)
Synchronous Boost
15.0
20
60
REF+
REG7(17)
Inverter Controller
-7.0
20
60
REF -
REG8
Synchronous Boost
15.0
15
30
Backlight Display
Notes
16.
Synchronous Buck-Boost: These regulators can work as pure BUCK regulator when the output voltage is lower than the input
voltage; and work as pure BOOST regulator when the input voltage is lower than the output voltage. Compensation should be done
for the worst case scenario, which is in most of the cases when the device is working as a boost converter, after compensating for
this scenario it is recommended to verify the buck operation to assure stability in the whole operating range.
17.
Available only on the 34704A
相關PDF資料 |
PDF描述 |
|---|---|
| PCA8802CX8/B/1 | SPECIALTY ANALOG CIRCUIT, PBGA8 |
| PCA8802U/2AA/1 | SPECIALTY ANALOG CIRCUIT, PBGA8 |
| PCF1252-9TD-T | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| PCF1252-4TD-T | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| PCF50603HN | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PQCC48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PC34708VK | 制造商:Freescale Semiconductor 功能描述:PMIC 5S 6LDO BST 10BTADC - Bulk |
| PC34708VM | 制造商:Freescale Semiconductor 功能描述:PMIC 5S 6LDO BST 10BTADC - Bulk |
| PC34709VK | 制造商:Freescale Semiconductor 功能描述:PMIC 5SW,6 LDO,BST - Bulk |
| PC34709VKR2 | 制造商:Freescale Semiconductor 功能描述:PMIC 5SW,6 LDO,BST - Tape and Reel |
| PC34710EW | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Adjustable Dual Output Switching Power Supply |
發布緊急采購，3分鐘左右您將得到回復。