參數資料
型號： P95020ZLLGI8
廠商： INTEGRATED DEVICE TECHNOLOGY INC
元件分類： 電源管理
英文描述： 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA124
封裝： LLGA-124
文件頁數： 101/137頁
文件大小： 3533K
代理商： P95020ZLLGI8
P95020 / Preliminary Datasheet
Revision 0.7.10
66
2010 Integrated Device Technology, Inc.
5.0 RTC MODULE
FEATURES
Real Time Clock (RTC) Counts Seconds, Minutes,
Hours, Day, Date, Month and Year (with Leap-Year
Compensation Valid Up to year 2100
Two time-of-day alarms
Low power
DESCRIPTION
The low power serial real-time clock (RTC) device has two
programmable time-of-day alarms. Address and data are
transferred serially through the IC bus. The device
provides seconds, minutes, hours, day, date, month and
year information. The date at the end of the month is
automatically adjusted for months with fewer than 31
days, including corrections for leap year. The clock
operates in either 24-hour format or 12-hour format with
AM/PM indicator.
5.1
RTC - GENERAL DESCRIPTION
The Real-Time Clock (RTC) block is a low-power clock/date device with two programmable time-of-day/date alarms. The
clock/date provides seconds, minutes, hours, day, date, month and year information. The date at the end of the month is
automatically adjusted for months with fewer than 31 days, including corrections for leap years. The clock operates in
either the 24-hour or 12-hour format with an AM/PM indicator. The RTC cannot be disabled while the system is powered
on. The register settings and logic are only reset the first time the system is powered on by inserting either the wall
adapter or the battery. After reset, the time keeping registers are reset and must be synchronized to the real time by
programming its time keeping registers. The alarm interrupts are disabled by default.
The time and date information is set and monitored by writing and reading the appropriate register bytes. Sections 5.2
and 5.3 below show the RTC TIMEKEEPER and RTC DATE registers. The contents of the time and date registers are in
BCD format. The RTC block can be run in either 12-hour or 24-hour mode. Bit 6 of the HOUR register is defined as the
12-hour or 24-hour mode-select bit. When high, the 12-hour mode is selected. In 12-hour mode, bit 5 is the PM bit with
logic high being PM. In the 24-hour mode, bit 5 is the second 10-hour bit (20 to 23 hours). All hour values, including the
alarms, must be re-entered whenever the TIME_12 mode bit is changed. The century bit (bit 7 of the month register) is
toggled when the YEAR register overflows from 99 to 0. The days register increments at midnight. Values that
correspond to the day of week are user-defined, but must be sequential (i.e., if 1 equals Sunday, then 2 equals Monday
and so on). Illogical time and date entries result in undefined operation.
When reading or writing the time and date registers, secondary (user) buffers are used to prevent errors when the internal
registers update. When reading the time and date registers, the user buffers are synchronized to the internal registers at
the time of reading address pointing to zero. The countdown chain is reset whenever the seconds register is written.
Write transfer occurs when the processor bus receives a write command. To avoid rollover issues, once the countdown
chain is reset, the remaining time and date registers must be written within 0.5 second.
The RTC block contains two time-of-day/date alarms. The alarms can be programmed (via the alarm enable and INT_EN
bits of the control registers defined in section 5.5) to activate the interrupt (INT) output when an alarm match condition
occurs. Bit 7 of each of the time of day/date alarm registers are mask bits (Table 2). When all the mask bits for each
alarm are logic 0 an alarm occurs only when the values in the timekeeping registers 00h to 04h match the values stored in
the time-of-day/date alarm register. The alarms can also be programmed to repeat every second, minute, hour, day or
date. Table 16 shows the possible settings.
Table 16 - Alarm mask bits
DY1
A1M4
A1M3
A1M2
A1M1
Alarm rate
X
1
Alarm once per second
X
1
0
Alarm when seconds match
X
1
0
Alarm when minutes and seconds match
X
1
0
Alarm when hours, minutes, and seconds match
0
Alarm when date, hours, minutes, and seconds match
1
0
Alarm when day, hours, minutes, and seconds match
DY2
A2M4
A2M3
A2M2
A2M1
Alarm rate
X
1
Alarm once per second
X
1
0
Alarm when seconds match
X
1
0
Alarm when minutes and seconds match
X
1
0
Alarm when hours, minutes, and seconds match
0
Alarm when date, hours, minutes, and seconds match
1
0
Alarm when day, hours, minutes, and seconds match
相關PDF資料
PDF描述
PBL3717A STEPPER MOTOR CONTROLLER, 1.2 A, PDIP16
PC13892AJVL 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA186
PC13892BJVK 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA139
PC13892AJVK 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA139
PC13892BJVL 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA186
相關代理商/技術參數
參數描述
P95021NQG 功能描述:PMIC 解決方案 Integrates Audio, LED B/Light Pwr Mgt RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel
P95021NQG8 制造商:Integrated Device Technology Inc 功能描述:POWER MANAGEMENT, AUDIO & CONT 制造商:Integrated Device Technology Inc 功能描述:132-VFQFPN - Tape and Reel 制造商:Integrated Device Technology Inc 功能描述:Integrates Audio, LED B/Light Pwr Mgt
P950-36I 制造商:Tripp Lite 功能描述:SERIAL ATA II SIGNAL CABLE, 2X7-PIN STRAIGHT CONNECTOR - 39" - Bulk
P9508- 制造商:ROEBUCK 功能描述:ROEBUCK DISH WASHING BRUSH
P9-511121 功能描述:按鈕開關 Flush Dome Solder 5A SPST-DB, SPDT-DB RoHS:否 制造商:OTTO 觸點形式: 開關功能: 電流額定值: 電壓額定值 AC: 電壓額定值 DC: 功率額定值: 安裝風格: 照明: 照明顏色: IP 等級: 端接類型: 觸點電鍍: 執行器: 蓋顏色: 封裝: 可燃性等級:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*