參數資料
型號： P89V51RB2FA,529
廠商： NXP Semiconductors
文件頁數： 53/80頁
文件大?。?/td> 0K
描述： IC 80C51 MCU FLASH 16K 44-PLCC
產品培訓模塊： Migrating from 8/16-Bit MCUs to 32-Bit ARMs
標準包裝： 156
系列： 89V
核心處理器： 8051
芯體尺寸： 8-位
速度： 40MHz
連通性： SPI，UART/USART
外圍設備： 欠壓檢測/復位，POR，PWM，WDT
輸入/輸出數： 32
程序存儲器容量： 16KB（16K x 8）
程序存儲器類型： 閃存
RAM 容量： 1K x 8
電壓 - 電源 (Vcc/Vdd)： 4.5 V ~ 5.5 V
振蕩器型： 內部
工作溫度： -40°C ~ 85°C
封裝/外殼： 44-LCC（J 形引線）
包裝： 管件
產品目錄頁面： 706 (CN2011-ZH PDF)
配用： 622-1017-ND - BOARD 44-ZIF PLCC SOCKET
622-1001-ND - USB IN-CIRCUIT PROG 80C51ISP
其它名稱： 568-2427-5
935278706529
P89V51RB2FA-S
2009-2011 Microchip Technology Inc.
DS39960D-page 57
PIC18F87K22 FAMILY
4.0
POWER-MANAGED MODES
The PIC18F87K22 family of devices offers a total of
seven operating modes for more efficient power man-
agement. These modes provide a variety of options for
selective power conservation in applications where
resources may be limited (such as battery-powered
devices).
There are three categories of power-managed mode:
Run modes
Idle modes
Sleep mode
There is an Ultra Low-Power Wake-up (ULPWU) for
waking from the Sleep mode.
These categories define which portions of the device
are clocked, and sometimes, at what speed. The Run
and Idle modes may use any of the three available
clock sources (primary, secondary or internal oscillator
block). The Sleep mode does not use a clock source.
The ULPWU mode, on the RA0 pin, enables a slow fall-
ing voltage to generate a wake-up, even from Sleep,
without excess current consumption. (See Section 4.7
The power-managed modes include several power-
saving features offered on previous PIC devices. One
is the clock switching feature, offered in other PIC18
devices. This feature allows the controller to use the
SOSC oscillator instead of the primary one. Another
power-saving feature is Sleep mode, offered by all PIC
devices, where all device clocks are stopped.
4.1
Selecting Power-Managed Modes
Selecting a power-managed mode requires two
decisions:
Will the CPU be clocked or not
What will be the clock source
The IDLEN bit (OSCCON<7>) controls CPU clocking,
while the SCS<1:0> bits (OSCCON<1:0>) select the
clock source. The individual modes, bit settings, clock
sources and affected modules are summarized in
4.1.1
CLOCK SOURCES
The SCS<1:0> bits select one of three clock sources
for power-managed modes. Those sources are:
The primary clock as defined by the FOSC<3:0>
Configuration bits
The secondary clock (the SOSC oscillator)
The internal oscillator block (for LF-INTOSC
modes)
4.1.2
ENTERING POWER-MANAGED
MODES
Switching from one power-managed mode to another
begins by loading the OSCCON register. The
SCS<1:0> bits select the clock source and determine
which Run or Idle mode is used. Changing these bits
causes an immediate switch to the new clock source,
assuming that it is running. The switch may also be
subject to clock transition delays. These considerations
and subsequent sections.
Entering the power-managed Idle or Sleep modes is
triggered by the execution of a SLEEP instruction. The
actual mode that results depends on the status of the
IDLEN bit.
Depending on the current and impending mode, a
change to a power-managed mode does not always
require setting all of the previously discussed bits. Many
transitions can be done by changing the oscillator select
bits, or changing the IDLEN bit, prior to issuing a SLEEP
instruction. If the IDLEN bit is already configured as
desired, it may only be necessary to perform a SLEEP
instruction to switch to the desired mode.
TABLE 4-1:
POWER-MANAGED MODES
Mode
OSCCON Bits
Module Clocking
Available Clock and Oscillator Source
IDLEN<7>(1)
SCS<1:0>
CPU
Peripherals
Sleep
0
N/A
Off
None – All clocks are disabled
PRI_RUN
N/A
00
Clocked
Primary – XT, LP, HS, EC, RC and PLL modes.
This is the normal, Full-Power Execution mode.
SEC_RUN
N/A
01
Clocked
Secondary – SOSC Oscillator
RC_RUN
N/A
1x
Clocked
Internal oscillator block(2)
PRI_IDLE
100
Off
Clocked
Primary – LP, XT, HS, RC, EC
SEC_IDLE
101
Off
Clocked
Secondary – SOSC oscillator
RC_IDLE
11x
Off
Clocked
Internal oscillator block(2)
Note 1:
IDLEN reflects its value when the SLEEP instruction is executed.
2:
Includes INTOSC (HF-INTOSC and MG-INTOSC) and INTOSC postscaler, as well as the LF-INTOSC
source.
相關PDF資料
PDF描述
P89V660FA,512 IC 80C51 MCU FLASH 16K 44-PLCC
P89V660FBC,557 IC 80C51 MCU FLASH 16K 44-TQFP
P89V662FBC,557 IC 80C51 MCU FLASH 32K 44-TQFP
PIC32MX130F064B-I/SO IC MCU 32BIT 64KB FLASH 28-SOIC
PIC32MX220F032D-I/ML IC MCU 32BIT 32KB FLASH 44QFN
相關代理商/技術參數
參數描述
P89V51RB2FN 制造商:NXP Semiconductors 功能描述:IC MCU 8BIT 80C51 16K FLASH DIP40 制造商:NXP Semiconductors 功能描述:IC, MCU 8BIT 80C51 16K FLASH, DIP40
P89V51RB2FN,112 功能描述:8位微控制器 -MCU 80C51 16K FL / 512 R RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
P89V51RB2FN112 制造商:NXP Semiconductors 功能描述:IC 8BIT MCU 80C51 40MHZ DIP-40
P89V51RC2 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit 80C51 5 V low power 16/32/64 kB Flash microcontroller with 1 kB RAM
P89V51RC2BN 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit 80C51 5 V low power 16/32/64 kB Flash microcontroller with 1 kB RAM
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*