- 您現在的位置：買賣IC網 > PDF目錄363665 > NSAM266SA (NATIONAL SEMICONDUCTOR CORP) 4 Mbit Uniform Sector, Serial Flash Memory PDF資料下載
參數資料
| 型號： | NSAM266SA |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 數字信號處理 |
| 英文描述： | 4 Mbit Uniform Sector, Serial Flash Memory |
| 中文描述： | 8-BIT, MIXED DSP |
| 文件頁數： | 8/52頁 |
| 文件大?。?/td> | 571K |
| 代理商： | NSAM266SA |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
1.0 Hardware
(Continued)
1.3.3 Power-Down Mode
Power-down mode is useful during a power failure, when the
power source for the CompactSPEECH is a backup battery,
or in battery powered devices, while the CompactSPEECH
is idle.
In power-down mode, the clock frequency of the Compact-
SPEECH is reduced, and some of the processor modules
are deactivated. As a result, the CompactSPEECH con-
sumes much less power than in normal-power mode
(
k
1.5 mA). Although the CompactSPEECH does not per-
form all its usual functions in power-down mode, it still
keeps stored messages and maintains the time of day.
Note:
In power-down mode all the chip select signals, CS0 to CS3, are set
to 1. To guarantee that there is no current flow from these signals to
the Serial Flash devices, the power supply to these devices must not
be disconnected.
The CompactSPEECH stores messages, and all memory
management information, in flash memory. Thus, there is no
need to maintain the power to the processor to preserve
stored messages. If the microcontroller’s real-time clock
(and not the CompactSPEECH’s real-time clock) is used to
maintain the time and day, neither the flash nor the
CompactSPEECH require battery backup during power fail-
ure. In this case, when returning to normal mode, the micro-
controller should perform the initialization sequence, as de-
scribed in Section 2.10, and use the SETD command to set
the time and day.
To keep power consumption low in power-down mode, the
RESET, MWCS, MWCLK and MWDIN signals should be
held above V
CC
b
0.5V or below V
SS
a
0.5V.
The PDM (Go To Power-down Mode) command switches
the CompactSPEECH to power-down mode. (For an expla-
nation of the CompactSPEECH commands, see Section
2.14.) It may only be issued when the CompactSPEECH is
in the
IDLE
state. (For an explanation of the Compact-
SPEECH states, see Section 2.3.) If it is necessary to switch
to power-down mode from any other state, the controller
must first issue an S command to switch the Compact-
SPEECH to the
IDLE
state, and then issue the PDM com-
mand. Sending any command while in power-down mode
resets the CompactSPEECH detectors, and returns the
CompactSPEECH to normal operation mode.
1.3.4 Power and Grounding
The CompactSPEECH processor requires a single 5V pow-
er supply, applied to the V
CC
pins.
The grounding connections are made on the GND pins.
For optimal noise immunity, the power and ground pins
should be connected to V
CC
and the ground planes, respec-
tively, on the printed circuit board. If V
CC
and the ground
planes are not used, single conductors should be run direct-
ly from each V
CC
pin to a power point, and from each GND
pin to a ground point. Avoid daisy-chained connections.
Use decoupling capacitors to keep the noise level to a mini-
mum. Attach standard 0.1
m
F ceramic capacitors to the V
CC
and GND pins, as close as possible to the Compact-
SPEECH.
When you build a prototype, using wire-wrap or other meth-
ods, solder the capacitors directly to the power pins of the
CompactSPEECH socket, or as close as possible, with very
short leads.
1.3.5 Memory Interface
Serial Flash Interface
The CompactSPEECH supports up to four NM29A040
4-Mbit, or up to two NM29A080 8-Mbit, serial flash memory
devices for storing messages.
NM29A040
The NM29A040 is organized as 128 blocks of 128 pages,
each containing 32 bytes. A block is the smallest unit that
can be erased, and is 4 kbytes in size.
Not all 128 blocks are available for recording. Up to 10
blocks may contain bad bits, and one block is write-once
and holds the locations of these unusable blocks.
For further information about the NM29A040, see the
NM29A040 Datasheet.
NM29A080
The NM29A080 is organized as 256 blocks of 128 pages,
each containing 32 bytes. A block is the smallest unit that
can be erased, and is 4 kbytes in size.
Not all 256 blocks are available for recording. Up to 20
blocks may contain bad bits, and two blocks are write-once
and hold the locations of these unusable blocks.
For further information about the NM29A080, see the
NM29A080 Datasheet.
Message Organization and Recording Time
A CompactSPEECH message uses at least one block. The
number of messages that can be stored on one NM29A040
device is 117–127, and on one NM29A080 device is 234 to
254 depending on the number of bad blocks. The maximum
recording time depends on four factors:
D The basic compression rate (5.2 kbit/s or 7.3 kbit/s)
D The amount of silence in the recorded speech
D The number of unusable blocks
D The number of recorded messages. (The basic memory
allocation unit for a message is a 4 kbyte block which
means that half a block in average is not used per re-
corded message)
Assuming a single message is recorded in all the available
memory space of a 4 Mbit device with all blocks usable, the
maximum recording time using 5.2 kbit/s compression is as
follows:
TABLE 1-3. Recording Time on 4 Mbit Device
Amount of Silence
Total Record Time
0
13 min 9 sec
14 min 25 sec
15 min 7 sec
15 min 47 sec
16 min 25 sec
10
15
20
25
Serial Flash Endurance
The serial flash may be erased up to 100,000 times. To
reduce the effect of this limitation, the memory manager
utilizes the serial flash’s blocks evenly, i.e., each block is
erased more or less the same number of times, to ensure
that all blocks have the same lifetime.
http://www.national.com
8
相關PDF資料 |
PDF描述 |
|---|---|
| NSAM266SAA | 4 Mbit Uniform Sector, Serial Flash Memory |
| NSB8 | BASIC interpreter for Z80 family |
| NSB9435T1 | High Current Bias Resistor Transistors(高強度電流偏置電阻晶體管) |
| NSBA114EDXV6T1 | Dual Bias Resistor Transistors(雙偏置電阻晶體管) |
| NSBA114YDXV6T1 | Dual Bias Resistor Transistors(雙偏置電阻晶體管) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NSAM266SAA | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:NSAM266SA CompactSPEECHTM Digital Speech Processor with Serial Flash Interface |
| NSAM266SAA/V | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:NSAM266SA CompactSPEECHTM Digital Speech Processor with Serial Flash Interface |
| NSAM266SAA/VLJ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Solid-State Recorder |
| NSAM266SC | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| NSAM266SCA/V | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Solid-State Recorder |
發布緊急采購，3分鐘左右您將得到回復。