- 您現在的位置：買賣IC網 > PDF目錄363664 > NS16C2752 (National Semiconductor Corporation) Dual UART with 16-byte/64-byte FIFOs and up to 5 Mbit/s Data Rate PDF資料下載
參數資料
| 型號： | NS16C2752 |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | Dual UART with 16-byte/64-byte FIFOs and up to 5 Mbit/s Data Rate |
| 中文描述： | 雙UART與16-byte/64-byte FIFO和高達5 Mbit / s的數據速率 |
| 文件頁數： | 7/43頁 |
| 文件大?。?/td> | 881K |
| 代理商： | NS16C2752 |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁
5.0 Pin Descriptions
(Continued)
Signal
Name
DSR1
DSR2
Type
I
PLCC
Pin #
41
29
TQFP
Pin #
39
25
Description
UART Data-set-ready:
When low, DSR indicates that the remote link partner is ready to establish the
communications link. The DSR signal is a MODEM status input and can be read for
the appropriate channel in MSR[5]. This bit reflects the complement of the DSR
signal. MSR[1] indicates whether the DSR input has changed state since the previous
read of the MODEM Status Register.
Note:
Whenever the DSR bit of the MSR changes state, an interrupt is generated if the MODEM Status
Interrupt is enabled.
UART Data-carrier-detect:
When low, DCD indicates that the data carrier has been detected by the remote link
partner. The DCD signal is a MODEM status input and can be read for the appropriate
channel in MSR[7]. This bit reflects the complement of the DCD signal. MSR[3]
indicates if the DCD input has changed state since the previous reading of the
MODEM Status Register. DCD has no effect on the receiver.
DCD1
DCD2
I
42
30
40
26
Note:
Whenever the DCD bit of the MSR changes state, an interrupt is generated if the MODEM Status
Interrupt is enabled.
UART Ring-detector:
When low, RI indicates that a telephone ringing is active. The RI signal is a MODEM
the complement of the RI signal. MSR[2] indicates whether the RI input signal has
changed state from low to high since the previous reading of the MSR.
RI1
RI2
I
43
31
41
27
Note:
Whenever the RI bit of the MSR changes from a high to a low state, an interrupt is generated if the
MODEM Status Interrupt is enabled.
UART Multi-function Pin:
MF can be programmed for any one of three signal functions OUT2, BAUDOUT or
RXRDY. Bits 2 and 1 of the Alternate Function Register select which output signal will
be present on this pin. OUT2 is the default signal and it is selected immediately after
master reset or power-up.
The OUT2 can be set active low by programming bit 3 (OUT2) of the MCR to a logic
1. A Master Reset operation sets this signal to its inactive (high) state. Loop Mode
holds this signal in its inactive state.
The BAUDOUT signal is the 16X clock output that drives the transmitter and receiver
logic of the associated serial channel. This signal is the result of the XIN clock divided
by the value in the Divisor Latch Registers. The BAUDOUT signal for each channel is
internally connected to provide the receiver clock (formerly RCLK on the PC16550D).
The RXRDY signal can be used to request a DMA transfer of data from the RCVR
FIFO. Details regarding the active and inactive states of this signal are described in
Section 6.5 FIFO CONTROL REGISTER (FCR)
and
Section 7.9 DMA OPERATION
.
MF1
MF2
O
35
19
32
14
N
www.national.com
7
相關PDF資料 |
PDF描述 |
|---|---|
| NS16C2752TVA | Dual UART with 16-byte/64-byte FIFOs and up to 5 Mbit/s Data Rate |
| NS32203D | DIRECT MEMORY ACCESS CONTROLLER |
| NS32203N | DIRECT MEMORY ACCESS CONTROLLER |
| NS32382-10 | MEMORY MANAGEMENT UNITS |
| NS32382-15 | MEMORY MANAGEMENT UNITS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NS16C2752TVA | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Dual UART with 16-byte/64-byte FIFOs and up to 5 Mbit/s Data Rate |
| NS16C2752TVA/NOPB | 功能描述:UART 接口集成電路 RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| NS16C2752TVAX/NOPB | 功能描述:UART 接口集成電路 Dual UART w/ 64-byte FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| NS16C2752TVS | 制造商:Texas Instruments 功能描述:UART 2-CH 64Byte FIFO 3.3V/5V 48-Pin TQFP |
| NS16C2752TVS/NOPB | 功能描述:UART 接口集成電路 RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。