- 您現在的位置：買賣IC網 > PDF目錄359235 > MT93L04 (Zarlink Semiconductor Inc.) 128-Channel Voice Echo Canceller PDF資料下載
參數資料
| 型號： | MT93L04 |
| 廠商： | Zarlink Semiconductor Inc. |
| 英文描述： | 128-Channel Voice Echo Canceller |
| 中文描述： | 128頻道語音回聲消除器 |
| 文件頁數： | 26/56頁 |
| 文件大小： | 903K |
| 代理商： | MT93L04 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁
MT93L04
Data Sheet
26
Zarlink Semiconductor Inc.
frequency range of 700 Hz to 3400 Hz, for at least 400 ms. Whenever a Tone Detector releases, an interrupt is
generated (i.e., IRQ pin low).
The selection between G.165 and G.164 tone disable is controlled by the PHDis bit in Control Register 2 on a per
channel basis. When the PHDis bit is set to 1, G.164 tone disable requirements are selected.
In response to a valid disable tone, the echo canceller must be switched from the Enable Adaptation state to the
Bypass state. This can be done in two ways, automatically or externally. In automatic mode, the Tone Detectors
internally control the switching between Enable Adaptation and Bypass states. The automatic mode is activated by
setting the AutoTD bit in Control Register 2 to high. In external mode, an external controller is needed to service the
interrupts and poll the TD bits in the Status Registers. Following the detection of a disable tone (TD bit high) on a
given channel, the external controller must switch the echo canceller from Enable Adaptation to Bypass state.
Instability Detector
In systems with very low echo channel return loss (ERL), there may be enough feedback in the loop to cause
stability problems in the adaptive filter. This instability can result in variable pitched ringing or oscillation. Should
this ringing occur, the Instability Detector will activate and suppress the oscillations.
The Instability Detector is activated by setting the RingClr bit in Control Register A3/B3 to "1".
Narrow Band Signal Detector (NBSD)
Single or dual frequency tones (i.e., DTMF tones) present in the receive input (Rin) of the echo canceller for a
prolonged period of time may cause the Adaptive Filter to diverge. The Narrow Band Signal Detector (NBSD) is
designed to prevent this by detecting single or dual tones of arbitrary frequency, phase, and amplitude. When
narrow band signals are detected, adaptation is halted but the echo canceller continues to cancel echo.
The NBSD can be disabled by setting the NBDis bit to “1” in Control Register 2.
Offset Null Filter
Adaptive filters in general do not operate properly when a DC offset is present at any inputs. To remove the DC
component, the MT93L00 incorporates Offset Null filters in both Rin and Sin inputs.
The offset null filters can be disabled by setting the HPFDis bit to “1” in Control Register 2.
ITU-T G.168 Compliance
The MT93L00 has been certified G.168 compliant in all 64 ms cancellation modes (i.e., Normal and Back-to-Back
configurations) by in-house testing with the DSPG ECT-1 echo canceller tester.
It should be noted that G.168 compliance is not claimed for the 128 ms Extended Delay mode, although
subjectively no difference can be noticed.
Device Configuration
The MT93L00 architecture contains 32 echo cancellers divided into 16 groups. Each group has two echo cancellers
which can be individually controlled (Echo Canceller A and B). They can be set in three distinct configurations:
Normal, Back-to-Back, and Extended Delay. See Figure 6.
Normal Configuration
In Normal configuration, the two echo cancellers (Echo Canceller A and B) are positioned in parallel, as shown in
Figure 6a, providing 64 milliseconds of echo cancellation in two channels simultaneously.
相關PDF資料 |
PDF描述 |
|---|---|
| MT9LD272G-6S | x72 Fast Page Mode DRAM Module |
| MT9LD272G-6XS | x72 EDO Page Mode DRAM Module |
| MT9LD272G-7S | x72 Fast Page Mode DRAM Module |
| MT9LD272G-7XS | x72 EDO Page Mode DRAM Module |
| MT9LDT272G-6 | x72 Fast Page Mode DRAM Module |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT93L04A | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:128-Channel Voice Echo Canceller |
| MT93L04AG | 制造商:Microsemi Corporation 功能描述:ECHO CANCELLER CHIP 128CH G.164/G.165/G.168/G.711 W/ TONE DE - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC VOICE ECHO CANCEL 365MCMBGA |
| MT93L04AG2 | 制造商:Microsemi Corporation 功能描述:ECHO CANCELLER CHIP 128CH G.164/G.165/G.168/G.711 W/ TONE DE - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC VOICE ECHO CANCEL 365MCMBGA 制造商:Microsemi Corporation 功能描述:IC VOICE ECHO CANCEL 365MCMBGA |
| MT93L16 | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:AEC with Noise Reduction & Codecs for Digital Hands-Free Communication |
| MT93L16AF | 制造商:Microsemi Corporation 功能描述:ECHO CANCELLER CHIP 2CH G.711 W/OUT TONE DETECTION 48TQFP - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。