參數資料
型號: MM908E630CVFC
廠商: FREESCALE SEMICONDUCTOR INC
元件分類: 微控制器/微處理器
英文描述: MICROCONTROLLER, QCC44
封裝: 9 X 9 MM, 1 MM HEIGHT, 0.65 MM PITCH, ROHS COMPLIANT, QFN-44
文件頁數: 47/48頁
文件大?。?/td> 2299K
代理商: MM908E630CVFC
Analog Integrated Circuit Device Data
8
Freescale Semiconductor
908E630
ELECTRICAL CHARACTERISTICS
STATIC ELECTRICAL CHARACTERISTICS
STATIC ELECTRICAL CHARACTERISTICS
Table 3. Static Electrical Characteristics
All characteristics are for the analog die only. Refer to the 68HC908EY16A datasheet for characteristics of the microcontroller
die. Characteristics noted under conditions 5.5 V
≤ VSUP ≤ 18 V, -40°C ≤ TJ ≤ 125°C, unless otherwise noted. Typical values
noted reflect the approximate parameter mean at TA = 25°C under nominal conditions, unless otherwise noted.
Characteristic
Symbol
Min
Typ
Max
Unit
SUPPLY VOLTAGE RANGE
Nominal Operating Voltage
VSUP
5.5
18
V
Functional Operating Voltage
VSUPOP
27
V
Load Dump
VSUPLD
40
V
SUPPLY CURRENT RANGE
Normal Mode(12)
VSUP = 13.5 V,
Analog die in Normal mode;
MCU Operating Using Internal Oscillator at 32 MHz (8.0 MHz Bus
Frequency), SPI, ESCI, ADC Enabled.
IRUN
20
33
mA
VSUP = 13.5 V,
Analog die in Stop mode with cyclic sense disabled;
MCU in Stop mode with LVI in STOP disabled, Oscillator disabled,
KeyBoard Walk-up disabled, LIN in recessive state.
ISTOP
58
90
A
VSUP = 13.5 V,
Analog die in Sleep mode with cyclic sense disabled;
LIN in recessive state.
ISLEEP
37
48
A
Cyclic Sense Supply Current Adder(15)
ICYCLIC
10
A
SUPPLY UNDER/OVER-VOLTAGE DETECTIONS
Power On Reset (BATFAIL)(16)
Threshold (measured on VS1)(15)
Hysteresis (measured on VS1)(15)
VBATFAIL
VBATFAIL_HYS
1.5
3.0
0.9
3.9
V
VSUP under-voltage detection (VSUV Flag) (Normal and Normal Request
Modes, Interrupt Generated)
Threshold (measured on VS1)
Hysteresis (measured on VS1)
VSUV
VSUV_HYS
5.55
6.0
0.2
6.6
V
VSUP over-voltage detection (VSOV Flag) (Normal and Normal Request
Modes, Interrupt Generated)
Threshold (measured on VS1)
Hysteresis (measured on VS1)
VSOV
VSOV_HYS
17.5
19.25
1.0
20.5
V
Notes
12.
Total current (IVS1 + IVS2) measured at GND pin excluding all loads, cyclic sense disabled.
13.
Total IDD current (including loads) below 100 A.
14.
Stop and Sleep mode current will increase if VSUP exceeds 13.5 V
15.
This parameter is guaranteed by process monitoring but not production tested.
16.
The Flag is set during power up sequence. To clear the flag, a SPI read must be performed.
相關PDF資料
PDF描述
MN101CP66DBF 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP84
MN101CF66DBF 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP84
MN101CF66DAL 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP80
MN101CP66DAL 8-BIT, OTPROM, 20 MHz, MICROCONTROLLER, PQFP80
MN103SA7D 32-BIT, MROM, MICROCONTROLLER, PQFP80
相關代理商/技術參數
參數描述
MM-90N 功能描述:ANT MAGN MNT VEHIC 3.5"DIA 10'NF RoHS:是 類別:RF/IF 和 RFID >> RF 天線 系列:* 標準包裝:1 系列:*
MM90R9F 制造商:Ohmite Mfg Co 功能描述:
MM912_634 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Integrated S12 Based Relay Driver with LIN
MM912_634_12 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Integrated S12 Based Relay Driver with LIN
MM912_637 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Xtrinsic Battery Sensor with LIN for 12 V Lead-acid