參數資料
型號: MC68HCP11A1CFN3
廠商: MOTOROLA INC
元件分類: 微控制器/微處理器
英文描述: HCMOS Single-Chip Microcontroller
中文描述: 8-BIT, EEPROM, 3 MHz, MICROCONTROLLER, PQCC52
封裝: PLASTIC, LCC-52
文件頁數: 36/158頁
文件大小: 776K
代理商: MC68HCP11A1CFN3
MOTOROLA
3-10
ON-CHIP MEMORY
MC68HC11A8
TECHNICAL DATA
3
of ROM and EEPROM in the memory map, as well as enabling the COP watchdog
system. A security feature to protect data in the EEPROM and RAM is also available
on mask programmed MC68HC11A8s.
Bits 7, 6, 5, and 4 — Not Implemented
These bits are always read as zero.
NOSEC — Security Mode Disable Bit
This bit is only implemented if it is specifically requested at the time mask ROM infor-
mation is submitted. When this bit is not implemented it always reads one.
When RAM and EEPROM security are required, the NOSEC bit can be programmed
to zero to enable the software anti-theft mechanism. When clear, the NOSEC bit pre-
vents the selection of expanded multiplexed operating modes. If the MCU is reset in
the special bootstrap operating mode while NOSEC is zero, EEPROM, RAM, and
CONFIG are erased before the loading process continues.
0 = Enable Security Mode
1 = Disable Security Mode
NOCOP — COP System Disable
0 = COP Watchdog System Enabled
1 = COP Watchdog System Disabled
ROMON — Enable On-Chip ROM
When this bit is clear, the 8K ROM is disabled, and that memory space becomes ex-
ternally accessed space. In the single-chip operating mode, the internal 8K ROM is en-
abled regardless of the state of the ROMON bit.
EEON — Enable On-Chip EEPROM
When this bit is clear, the 512-byte EEPROM is disabled, and that memory space be-
comes externally accessed space.
3.5.3.1 Programming and Erasure of the CONFIG Register
Since the CONFIG register is implemented with EEPROM cells, special provisions
must be made to erase and program this register. The normal EEPROM control bits in
the PPROG register are used for this purpose. Programming follows the same proce-
dure as programming a byte in the 512-byte EEPROM except the CONFIG register
address is used. Erase also follows the same procedure as that used for the EEPROM
except that only bulk erase can be used on the CONFIG register. When the CONFIG
register is erased, the 512-byte EEPROM array is also erased. Be sure to check the
Technical Summary for the particular MC68HC11 Family member you are using.
7
0
6
0
(see
3.5.3.2 Operation of the Configuration Mechanism
)
5
0
4
0
3
2
1
0
$
1
03F
RESET
NOSEC
NOCOP
ROMON
EEON
CONFIG
相關PDF資料
PDF描述
MC68HCP11A1CP2 HCMOS Single-Chip Microcontroller
MC68HCP11A1CP3 HCMOS Single-Chip Microcontroller
MC68HCP11A1MFN2 HCMOS Single-Chip Microcontroller
MC68HCP11A1MP2 HCMOS Single-Chip Microcontroller
MC68HCP11A1VFN2 HCMOS Single-Chip Microcontroller
相關代理商/技術參數
參數描述
MC68HCP11A1FN 制造商:MOTORALA 功能描述:
MC68HCP11E0CP2 制造商:Rochester Electronics LLC 功能描述:- Bulk
MC68HCP11E0FN 功能描述:MICROCONTROLLER MCU 8ADC 3MHC RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:HC11 標準包裝:250 系列:56F8xxx 核心處理器:56800E 芯體尺寸:16-位 速度:60MHz 連通性:CAN,SCI,SPI 外圍設備:POR,PWM,溫度傳感器,WDT 輸入/輸出數:21 程序存儲器容量:40KB(20K x 16) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:6K x 16 電壓 - 電源 (Vcc/Vdd):2.25 V ~ 3.6 V 數據轉換器:A/D 6x12b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:48-LQFP 包裝:托盤 配用:MC56F8323EVME-ND - BOARD EVALUATION MC56F8323
MC68HCP11E0FNE 功能描述:8位微控制器 -MCU 8B MCU 512RAM COP A/D RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
MC68HCP11E1CFNE2 功能描述:8位微控制器 -MCU 8B MCU 512 BYTES RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT