參數資料
型號: MC145572APB
廠商: Freescale Semiconductor
文件頁數: 19/52頁
文件大小: 0K
描述: IC ISDN INTERFACE TXCVER 44-LQFP
標準包裝: 160
類型: 收發器
規程: RS232
電源電壓: 5V
安裝類型: 表面貼裝
封裝/外殼: 44-LQFP
供應商設備封裝: 44-LQFP(10x10)
包裝: 托盤
27
MC145572EVK
Note that the M and the A bits used in the IDL interface of the MC145574 S/T-Interface Transceiver are
not used by the MC145572, and, therefore, are not driven by the MC145572.
NTFSR: (NT U-Interface Transceiver Pin FSR).
This pin is an input when the MC145572 is congured for slave mode and an output when congured for
master mode, as established by switch S4-1, MAS/SLV. In the master mode this output is phase locked
to the signal received at the NT1 U-Interface. This signal is associated with data output from the Dout pin
of the MC145572. This signal is also connected to the FSC/FSR pin of the MC145574 S/T-Transceiver.
NTFSX: (NT U-Interface Transceiver Pin FSX).
This pin is an input when the MC145572 is congured for slave mode and an output when congured for
master mode, as established by switch S2-1, MAS/SLV. In the master mode this output is phase locked
to the signal received at the NT1 U-Interface. This signal is associated with data input to the Din pin of the
MC145572.
STIRQ: Interrupt Request T (S/T-Interface Transceiver IRQ).
The STIRQ pin is an active low open drain output used to signal the MCU devices that an interrupt condition
exists in the MC145574 S/T-Interface Transceiver. On clearing the interrupt condition, the STIRQ pin is
returned to the high impedance state.
NTSFAX: Transmit Superframe Alignment.
This pin carries a signal that indicates the rst 2B+D frame in a U superframe to be transmitted onto the
U-Interface.This signal is not active when the NT side MC145572 is congured for full GCI mode operation.
NTSFAR: Receive Superframe Alignment.
This pin carries a signal that indicates the rst 2B+D frame in a U superframe to be received from the
U-Interface.This signal is not active when the NT side MC145572 is congured for full GCI mode operation.
NTFREF: Synchronized Clock Out, MCU Mode.
When the NT side MC145572 is congured for MCU mode operation, S4-4 in IDL2 position, this pin
provides the recovered timing clock. The frequency of the clock at this pin is selected by programming the
NT side MC145572 registers BR7(b4) and OR7(b4).
NTFREFO: Synchronized Clock Out, GCI Mode.
When the NT side MC145572 is congured for full GCI mode operation, S4-4 in GCI position, this pin
provides the recovered timing clock. The frequency of the clock is selected between 2.048 MHz and
512 kHz by the setting of S3-4, GCI2048/GCI512.
NTCLK or NTGTCLK: Gated IDL Clock Output.
This pin provides a gated clock output. The clock input of an external bit error rate tester should be
connected to this signal.
GND: Ground.
Negative Power Supply.
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
..
.
相關PDF資料
PDF描述
VE-J4N-MX-F4 CONVERTER MOD DC/DC 18.5V 75W
M83723/75W10068 CONN PLUG 6POS STRAIGHT W/SCKT
VE-J4K-MX-F3 CONVERTER MOD DC/DC 40V 75W
SN74CB3T3384DBQR IC FET BUS SWT 3.3V 10BIT 24QSOP
M83723/75W10067 CONN PLUG 6POS STRAIGHT W/SCKT
相關代理商/技術參數
參數描述
MC145572APBR2 制造商:Rochester Electronics LLC 功能描述:- Bulk
MC145572FN 制造商:Rochester Electronics LLC 功能描述:- Bulk
MC145572FNR2 制造商:Rochester Electronics LLC 功能描述:- Bulk
MC145572PB 制造商:Rochester Electronics LLC 功能描述:- Bulk
MC145572PBR2 制造商:Rochester Electronics LLC 功能描述:- Bulk